Not enough height above the range
Every maker lists a minimum distance from the cooktop to the bottom of the microwave. If the cabinet is too low, a low-profile model or a cabinet change may be the answer.
Serving Bolingbrook & nearby Woodridge, Naperville
Microwave Installation in Bolingbrook, IL
Over-the-range, drawer and built-in microwaves installed in Bolingbrook: anchored into the wall, bolted to the cabinet and vented the right way.
- Serving Bolingbrook ZIP 60440, 60490
- Installed level, sealed and tested before we leave
- Clear price for the install before the visit
Microwave installs we take on in Bolingbrook
An over-the-range microwave is heavy, hangs in front of a hot cooktop and doubles as the exhaust fan, so how it's hung matters. In Bolingbrook we fasten the wall plate into studs, bolt the top through the cabinet, set the blower for your vent path and check the outlet before the unit goes up.
Over-the-range microwave replacing a range hood
Trading a hood for a microwave means a new mounting plate, holes drilled through the cabinet bottom and a receptacle where the hood wire used to be. All three get done in one visit.
Moving the microwave off the counter
Many owners want the counter clear. We look at the range wall, the base cabinets and the wall cabinets to see where a mounted microwave fits best.
Microwave drawer in an island or base cabinet
A drawer microwave slides into a base cabinet cutout below the counter, and the island needs an outlet behind it. We prepare the opening and secure the unit flush.
Microwave that sags, wobbles or pulls away from the wall
If the front of the microwave dips or the unit moves when you open the door, the wall plate is probably held by drywall anchors instead of studs. We remount it into framing.
Built-in microwave with a trim kit
Placing a microwave above a wall oven or in a tall pantry cabinet takes a precise cutout and an outlet inside. We prepare both and install the kit.
Convection or air-fry microwave on an old circuit
Combination microwaves with convection or air-fry modes are heavier and can draw more power. We check the circuit rating against the model before it goes up.
Should it vent outside or recirculate?
Microwaves ship ready for outside venting or recirculation, and the blower often has to be rotated for your setup. We match it to the duct you have.
What we hook up and check
- Old unit or hood removedWe unplug or disconnect the old unit and clear the wall and cabinet for the new one.
- Outlet and circuitA receptacle in the cabinet above or behind the drawer, on a dedicated circuit when the maker calls for one, added by a licensed electrician.
- Studs located and wall plate mountedWe find the framing and fasten the bracket to solid wood.
- Blower set and duct connectedThe fan is set for outside venting through the wall or roof, or for recirculation with a filter.
- Unit hung and boltedThe unit is hooked on the bracket, bolted from above and checked for level.
- Drawer and built-in cutoutsBase or wall cabinet openings sized to the maker's spec, with support and trim kits fitted.
- Testing and haul-awayHeating, exhaust and light tested, old appliance and boxes removed.
What to pick before the install
Venting partsDamper, duct transitions, charcoal filters and wall or roof caps.
Microwave drawersDrawer units set in a base cabinet, reachable without lifting dishes overhead.
Convection and air-fry combosMicrowaves that also bake, crisp or air-fry, available in over-the-range and built-in styles.
Over-the-range microwavesThe most common type: a microwave and a vent fan in one unit over the cooktop.
Built-in and trim-kit microwavesMicrowaves set into a wall or pantry cabinet with a finishing trim.
Microwave Installation before and after — Bolingbrook homes
Before
Installed
DetailA Bolingbrook 1980s two-story: before and after
This one is a 1980s two-story in Bolingbrook. What we started with: almond appliances. What bothered the owners most: a decades-old hood and a microwave crowding the counter. After: a new over-the-range microwave installed above the range and vented. Work included old unit or hood removed, blower set and duct connected, plus testing and haul-away.
Before
AfterA Woodridge 1980s condo: before and after
This one is a 1980s condo near Seven Bridges. Before: white appliances. The main complaint was an old hood and a countertop microwave eating prep space. The result: a new over-the-range microwave installed above the range and vented. Work included outlet and circuit, blower set and duct connected, plus drawer and built-in cutouts.
