Built-in microwave with a trim kit
Built-in microwaves and trim-kit models need a specific opening and airflow around the unit. We frame the cabinet space and fasten the trim.
Serving Naperville & nearby Lisle, Warrenville
Microwave Installation in Naperville, IL
Over-the-range, drawer and built-in microwaves installed in Naperville: anchored into the wall, bolted to the cabinet and vented the right way.
- Installers working in Naperville ZIP 60540, 60563, 60564, 60565
- Hookups by licensed trades where the code calls for it
- Old unit hauled away on request
Microwave installs we take on in Naperville
Most microwave calls we get in Naperville are one of three jobs: a new over-the-range unit replacing an old one or a hood, a drawer model going into an island, or a built-in with a trim kit set into a wall cabinet. Each has its own cutout, power and venting needs, and we sort those out first.
Should it vent outside or recirculate?
If there's a duct through the wall or roof, we set the blower to exhaust outside, which clears steam and cooking smells better. With no duct, the unit recirculates through a charcoal filter.
Microwave that sags, wobbles or pulls away from the wall
A loose over-the-range unit is a hazard over a hot range. We check the top bolts and the plate, then rehang it with screws into solid wood.
Cabinet above that's the wrong width or depth
A standard over-the-range microwave expects a cabinet bottom about as wide as the unit to bolt into. If the cabinet is narrower, shallower or uneven, we add a filler or adjust it.
Microwave above a pro-style or high-output range
Wide professional ranges often need more ventilation than a microwave can offer. We read both installation guides before recommending a setup.
Convection or air-fry microwave on an old circuit
Combination microwaves with convection or air-fry modes are heavier and can draw more power. We check the circuit rating against the model before it goes up.
Over-the-range microwave replacing a range hood
A hood is usually hardwired and has no outlet above it, while an over-the-range microwave plugs into a receptacle in the cabinet. We add the outlet, reuse or adapt the duct and hang the new unit.
Not enough height above the range
We measure from the burners to the cabinet bottom before you buy. Too little space means heat on the microwave and a hard reach over the pots.
What the install includes
- Pre-install checkMeasurements, power and venting are checked against the installation instructions.
- Outlet and circuitPower where the new unit needs it, with any new circuit wired by a licensed electrician.
- Studs located and wall plate mountedThe mounting plate is leveled and screwed into studs per the template.
- Blower set and duct connectedWe orient the blower for your vent path and seal the connection to the duct.
- Unit hung and boltedTwo installers lift the microwave onto the plate and draw it tight to the cabinet with the top bolts.
- Drawer and built-in cutoutsCutouts framed for drawer and trim-kit models so they sit flush.
- Testing and haul-awayWe run the microwave, the fan at each speed and the light, then take the old unit and packaging away.
What to pick before the install
Low-profile over-the-range modelsShorter units that leave more room above the burners where cabinets are low.
Over-the-range microwavesMicrowaves with a built-in exhaust fan and light that mount above the range.
Microwave drawersUnder-counter microwaves that open like a drawer, often in an island.
Built-in and trim-kit microwavesMicrowaves set into a wall or pantry cabinet with a finishing trim.
Convection and air-fry combosMicrowaves that also bake, crisp or air-fry, available in over-the-range and built-in styles.
Kitchens like yours in Naperville: before and after
Before
Installed
DetailNaperville kitchen, 1980s two-story: microwave installation
A 1980s two-story near Tamarack, a typical kitchen for Naperville. What we started with: almond appliances. The reason for the call: a decades-old hood and a microwave crowding the counter. The result: a new over-the-range microwave installed above the range and vented. The job covered blower set and duct connected, unit hung and bolted, plus drawer and built-in cutouts.
Before
AfterLisle kitchen, 1980s condo: microwave installation
The site: a 1980s condo in Lisle. Before: white appliances. What bothered the owners most: a weak hood and a microwave stuck on the counter. The result: a new over-the-range microwave installed above the range and vented. The job covered blower set and duct connected, drawer and built-in cutouts, plus testing and haul-away.
