Serving Skokie & nearby Evanston, Park Ridge

Kitchen Island & Peninsula Installation in Skokie, IL

We add, enlarge or replace kitchen islands and peninsulas in Skokie, with seating, power and plumbing planned around real clearances.

  • Kitchen remodels across Skokie ZIP 60076, 60077, 60203
  • One project manager from drawings to final walk-through
  • Permits and inspections handled for you

Prefer a callback?

Leave your number and a Skokie island installer will call you.

Island and peninsula problems we solve in Skokie

Whether you are adding a first island, replacing a small one or turning a wall into a peninsula with stools, the job is part carpentry, part trades. Our Skokie crew handles the cabinets, the floor anchoring, wiring, any plumbing and the countertop in one schedule.

Dated peninsula with a half wall

Upper cabinets hung over a 1950s peninsula block the room. We take them down, reroute any wiring and rebuild the peninsula with an overhang.

Clutter with no storage

An island adds drawers for pots, a trash pull-out and shelves for cookbooks, which clears the perimeter counters.

No outlets at the island

Running an extension cord to the island for a mixer is a hazard. Code usually requires an outlet on an island counter, and we wire it from below.

Want a sink in the island

An island sink is very doable but involves plumbing under the floor and proper venting. We check access from the basement or crawl space first.

Island too small to be useful

Small islands often leave unused floor around them. A longer or deeper island uses that space for storage and seats.

No place to sit in the kitchen

A counter with seating turns the kitchen into the spot where people gather. We size the overhang and the stool spacing so it's comfortable.

Island that wobbles or shifts

A freestanding island that slides when you lean on it isn't safe for stone. We fasten the base to the floor with cleats so it stays put.

Island in the dark

One ceiling light over the island leaves shadows on the work surface. We add pendants on their own switch and dimmer.

What the project covers

  • Layout and clearance checkWe measure the room and mark the island footprint to confirm walkways and appliance door swings.
  • Electrical rough-inA circuit run to the island for outlets, plus wiring for pendants overhead.
  • Plumbing and ventingDrain, vent and supply lines for an island sink or dishwasher, run by licensed trades.
  • Island cabinets set and anchoredWe set the island boxes level, join them and fasten them down.
  • Panels and seating sideFinished end and back panels, with knee space and furniture details where you want them.
  • CountertopTop templated on the installed base and set with sink and cooktop cut-outs.
  • Outlets, pendants and hookupsFinal electrical and plumbing connections and a test of every outlet and light.

Finishes and options

Quartz and granite topsQuartz for low upkeep, granite for heat resistance; both need support at seating overhangs.
Butcher blockWood tops add warmth and are pleasant for prep; they need oiling or sealing from time to time.
Waterfall endsThe countertop continues down the sides of the island to the floor for a clean modern look.
Island cabinetsIsland cabinets can match the perimeter or stand out in another color or wood.
Counter or bar height seatingCounter height keeps one continuous surface; a raised bar hides prep clutter from the room.

Before and after: kitchens near Skokie

Kitchen Island & Peninsula Installation in a postwar ranch / cape cod / bi-level — beforeBefore
Kitchen Island & Peninsula Installation in a postwar ranch / cape cod / bi-level — in progressIn progress
Kitchen Island & Peninsula Installation in a postwar ranch / cape cod / bi-level — afterAfter

Before and after: a postwar Cape Cod in Skokie

A postwar Cape Cod in Skokie, a typical kitchen for Skokie. The kitchen as it was: dark walnut-stained flush-panel cabinets with brass pulls and speckled laminate. The main complaint was too little counter space and nowhere to sit. The result: a new island in dusty blue with a creamy quartzite-look quartz top and seating. The job covered island cabinets set and anchored, panels and seating side, plus countertop.

Kitchen Island & Peninsula Installation project in Evanston, beforeBefore
Kitchen Island & Peninsula Installation project in Evanston, afterAfter

Before and after: a prewar foursquare in Evanston

The site: a prewar foursquare in Evanston. What we started with: 1960s birch cabinets painted cream over the years, chipped door edges, old brass hardware and worn beige laminate with a metal edge strip. The main complaint was too little counter space and nowhere to sit. Finished kitchen: a new island in navy with a dark soapstone-look quartz top and seating. The job covered electrical rough-in, plumbing and venting, plus countertop.

