Serving Orland Park & nearby Tinley Park, Woodridge

Kitchen Sink Installation & Replacement in Orland Park, IL

Undermount, drop-in and farmhouse sinks set, sealed and connected by licensed plumbers in Orland Park.

  • Serving Orland Park ZIP 60462, 60467
  • Installed level, sealed and tested before we leave
  • Clear price for the install before the visit

Prefer a callback?

Leave your number and a Orland Park licensed plumber will call you.

Kitchen sink problems we fix in Orland Park

Swapping a sink looks simple until the new bowl doesn't match the cutout or the drain lands in the wrong spot. Our Orland Park crew measures first, then sets the sink and has a licensed plumber hook up the drain and supplies.

1990s stainless double sink

If your sink dates from the 1990s, the drain parts usually do too. We replace both at once.

Strainer or drain leaking

Old strainers loosen and their seals dry out. We install new ones and tighten them so the joint stays dry.

Sink that drains slowly after replacement

A sink that drains poorly after a DIY swap usually has a trap set too high or a tailpiece forced at an angle. We rebuild the drain.

Sink cabinet floor wet or swollen

Water damage in the sink base usually comes from the strainer, the trap or a failed undermount seal. We repair the cause along with the sink.

Chipped or stained porcelain sink

When the finish on a cast-iron or porcelain sink is worn through, it won't come back. A new bowl is quicker than chasing repairs.

Dated sink in an otherwise good kitchen

Not every update needs new counters. A new sink and faucet change how the kitchen looks and works in a day.

Double bowl too small for big pans

Two narrow bowls make sheet pans and stockpots awkward. A large single bowl or a low-divide sink fits them, often in the same cabinet.

Old drain parts that won't line up

Mixed old and new drain parts are where leaks start. With a new sink we replace the trap assembly instead of forcing the old one to fit.

What the install includes

  • Measure the cutout and cabinetA check of the cutout, cabinet width and plumbing so the new sink fits.
  • Shut off and disconnectWe close the valves and take apart the drain, supply and appliance connections.
  • Remove the old sinkOld sealant cut, clips released and the old bowl lifted out.
  • Cabinet changes for farmhouse sinksSink base cut down or replaced, with a support frame for the apron sink.
  • New strainers and drainNew basket strainers, tailpieces and P-trap assembled to the drain line.
  • Faucet and accessoriesYour old faucet reused or a new one mounted on the sink or counter.
  • Supply valves and linesWorn shut-off valves replaced and new braided supply lines installed.

Options to choose from

Drop-in (top-mount)Rests on the counter with a rim; works with laminate as well as stone.
UndermountHung under the countertop; needs a finished cutout edge and a strong counter.
FireclayGlazed ceramic fired at high heat, common for farmhouse sinks; heavy and glossy.
Stainless steelEasy-care steel; a lower gauge number means thicker metal.
Workstation sinksBowls with a ledge for cutting boards, colanders and drying racks.

What the work looks like in Orland Park homes

Kitchen Sink Installation & Replacement in a 1980s-1990s two-story colonial / tract house — beforeBefore
Kitchen Sink Installation & Replacement in a 1980s-1990s two-story colonial / tract house — installedInstalled
Kitchen Sink Installation & Replacement in a 1980s-1990s two-story colonial / tract house — detailDetail

Kitchen Sink Installation & Replacement in a 1980s two-story, Orland Park

A 1980s two-story in Orland Park, a typical kitchen for Orland Park. The kitchen as it was: white double sink. The main complaint was two small bowls where big pots never fit. Finished kitchen: a new undermount stainless single-bowl sink with a pull-down faucet. On site this meant measure the cutout and cabinet, cabinet changes for farmhouse sinks, plus supply valves and lines.

Kitchen Sink Installation & Replacement project in Tinley Park, beforeBefore
Kitchen Sink Installation & Replacement project in Tinley Park, afterAfter

Before and after: a 1990s two-story colonial in Tinley Park

This one is a 1990s two-story colonial in Tinley Park. What we started with: solid-surface integrated sink. The main complaint was a stained solid-surface bowl. Finished kitchen: a new undermount stainless single-bowl sink with a pull-down faucet. The job covered new strainers and drain, faucet and accessories, plus supply valves and lines.