Microwave Installation in Lisle →
Before
AfterBefore and after: a 1990s two-story colonial in Warrenville
The site: a 1990s two-story colonial near Summerlakes. What we started with: white appliances. The reason for the call: an old hood and a countertop microwave eating prep space. The result: a new over-the-range microwave installed above the range and vented. On site this meant pre-install check, studs located and wall plate mounted, plus testing and haul-away.
Microwave Installation in Warrenville →
Before
AfterKitchen Remodeling in a 1990s two-story colonial, Naperville
What changed: cabinets in light butter yellow with satin brass pulls, charcoal concrete-look quartz counters, a terracotta-look square tile backsplash, gray wood-look porcelain plank flooring and two glass pendants and recessed lights.
Kitchen Remodeling in Naperville →
Before
AfterKitchen Cabinet Painting in a 1980s two-story, Naperville
What changed: the same doors sprayed in pale mint green, new matte black pulls; counters and floor stayed as they were.
Kitchen Cabinet Painting in Naperville →From the old unit to the new one
- Send the model and photosTell us which microwave you bought and show us where it goes.
- Fit and power checkWe confirm clearance, cabinet size, outlet and vent path, and list anything that must change first.
- Written estimateAn itemized estimate covering removal, mounting, venting and any outlet or cabinet work.
- Install and testWe hang it, connect it, run it and take the old one away.
Microwave Installation questions from Naperville homeowners
Can you put a microwave drawer in my island?
Yes in most cases. The island cabinet is adjusted to the maker's cutout and a receptacle is installed behind the drawer.
Can an over-the-range microwave vent outside?
It can, when your kitchen has an exterior duct. Without one, the microwave recirculates through a charcoal filter.
How long does microwave installation take?
A replacement over the range often takes a couple of hours. Jobs with a new outlet, new duct or cabinet cutout take longer.
Will you take the old microwave or hood away?
Yes. The old unit leaves with us and goes for recycling.
Can you install a microwave I bought at a big-box store or online?
Yes. We install microwaves from any retailer, whether or not they offered installation.
Can Naperville bulk pickup take my old appliance or cabinets?
Hauler Groot Industries (630-892-9294): two bulk items/week free; one appliance/week free but call ahead. If you'd rather not deal with it, we haul old units and debris away.
Does microwave installation need a Naperville building permit, and who files it?
Permits go through Transportation, Engineering and Development (TED) Business Group, Building Permits, phone (630) 420-6100, Option 2. When your scope needs one, we prepare the application and schedule the inspections.
Does Naperville require a licensed electrician for microwave installation?
City guide says electricians must be licensed; it advises insisting on seeing a current license. New circuits and wiring are done by licensed electricians.
Do I need a permit for microwave installation in Naperville?
It depends on the scope. Naperville's rule in short: Remodeling such as kitchens requires a permit, as do electrical work (minor repairs and low-voltage excepted), plumbing pipe/fixture installation or rearrangement, and structural changes. We handle the permit when one is needed with Transportation, Engineering and Development (TED) Business Group, Building Permits.
Do you work in my part of Naperville?
Yes. Our crews work across Naperville, including Downtown Naperville, Highlands, Tamarack — ZIP 60540, 60563, 60564, 60565 — and nearby Lisle, Warrenville, Bolingbrook.
Working in Naperville
- A lot of Naperville kitchens date from the 1990s. We know these layouts well and what is worth keeping.
- Most Naperville homes are single-family. We protect floors and driveways and leave the site clean every day.
- Live in the Naperville Historic District? Interior kitchen work is usually not reviewed. We check before anything touches the exterior.
Downtown NapervilleHighlandsTamarack
ZIP 60540ZIP 60563ZIP 60564ZIP 60565
Microwave Installation nearby
Other kitchen services in Naperville
Dishwasher InstallationOld unit out, new dishwasher connected, leveled and leak-tested.
Oven, Range & Cooktop InstallationGas and electric ranges, wall ovens and cooktops, safely connected.
Built-In Refrigerator InstallationBuilt-in and panel-ready fridges fitted flush, anchored and connected.
Kitchen RemodelingFull kitchen remodels, from layout to last cabinet pull.
Kitchen Cabinet PaintingFactory-smooth painted cabinets without replacing them.