Scale on the aerator from lake water
Treated Lake Michigan water still leaves some mineral scale in aerators and spray heads over time. Cleaning them restores the spray pattern.
Serving Orland Park & nearby Tinley Park, Woodridge
Kitchen Faucet Installation in Orland Park, IL
Pull-down, touchless and two-handle kitchen faucets installed leak-free by licensed plumbers in Orland Park.
- Serving Orland Park ZIP 60462, 60467
- Installed level, sealed and tested before we leave
- Clear price for the install before the visit
Kitchen faucet problems we fix in Orland Park
Whether you picked a pull-down, a touchless or a bridge faucet, we fit it to your sink or counter in Orland Park, cover or reuse the extra holes, and connect it with new supply lines.
Wanting a touchless faucet
A touchless kitchen faucet is a standard install with one extra piece: the control box and its power supply. We fit both.
Leaking from the handle
A handle that weeps while you run water has a failed seal under it. We open it up and tell you whether a part solves it.
Leak under the sink at the faucet lines
If the faucet looks fine on top but the cabinet is wet, check the lines under it. Worn supply hoses and spray hoses are common culprits.
Shut-off valves that won't turn
Faucet swaps often stop at the valves: old multi-turn stops seize or leak when turned. We replace them with quarter-turn valves.
Old two-handle faucet with a side sprayer
Separate hot and cold handles and a side sprayer that leaks are a common reason to upgrade. A single-handle pull-down does both jobs in one.
Drip from the spout that won't stop
A steady drip with the handle off means the cartridge or valve seat is worn. We swap the cartridge when it's available, or replace the faucet.
Spout too short or too low
A low spout makes it hard to fill stockpots and leaves water splashing at the back. A high-arc or pull-down faucet gives more room.
Included with the install
- Check the sink and suppliesA check of the sink holes, shut-offs and clearances so the faucet fits.
- Shut off and removeWater off, supply lines disconnected and the old faucet unbolted.
- Replace valves when neededSeized or leaking stops replaced with quarter-turn valves.
- Mount the faucetFaucet set with its gasket or deck plate and tightened from below.
- Pull-down hose and weightSpray hose routed clear of the drain and disposal, weight set so it retracts.
- Power for touchless modelsSensor faucet wiring and power placed where it can be serviced.
- Flush and testWe run hot and cold, test the sprayer and look for drips below.
What to pick before the install
Pull-out faucetsA shorter spout with a head that pulls straight out toward you.
FinishesStainless, chrome, matte black and brass finishes, each with its own care.
Deck platesTrim that lets a one-hole faucet sit cleanly on a three-hole sink.
Bridge and two-handle faucetsSeparate hot and cold handles on a bridge or widespread base for traditional kitchens.
Pull-down faucetsHigh spout with a docking spray head for rinsing and filling pots.
Kitchen Faucet Installation before and after — Orland Park homes
Before
Installed
DetailOrland Park kitchen, two-story colonial from the 1990s: kitchen faucet installation
This one is a two-story colonial from the 1990s in Orland Park. Before: solid-surface integrated sink. The reason for the call: an old faucet that dripped and was crusted with scale. The result: a new single-handle pull-down faucet with a clean caulk line. On site this meant mount the faucet, pull-down hose and weight, plus flush and test.
Before
AfterA Woodridge townhouse from the 1990s: before and after
The site: a townhouse from the 1990s near The Ridge. What we started with: stainless double sink. The reason for the call: a faucet too low to fill a stockpot. After: a new single-handle pull-down faucet with a clean caulk line. On site this meant shut off and remove, replace valves when needed, plus flush and test.
Kitchen Faucet Installation in Woodridge →
Before
AfterBefore and after: a 1990s two-story colonial in Bolingbrook
The site: a 1990s two-story colonial near Colonial Village. Before: white double sink. The reason for the call: a faucet too low to fill a stockpot. Finished kitchen: a new single-handle pull-down faucet with a clean caulk line. On site this meant check the sink and supplies, mount the faucet, plus power for touchless models.