Kitchen Sink Installation & Replacement in Tinley Park →
Kitchen Sink Installation & Replacement project in Bolingbrook, beforeBefore
Kitchen Sink Installation & Replacement project in Bolingbrook, afterAfter

Kitchen Sink Installation & Replacement in a two-story colonial from the 1990s, Bolingbrook

This one is a two-story colonial from the 1990s near Heritage Creek. Before: white cast-iron double sink. What bothered the owners most: worn enamel and rust spots in the old bowl. Finished kitchen: a new undermount stainless single-bowl sink with a pull-down faucet. The job covered measure the cutout and cabinet, new strainers and drain, plus supply valves and lines.

Kitchen Sink Installation & Replacement in Bolingbrook →
Kitchen Remodeling project near Orland Park, beforeBefore
Kitchen Remodeling project near Orland Park, afterAfter

An Orland Park two-story colonial from the 1990s: before and after

Finished: cabinets in white uppers and deep green lowers with polished nickel pulls, dark soapstone-look quartz counters, a white herringbone tile backsplash, warm oak luxury vinyl plank flooring and a flush drum fixture and under-cabinet lights.

Kitchen Remodeling in Orland Park →
Kitchen Cabinet Painting project near Orland Park, beforeBefore
Kitchen Cabinet Painting project near Orland Park, afterAfter

Before and after: a 1990s two-story colonial in Orland Park

What changed: the same doors sprayed in cream uppers and walnut-stained lowers, new satin brass pulls; counters and floor stayed as they were.

Kitchen Cabinet Painting in Orland Park →

How the install goes

  1. Pick the sinkSend the model you like or let us suggest a few that fit.
  2. Measure and planWe check the cutout, the cabinet and the drain, and plan any cabinet changes.
  3. Written estimateA clear quote listing the sink work, parts and any cabinet modifications.
  4. Install and connectThe old sink comes out, the new one is set and a licensed plumber makes the connections.
  5. Cure and testAfter the bond sets, the sink is tested in full use.

Kitchen Sink Installation & Replacement questions from Orland Park homeowners

Will Lake Michigan water mark my new sink?
Some spotting is normal. A quick dry-off and an occasional vinegar rinse keep the bowl clean.
Can you install a sink I bought myself?
Yes. We check that it fits the cutout and the cabinet before install day.
What does a new kitchen sink installation cost?
The sink type, the counter, any cabinet changes and how much plumbing is replaced drive the price. We give a written, itemized estimate after the visit.
What size sink fits my cabinet?
The sink base width sets the limit. Most kitchen sinks are made for common base sizes, and we measure inside the cabinet before you buy.
Who would you call to install a new sink?
For a straight swap, a plumber. If the counter or cabinet changes too, a crew that handles both saves a second visit.
Orland Park water: how does it affect sink replacement?
Orland Park's water source: Lake Michigan water from the City of Chicago, delivered through the Village of Oak Lawn regional water system. We plan fittings and filters around it.
What is the Orland Park building department phone number?
Permits go through Development Services Department - Building Division, phone 708-403-5300. When your scope needs one, we prepare the application and schedule the inspections.
Orland Park plumbing code: who can do the plumbing for sink replacement?
Plumbing permit only issued to a licensed plumbing contractor, limited exception for single-family homeowners. Our plumbing connections are made by licensed plumbers.
Orland Park contractor registration: do kitchen contractors need it?
Contractors must be licensed with the Village before permits issue; apply via Civic Access portal. We take care of that before work starts.
Do I need a permit for sink replacement in Orland Park?
It depends on the scope. Orland Park's rule in short: Permit needed for remodeling; application lists electrical and plumbing contractors. We handle the permit when one is needed with Development Services Department - Building Division.
Do you work in my part of Orland Park?
Yes. Our crews work across Orland Park — ZIP 60462, 60467 — and nearby Tinley Park, Woodridge, Bolingbrook.

Working in Orland Park

  • A lot of Orland Park kitchens date from the 1990s. We know these layouts well and what is worth keeping.
  • Most Orland Park homes are single-family. We protect floors and driveways and leave the site clean every day.
  • Live in the Old Orland Historic District? Interior kitchen work is usually not reviewed. We check before anything touches the exterior.

ZIP 60462ZIP 60467

Kitchen Sink Installation & Replacement nearby

Planning a kitchen project in Orland Park?

Call us — we'll check your ZIP, answer your questions and book an in-home estimate.

Call now (708) 400-7049
Call (708) 400-7049Callback