Light not working but the fan is
A dark light with a working fan is usually a bulb, a socket or the light switch. We swap the bulb type the hood calls for or replace the socket.
Serving St. Charles & nearby Geneva, West Chicago
Range Hood Repair in St. Charles, IL
Fan dead, lights out or a hood that rattles and roars? We repair range hoods in St. Charles and tell you plainly when replacing makes more sense.
- Technicians covering St. Charles ZIP 60174, 60175
- Diagnosis first, then a written price for the repair
- Honest advice when replacing makes more sense
Range hood problems we fix in St. Charles
A hood that hums but won't spin, a light that stays dark, a fan stuck on one speed or a rattle that gets louder every week: these are everyday repairs. Our St. Charles technicians diagnose the hood in place and fix it without tearing out cabinets.
Backdraft damper stuck open or shut
If you feel a cold draft from the hood in winter, the backdraft damper usually isn't closing. Grease or a bent flap is the common cause.
Fan stuck on one speed
Losing speeds points to the speed control rather than the motor in most cases. We test the switch and the board.
Buttons or touch panel not responding
Touch controls fail from heat, grease and moisture getting into the panel. We test the keypad and the board and replace the faulty one.
Fan runs but barely pulls air
If the fan spins but smoke still rolls past, we check the filters, the wheel, the duct and the exterior cap before blaming the motor.
Loud rattling or grinding
Rattles usually come from a loose blower wheel, a loose filter or a damper flap. Grinding usually means the motor bearings are wearing out.
Dripping grease or water from the hood
We trace drips back to filters, the duct or the roof jack, then clean, seal or replace whatever is letting it through.
Fan and light both dead
If nothing on the hood responds, we start with the power supply: the breaker, the wiring connection in the hood and the main control board.
What the repair visit covers
- DiagnosisA step-by-step check of the hood's electrical and mechanical parts.
- Fan motor replacementWorn or seized motors replaced with a motor matched to the hood.
- Blower wheel serviceGrease-packed or loose blower wheels cleaned, tightened or replaced.
- Switches and control boardsFaulty controls swapped so every speed and setting responds again.
- Damper and duct checkWe confirm air can leave the house and the damper closes when the fan stops.
- Noise and vibration fixesLoose mounts, filters, wheels and duct connections tightened to stop rattles.
- Final testWe run the hood and check airflow before we leave.
Repair options
Island hoods and insertsCeiling-hung and built-in hoods, often with internal or inline blowers.
Under-cabinet and chimney hoodsThe most common hoods we repair, with fans and controls reachable from below.
FiltersMetal filters catch grease; charcoal filters treat odor in ductless setups.
LightsOlder halogen bulbs or newer LED strips, depending on the hood.
Fan motors and blower wheelsThe parts that move air, and the ones most often worn out.
Before and after: kitchens near St. Charles
Problem
Fixed
DetailBefore and after: a 1980s two-story in St. Charles
This one is a 1980s two-story in St. Charles. Before: black appliances and two hanging glass pendants. The main complaint was a range hood with dead lights and a weak fan. After: the same hood with a new fan motor and working LED lights. Work included switches and control boards, noise and vibration fixes, plus final test.
Before
AfterBefore and after: a 1990s two-story colonial in Geneva
The site: a 1990s two-story colonial in Geneva. What we started with: almond appliances and a fluorescent box light in the ceiling. What bothered the owners most: an old hood whose fan finally quit. Finished kitchen: the same hood with a new fan motor and working LED lights. On site this meant diagnosis, damper and duct check, plus noise and vibration fixes.
Range Hood Repair in Geneva →
Before
AfterBatavia kitchen, 1980s two-story: range hood repair
The site: a 1980s two-story in Batavia. What we started with: white appliances and a brass chandelier over the nook. The main complaint was a range hood with dead lights and a weak fan. Finished kitchen: the same hood with a new fan motor and working LED lights. On site this meant switches and control boards, damper and duct check, plus final test.
Range Hood Repair in Batavia →
Before
AfterA St. Charles 1990s two-story colonial: before and after
What changed: the same hood with clean, shining filters.
Residential Kitchen Hood Cleaning in St. Charles →
Before
AfterSt. Charles kitchen, 1990s two-story colonial: kitchen remodeling
Finished: cabinets in deep olive with unlacquered brass knobs and cup pulls, charcoal concrete-look quartz counters, a white 3x12 tile in a stacked pattern backsplash, gray wood-look porcelain plank flooring and black cage pendants and slim recessed lights.
Kitchen Remodeling in St. Charles →From diagnosis to fixed
- Describe the problemA photo of the label behind the filter and a short description help us bring the likely parts.
- Diagnosis on siteA technician checks the power, controls, motor and damper.
- Repair or replaceWe explain what failed and whether the fix is worth it on your hood.
- Fix and testThe part is replaced and the hood tested on every speed and light.
Range Hood Repair questions from St. Charles homeowners
How much does range hood repair cost?
The part, its availability and the labor to reach it drive the price. We put it in writing before we do the work.
Why does my range hood fan not work but the light does?
It means the fan's own switch or motor has failed while the light circuit is fine.
Can a range hood be repaired?
Usually, yes. Motors, blower wheels, switches, control boards, lights and dampers are all replaceable parts on most hoods.
What bulb does my range hood need?
It depends on the hood. The bulb type and wattage are listed in the manual or near the socket; many newer hoods use LED modules instead of bulbs.
Do you repair all range hood brands?
We work on most residential hood brands, as long as parts are available.
Do I need a permit for range hood repair in St. Charles?
It depends on the scope. St. Charles's rule in short: Permits required for construction, alteration, repair or demolition of any structure; major residential projects including remodels require 5 sets of drawings. We handle the permit when one is needed with Building Division, Community Development, 2 E. Main St..
Do you work in my part of St. Charles?
Yes. Our crews work across St. Charles — ZIP 60174, 60175 — and nearby Geneva, West Chicago, Batavia.
Working in St. Charles
- A lot of St. Charles kitchens date from the 2000s. We know these layouts well and what is worth keeping.
- Most St. Charles homes are single-family. We protect floors and driveways and leave the site clean every day.
- Live in a historic district? Interior kitchen work is usually not reviewed. We check before anything touches the exterior.
ZIP 60174ZIP 60175
Range Hood Repair nearby
Other kitchen services in St. Charles
Range Hood InstallationUnder-cabinet, chimney, island and insert hoods, ducted to the outside.
Residential Kitchen Hood CleaningDegreased filters, fan, hood interior and the duct you can reach.
Kitchen RemodelingFull kitchen remodels, from layout to last cabinet pull.
Kitchen Cabinet PaintingFactory-smooth painted cabinets without replacing them.
Cabinet RefacingNew doors and fronts on your existing cabinet boxes.