Microwave Installation in Woodridge →
Before
AfterPlainfield kitchen, 2000s open-plan home: microwave installation
A 2000s open-plan home in Plainfield, a typical kitchen for Plainfield. What we started with: stainless appliances. What bothered the owners most: a microwave that had stopped working over the range. The result: a new over-the-range microwave installed above the range and vented. Work included old unit or hood removed, studs located and wall plate mounted, plus blower set and duct connected.
Microwave Installation in Plainfield →
Before
AfterBefore and after: a two-story colonial from the 1990s in Bolingbrook
Cabinets in white uppers and deep green lowers with unlacquered brass knobs and cup pulls, warm walnut butcher block counters, a green zellige-look tile backsplash, warm oak luxury vinyl plank flooring and recessed lights and under-cabinet LED strips.
Kitchen Remodeling in Bolingbrook →
Before
AfterBolingbrook kitchen, two-story colonial from the 1990s: kitchen cabinet painting
What changed: the same doors sprayed in forest green, new satin brass pulls; counters and floor stayed as they were.
Kitchen Cabinet Painting in Bolingbrook →From the old unit to the new one
- Send the model and photosShare the model number and photos of the range wall, the cabinet above and the old unit.
- Fit and power checkWe confirm clearance, cabinet size, outlet and vent path, and list anything that must change first.
- Written estimateAn itemized estimate covering removal, mounting, venting and any outlet or cabinet work.
- Install and testOld unit down, new one mounted and vented, everything tested and the old microwave hauled off.
Microwave Installation questions from Bolingbrook homeowners
Can you put a microwave drawer in my island?
We can. We check the island's cabinet layout and wiring path first.
Is a microwave enough ventilation over a gas range?
For everyday cooking it often is, especially vented outside. For heavy searing or a high-output range, a hood moves more air.
Do I need an electrician to install an over-the-range microwave?
Usually not for a straight swap. When a hood is being replaced or there's no receptacle overhead, electrical work is part of the job.
Does the wall plate have to go into studs?
It should. Drywall anchors alone are why some microwaves start to sag.
How high should an over-the-range microwave be above the stove?
The maker's instructions give the minimum. Too low is unsafe over a hot range, so we check it on the visit.
What is the Bolingbrook building department phone number?
Permits go through Building Division (Community Development), Village of Bolingbrook, phone (630) 226-8470. When your scope needs one, we prepare the application and schedule the inspections.
Do I need a Bolingbrook-registered contractor for microwave installation?
The Village has a Contractor Registration form on its permit portal. We take care of that before work starts.
Can Bolingbrook bulk pickup take my old appliance or cabinets?
Hauler Flood Brothers Disposal, (630) 919-0400. One bulk item per week free (extra $8 each. If you'd rather not deal with it, we haul old units and debris away.
Do I need a permit for microwave installation in Bolingbrook?
It depends on the scope. Bolingbrook's rule in short: Permits are required for new construction, renovations, additions, alterations and repairs and must be obtained before work starts. We handle the permit when one is needed with Building Division (Community Development), Village of Bolingbrook.
Do you work in my part of Bolingbrook?
Yes. Our crews work across Bolingbrook, including Westbury, Colonial Village, Heritage Creek — ZIP 60440, 60490 — and nearby Woodridge, Naperville, Lisle.
Working in Bolingbrook
- A lot of Bolingbrook kitchens date from the 1970s. We know these layouts well and what is worth keeping.
- Most Bolingbrook homes are single-family. We protect floors and driveways and leave the site clean every day.
- We know how Building Division (Community Development), Village of Bolingbrook handles kitchen permits and pull them for you.
WestburyColonial VillageHeritage Creek
ZIP 60440ZIP 60490
Microwave Installation nearby
Other kitchen services in Bolingbrook
Dishwasher InstallationOld unit out, new dishwasher connected, leveled and leak-tested.
Oven, Range & Cooktop InstallationGas and electric ranges, wall ovens and cooktops, safely connected.
Built-In Refrigerator InstallationBuilt-in and panel-ready fridges fitted flush, anchored and connected.
Kitchen RemodelingFull kitchen remodels, from layout to last cabinet pull.
Kitchen Cabinet PaintingFactory-smooth painted cabinets without replacing them.