Serving Park Ridge & nearby Des Plaines, Glenview

Kitchen Island & Peninsula Installation in Park Ridge, IL

We add, enlarge or replace kitchen islands and peninsulas in Park Ridge, with seating, power and plumbing planned around real clearances.

  • Local crews working in Park Ridge ZIP 60068
  • Design, permits and every trade on one schedule
  • A written, itemized estimate before any work

Prefer a callback?

Leave your number and a Park Ridge island installer will call you.

Island and peninsula problems we solve in Park Ridge

Whether you are adding a first island, replacing a small one or turning a wall into a peninsula with stools, the job is part carpentry, part trades. Our Park Ridge crew handles the cabinets, the floor anchoring, wiring, any plumbing and the countertop in one schedule.

Dated peninsula with a half wall

Upper cabinets hung over a 1950s peninsula block the room. We take them down, reroute any wiring and rebuild the peninsula with an overhang.

Island in the dark

Pendant lights over the island light the prep area and define the space. We wire them while the ceiling is open.

Nowhere to prep

If two cutting boards can't fit side by side anywhere, the kitchen needs a central work surface. An island or peninsula is the usual answer.

Want the cooktop in the island

If you want to cook facing the room, we plan the island around the cooktop, the ventilation path and safe space on both sides.

Want a sink in the island

Facing the family while washing up is a common wish. We plan the drain, vent and supply lines and add a dishwasher next to the island sink.

Island too small to be useful

A narrow builder island or a rolling cart holds a fruit bowl and little else. We replace it with a larger island sized to the room's clearances.

Cracked overhang on a stone top

If your bar top has a crack near the edge, it likely lacked support. New tops get hidden steel or visible corbels.

No outlets at the island

An island without power can't hold a blender or charge a phone. We add GFCI-protected outlets on the side or a pop-up in the top.

What's included

  • Layout and clearance checkTaped outlines on the floor so you can walk around the island before anything is ordered.
  • Plumbing and ventingDrain, vent and supply lines for an island sink or dishwasher, run by licensed trades.
  • Island cabinets set and anchoredBase cabinets assembled, leveled and screwed to the floor blocking so the island can't move.
  • Panels and seating sideDecorative panels on the exposed sides and a clean seating face for the stools.
  • Overhang supportSteel brackets, support plates or corbels for seating overhangs on stone tops.
  • CountertopTop templated on the installed base and set with sink and cooktop cut-outs.
  • Outlets, pendants and hookupsOutlets trimmed out, pendants hung and the sink and dishwasher connected.

Materials and options

Counter or bar height seatingCounter height keeps one continuous surface; a raised bar hides prep clutter from the room.
Pop-up and side outletsWe place outlets where code allows and where they won't be in a spill zone.
Waterfall endsA slab that wraps over the ends to the floor and protects the cabinet sides.
Island cabinetsIsland cabinets can match the perimeter or stand out in another color or wood.
Legs, corbels and bracketsFurniture legs or corbels support overhangs and give the island a built-in look.

What the work looks like in Park Ridge homes

Kitchen Island & Peninsula Installation in a postwar ranch / cape cod / bi-level — beforeBefore
Kitchen Island & Peninsula Installation in a postwar ranch / cape cod / bi-level — in progressIn progress
Kitchen Island & Peninsula Installation in a postwar ranch / cape cod / bi-level — afterAfter

Kitchen Island & Peninsula Installation in a 1950s ranch, Park Ridge

A 1950s ranch in Park Ridge, a typical kitchen for Park Ridge. The kitchen as it was: 1970s dark pecan-stained cabinets and light beige laminate. The reason for the call: a kitchen with no room to prep or gather. Finished kitchen: a new island in dusty blue with a charcoal concrete-look quartz top and seating. On site this meant overhang support, countertop, plus outlets, pendants and hookups.