Kitchen Island & Peninsula Installation in Evanston →
Kitchen Island & Peninsula Installation project in Park Ridge, beforeBefore
Kitchen Island & Peninsula Installation project in Park Ridge, afterAfter

Park Ridge kitchen, postwar Cape Cod: kitchen island & peninsula installation

A postwar Cape Cod in Park Ridge, a typical kitchen for Park Ridge. What we started with: 1970s dark pecan-stained cabinets and light beige laminate. The reason for the call: too little counter space and nowhere to sit. After: a new island in dusty blue with a charcoal concrete-look quartz top and seating. On site this meant layout and clearance check, electrical rough-in, plus countertop.

Kitchen Island & Peninsula Installation in Park Ridge →
Pantry Design & Installation project near Skokie, beforeBefore
Pantry Design & Installation project near Skokie, afterAfter

Before and after: a postwar bi-level in Skokie

What changed: the closet next to the kitchen rebuilt as a pantry with solid wood shelves, pull-out baskets on the bottom and a light.

Pantry Design & Installation in Skokie →
Built-In Breakfast Nook & Banquette project near Skokie, beforeBefore
Built-In Breakfast Nook & Banquette project near Skokie, afterAfter

Skokie kitchen, 1960s ranch: built-in breakfast nook & banquette

Finished: a built-in banquette bench with storage drawers and cushions under the window, with a round pedestal table.

Built-In Breakfast Nook & Banquette in Skokie →

From first visit to final walk-through

  1. Measure and mock-upA visit to measure, check clearances and see where power and water can reach.
  2. Plan and written estimateIsland size, cabinets, top, seating and trades in a drawn plan with an itemized quote.
  3. Rough-in and permitsPermits filed when wiring or plumbing is added; rough-ins done and inspected before the base goes in.
  4. Build and countertopCabinets fastened down, sides finished, then the countertop is measured and set.
  5. Hookups and walk-throughFinal connections, cleanup and a look at the finished island together.

Kitchen Island & Peninsula Installation questions from Skokie homeowners

Can you add a sink to a kitchen island?
Usually. We check how the drain can reach the island and how it will be vented before designing around a sink.
Will my floor hold a stone island?
Usually yes. We look at the joists when the island is large or sits mid-span and reinforce if anything seems marginal.
Can you put a cooktop or range in the island?
Yes, with proper ventilation: a ceiling-mounted island hood or a downdraft system, plus gas or a dedicated circuit run to the island.
Does a kitchen island need an electrical outlet?
Most building codes require one, and it's practical regardless. We place it where it's safe and easy to reach.
How much space do I need for a kitchen island?
Clearance comes first: about 42 inches for one cook, about 48 for two. Whatever remains after those aisles is the island's footprint.
Do I need a Skokie-registered contractor for island project?
Many contractors must be registered and insured with the Village each year; permits are not issued unless all listed contractors are registered and insured. We take care of that before work starts.
What is the Skokie building department phone number?
Permits go through Community Development Department - Building & Inspection Services Division (www.skokiepermits.com), phone (847) 933-8223. When your scope needs one, we prepare the application and schedule the inspections.
Do I need a permit for island project in Skokie?
It depends on the scope. Skokie's rule in short: Electrical work and plumbing or electrical system changes need a permit. We handle the permit when one is needed with Community Development Department - Building & Inspection Services Division.
Do you work in my part of Skokie?
Yes. Our crews work across Skokie — ZIP 60076, 60077, 60203 — and nearby Evanston, Park Ridge, Glenview.

Working in Skokie

  • A lot of Skokie kitchens date from the 1950s. We know these layouts well and what is worth keeping.
  • Most Skokie homes are single-family. We protect floors and driveways and leave the site clean every day.
  • We know how Community Development Department - Building & Inspection Services Division handles kitchen permits and pull them for you.

ZIP 60076ZIP 60077ZIP 60203

Kitchen Island & Peninsula Installation nearby

Planning a kitchen project in Skokie?

Call us — we'll check your ZIP, answer your questions and book an in-home estimate.

Call now (708) 400-7049
Call (708) 400-7049Callback