Kitchen Faucet Installation in Bolingbrook →
Before
AfterKitchen Plumbing Relocation in a two-story colonial from the 1990s, Orland Park
What changed: a new island with a prep sink, the drain, vent and water lines relocated from the old wall.
Kitchen Plumbing Relocation in Orland Park →
Before
AfterOrland Park kitchen, 1980s two-story: kitchen remodeling
What changed: cabinets in white uppers and deep green lowers with polished nickel pulls, dark soapstone-look quartz counters, a white herringbone tile backsplash, warm oak luxury vinyl plank flooring and a flush drum fixture and under-cabinet lights.
Kitchen Remodeling in Orland Park →Install day
- Pick a faucetSend the model you like and a photo of your sink.
- Check the setupWe confirm the hole count, valves and clearances.
- Written estimateYou get the price in writing, including any valve replacement.
- Install and testThe faucet goes in, a licensed plumber connects it and we test every joint.
Kitchen Faucet Installation questions from Orland Park homeowners
What does a faucet installation cost?
The faucet type, the condition of the valves and lines and any drilling decide it. We give a written, itemized estimate after we see the sink.
Can you add a filtered-water faucet?
Yes, through a spare hole or a newly drilled one, paired with a carbon or reverse osmosis system.
Do I need a plumber to install a faucet?
In Illinois, plumbing is done by plumbers licensed by the Illinois Department of Public Health. Our licensed plumbers install and connect your faucet.
Repair or replace a dripping faucet?
If the faucet is fairly new and parts are available, repair. If it's old, corroded or leaking in several places, replace.
Why is my faucet leaking from the base?
Worn spout seals. We tell you if a repair kit fixes it or if a new faucet is the better buy.
What is the Orland Park building department phone number?
Permits go through Development Services Department - Building Division, phone 708-403-5300. When your scope needs one, we prepare the application and schedule the inspections.
Do I need a Orland Park-registered contractor for faucet installation?
Contractors must be licensed with the Village before permits issue; apply via Civic Access portal. We take care of that before work starts.
Orland Park plumbing code: who can do the plumbing for faucet installation?
Plumbing permit only issued to a licensed plumbing contractor, limited exception for single-family homeowners. Our plumbing connections are made by licensed plumbers.
Orland Park water: how does it affect faucet installation?
Orland Park's water source: Lake Michigan water from the City of Chicago, delivered through the Village of Oak Lawn regional water system. Aerators and cartridges scale faster with harder water.
Do I need a permit for faucet installation in Orland Park?
It depends on the scope. Orland Park's rule in short: Permit needed for remodeling; application lists electrical and plumbing contractors. We handle the permit when one is needed with Development Services Department - Building Division.
Do you work in my part of Orland Park?
Yes. Our crews work across Orland Park — ZIP 60462, 60467 — and nearby Tinley Park, Woodridge, Bolingbrook.
Working in Orland Park
- A lot of Orland Park kitchens date from the 1990s. We know these layouts well and what is worth keeping.
- Most Orland Park homes are single-family. We protect floors and driveways and leave the site clean every day.
- Live in the Old Orland Historic District? Interior kitchen work is usually not reviewed. We check before anything touches the exterior.
ZIP 60462ZIP 60467
Kitchen Faucet Installation nearby
Other kitchen services in Orland Park
Kitchen Sink Installation & ReplacementNew sinks, undermount and farmhouse styles.
Garbage Disposal Installation & RepairDisposals unjammed, repaired or replaced, with the drain connected right.
Kitchen Plumbing RelocationMove the sink to the island or another wall, drain and vent done right.
Kitchen RemodelingFull kitchen remodels, from layout to last cabinet pull.
Kitchen Cabinet PaintingFactory-smooth painted cabinets without replacing them.