Kitchen Island & Peninsula Installation project in Glenview, beforeBefore
Kitchen Island & Peninsula Installation project in Glenview, afterAfter

Kitchen Island & Peninsula Installation in a 1950s ranch, Glenview

A 1950s ranch near The Park, a typical kitchen for Glenview. Before: dark walnut-stained flush-panel cabinets with brass pulls and speckled laminate. The reason for the call: too little counter space and nowhere to sit. After: a new island in dusty blue with a creamy quartzite-look quartz top and seating. On site this meant plumbing and venting, island cabinets set and anchored, plus panels and seating side.

Kitchen Island & Peninsula Installation in Glenview →
Pantry Design & Installation project near Park Ridge, beforeBefore
Pantry Design & Installation project near Park Ridge, afterAfter

Pantry Design & Installation in a 1960s ranch, Park Ridge

The closet next to the kitchen rebuilt as a pantry with solid wood shelves, pull-out baskets on the bottom and a light.

Pantry Design & Installation in Park Ridge →
Built-In Breakfast Nook & Banquette project near Park Ridge, beforeBefore
Built-In Breakfast Nook & Banquette project near Park Ridge, afterAfter

Park Ridge kitchen, 1950s ranch: built-in breakfast nook & banquette

A built-in banquette bench with storage drawers and cushions under the window, with a round pedestal table.

Built-In Breakfast Nook & Banquette in Park Ridge →
Kitchen Remodeling project near Park Ridge, beforeBefore
Kitchen Remodeling project near Park Ridge, afterAfter

Park Ridge kitchen, postwar bi-level: kitchen remodeling

Cabinets in forest green with matte black pulls, black honed granite counters, a green zellige-look tile backsplash, warm oak luxury vinyl plank flooring and a flush drum fixture and under-cabinet lights.

Kitchen Remodeling in Park Ridge →

From first visit to final walk-through

  1. Measure and mock-upWe measure the kitchen and tape the island outline on the floor so you can test the walkways.
  2. Plan and written estimateIsland size, cabinets, top, seating and trades in a drawn plan with an itemized quote.
  3. Rough-in and permitsPermits filed when wiring or plumbing is added; rough-ins done and inspected before the base goes in.
  4. Build and countertopBase set and anchored, panels installed, top templated and installed.
  5. Hookups and walk-throughOutlets, pendants and plumbing connected, and a final walk-through with you.

Kitchen Island & Peninsula Installation questions from Park Ridge homeowners

Will my floor hold a stone island?
Most residential floors carry a typical stone island without trouble. For very large slabs we check the framing from below and add blocking if needed.
Island or peninsula — which is better?
If the room can spare aisles all around, an island. If not, a peninsula gives you seating and counter space without crowding.
Does a kitchen island need an electrical outlet?
Most building codes require one, and it's practical regardless. We place it where it's safe and easy to reach.
Can you put a cooktop or range in the island?
We can, as long as there's a way to vent it and safe counter space on each side. We plan the hood and the utility lines together.
Should the island be fixed or freestanding?
Most islands we install are fixed so they can carry stone and power safely; freestanding units are lighter and simpler.
Do I need a Park Ridge-registered contractor for island project?
Building contractors must register with the City each calendar year ($50 per firm). We take care of that before work starts.
Do I need a permit for island project in Park Ridge?
It depends on the scope. Park Ridge's rule in short: Park Ridge publishes permit guidelines by project type; contact the Permit Technicians to confirm whether a kitchen project needs a permit. We handle the permit when one is needed.
Do you work in my part of Park Ridge?
Yes. Our crews work across Park Ridge — ZIP 60068 — and nearby Des Plaines, Glenview, Skokie.

Working in Park Ridge

  • A lot of Park Ridge kitchens date from the 1950s. We know these layouts well and what is worth keeping.
  • Most Park Ridge homes are single-family. We protect floors and driveways and leave the site clean every day.
  • We know how Park Ridge building department handles kitchen permits and pull them for you.

ZIP 60068

Kitchen Island & Peninsula Installation nearby

Planning a kitchen project in Park Ridge?

Call us — we'll check your ZIP, answer your questions and book an in-home estimate.

Call now (708) 400-7049
Call (708) 400-7049Callback