Backdraft damper stuck open or shut
Dampers at the hood or the wall cap get gummed up with grease. We clean or replace them so they open with the fan and close after.
Serving Batavia & nearby Geneva, St. Charles
Range Hood Repair in Batavia, IL
Fan dead, lights out or a hood that rattles and roars? We repair range hoods in Batavia and tell you plainly when replacing makes more sense.
- Technicians covering Batavia ZIP 60510, 60539
- Diagnosis first, then a written price for the repair
- Honest advice when replacing makes more sense
Range hood problems we fix in Batavia
A hood that hums but won't spin, a light that stays dark, a fan stuck on one speed or a rattle that gets louder every week: these are everyday repairs. Our Batavia technicians diagnose the hood in place and fix it without tearing out cabinets.
Loud rattling or grinding
A new rattle is often something simple: a filter not latched, a loose screw, a wheel slipping on its shaft. A grinding noise is more often the motor.
Fan won't turn off
When pressing off does nothing, the switch contacts or the control board are typically to blame. We check which one is stuck.
Fan stuck on one speed
Losing speeds points to the speed control rather than the motor in most cases. We test the switch and the board.
Dripping grease or water from the hood
We trace drips back to filters, the duct or the roof jack, then clean, seal or replace whatever is letting it through.
Light not working but the fan is
Hood lights fail at the bulb more often than anywhere else, but heat and grease also wear out sockets and switches. We find which it is.
Burning smell when the fan runs
If the hood smells hot, stop using it. We check the motor, the wiring connections and how much grease has built up around them.
Fan and light both dead
A hood with no fan and no lights may have lost power or a control board. We trace the supply before replacing any parts.
What we check and fix
- DiagnosisWe test power, switches, controls, motor and lights to find the failed part.
- Fan motor replacementWorn or seized motors replaced with a motor matched to the hood.
- Switches and control boardsRocker switches, speed controls, keypads and boards replaced as needed.
- Lights and socketsWorking lights restored with the correct bulb type or LED part.
- Filter replacementNew grease or charcoal filters fitted when the old ones are worn out.
- Noise and vibration fixesLoose mounts, filters, wheels and duct connections tightened to stop rattles.
- Final testWe run the hood and check airflow before we leave.
Common fixes and parts
Switches, keypads and boardsMechanical rocker or slide switches on simpler hoods; touch keypads and control boards on newer ones.
Fan motors and blower wheelsShaded-pole and capacitor motors, squirrel-cage and centrifugal wheels.
Under-cabinet and chimney hoodsWall and under-cabinet hoods serviced in place without removing cabinets.
FiltersMetal filters catch grease; charcoal filters treat odor in ductless setups.
Island hoods and insertsInserts inside custom covers, serviced through the filter opening.
Range Hood Repair before and after — Batavia homes
Problem
Fixed
DetailBefore and after: a two-story colonial from the 1990s in Batavia
This one is a two-story colonial from the 1990s in Batavia. What we started with: white appliances and a brass chandelier over the nook. What bothered the owners most: a loud, rattling range hood. The result: the same hood with a new fan motor and working LED lights. On site this meant lights and sockets, noise and vibration fixes, plus final test.
Before
AfterRange Hood Repair in a two-story colonial from the 1990s, Geneva
A two-story colonial from the 1990s near Mill Creek, a typical kitchen for Geneva. Before: almond appliances and a fluorescent box light in the ceiling. What bothered the owners most: an old hood whose fan finally quit. Finished kitchen: the same hood with a new fan motor and working LED lights. Work included diagnosis, switches and control boards, plus lights and sockets.
Range Hood Repair in Geneva →
Before
AfterSt. Charles kitchen, 1980s two-story: range hood repair
A 1980s two-story in St. Charles, a typical kitchen for St. Charles. What we started with: black appliances and two hanging glass pendants. The reason for the call: a hood fan that stopped working. Finished kitchen: the same hood with a new fan motor and working LED lights. The job covered diagnosis, switches and control boards, plus noise and vibration fixes.
Range Hood Repair in St. Charles →
Before
AfterBatavia kitchen, two-story colonial from the 1990s: residential kitchen hood cleaning
The same hood with clean, shining filters.
Residential Kitchen Hood Cleaning in Batavia →
Before
AfterBefore and after: a 1990s two-story colonial in Batavia
What changed: cabinets in pale sage with unlacquered brass knobs and cup pulls, charcoal concrete-look quartz counters, a terracotta-look square tile backsplash, light oak hardwood flooring and black cage pendants and slim recessed lights.
Kitchen Remodeling in Batavia →How the repair goes
- Describe the problemA photo of the label behind the filter and a short description help us bring the likely parts.
- Diagnosis on siteWe test the hood in place and find the failed part.
- Repair or replaceYou get a written estimate for the repair, or a straight recommendation to replace.
- Fix and testThe part is replaced and the hood tested on every speed and light.
Range Hood Repair questions from Batavia homeowners
Why does my range hood have weak suction?
Weak airflow is usually a blockage, not a weak motor. We find where the air is being held up.
Can a range hood be repaired?
Yes, most hoods can be fixed. We check part availability before recommending the repair.
Do you repair all range hood brands?
We work on most residential hood brands, as long as parts are available.
Why won't my range hood fan turn off?
Check whether the cooktop is still hot; heat sensors can keep the fan on. If not, the control is faulty.
Is a noisy range hood worth repairing?
Often. Many noises come from a loose wheel, filter or damper, which is a small fix. Grinding motor bearings mean a new motor, which is still usually less than a new hood.
Do I need a permit for range hood repair in Batavia?
It depends on the scope. Batavia's rule in short: Building permits are required for all construction; a Residential Alteration handout is available. We handle the permit when one is needed with City of Batavia Community & Economic Development - Building Division.
Do you work in my part of Batavia?
Yes. Our crews work across Batavia — ZIP 60510, 60539 — and nearby Geneva, St. Charles, West Chicago.
Working in Batavia
- A lot of Batavia kitchens date from the 1990s. We know these layouts well and what is worth keeping.
- Most Batavia homes are single-family. We protect floors and driveways and leave the site clean every day.
- Live in the Downtown Historic District? Interior kitchen work is usually not reviewed. We check before anything touches the exterior.
ZIP 60510ZIP 60539
Range Hood Repair nearby
Other kitchen services in Batavia
Range Hood InstallationUnder-cabinet, chimney, island and insert hoods, ducted to the outside.
Residential Kitchen Hood CleaningDegreased filters, fan, hood interior and the duct you can reach.
Kitchen RemodelingFull kitchen remodels, from layout to last cabinet pull.
Kitchen Cabinet PaintingFactory-smooth painted cabinets without replacing them.
Cabinet RefacingNew doors and fronts on your existing cabinet boxes.