Painted walls in a home built before 1978
We treat old paint as possibly lead-based in older homes and contain the work area before we sand or demolish anything.
Serving Glenview & nearby Northbrook, Park Ridge
Kitchen Drywall & Finish Work in Glenview, IL
Cracked plaster, bulky soffits and patched ceilings in Glenview kitchens, finished smooth and ready for paint.
- Kitchen remodels across Glenview ZIP 60025, 60026, 60062
- One project manager from drawings to final walk-through
- Permits and inspections handled for you
Wall and ceiling problems we fix in Glenview kitchens
Kitchens take more wall damage than any other room: leaks under the sink and from the bathroom above, holes left by old cabinets and outlets, and soffits nobody wants anymore. We repair drywall and plaster in Glenview kitchens, remove soffits, patch ceilings and finish everything so it disappears under paint.
2000s soffits and dropped ceilings
Kitchens from the 2000s often have soffits or a dropped ceiling with a light box. Removing them gives a taller, brighter room.
Wall damage behind the sink or range
Steam and splashes break down drywall near the sink and range. We replace damaged areas with moisture-resistant board where it makes sense.
Patchy walls after a remodel
Tile removal, new wiring and cabinet swaps leave walls uneven. We skim coat or patch so the wall reads as one flat surface.
Bulky soffits above the cabinets
Many soffits are empty; some hide ducts, vent pipes or wiring. We check before demolition and plan around what we find.
Wall prep for paint or tile
Paint shows every flaw, and tile needs a flat, solid backing. We prepare walls to the standard each finish needs.
Nail pops and bad seams
Raking light from under-cabinet lights makes every seam visible. We fix pops and feather the seams wider so they disappear.
Ducts or pipes inside the soffit
When a soffit carries a duct or a plumbing vent, it can sometimes be rerouted, made smaller or built into the new cabinet design.
What the project covers
- Protection and dust controlCabinets, counters and floors are covered and the area is sealed with plastic.
- Soffit and damaged board removalSoffits, bulkheads and damaged drywall or plaster are taken down carefully.
- Framing and backingBlocking for crown, cabinets or a rebuilt soffit is added while the wall is open.
- Skim coat and textureWe match existing texture or skim the surface flat, whichever you choose.
- Crown, casing and trimCrown molding and other trim are installed, nailed, filled and caulked.
- Primer and paint-ready finishRepairs are primed so paint takes evenly; painting can be included.
- CleanupDust is vacuumed with HEPA equipment and the kitchen is wiped down.
Choices you'll make
Crown and trim profilesPaint-grade crown, casing and baseboard in simple or traditional profiles.
Texture finishesOrange peel, knockdown and smooth skim finishes, matched to the room.
Stain-blocking primerWe seal stained areas with stain-blocking primer before paint.
Paper and mesh tapePaper tape for strength on seams and corners, mesh where it suits the repair.
Plaster repair materialsBonding agents, plaster washers and setting compounds made to work with old plaster.
Before and after: kitchens near Glenview
Before
AfterA Glenview 1950s ranch: before and after
The site: a 1950s ranch in Glenview. The kitchen as it was: dark walnut-stained flush-panel cabinets with brass pulls and a fluorescent box light. The main complaint was a dropped ceiling and an old light box. The result: soffits removed, ceiling and walls refinished smooth and painted, new crown molding. On site this meant protection and dust control, framing and backing, plus crown, casing and trim.
Before
AfterKitchen Drywall & Finish Work in a postwar bi-level, Northbrook
This one is a postwar bi-level near Techny. Before: 1970s dark pecan-stained cabinets and a dome ceiling light. The main complaint was a dropped ceiling and an old light box. The result: soffits removed, ceiling and walls refinished smooth and painted, new crown molding. Work included protection and dust control, primer and paint-ready finish, plus cleanup.
Kitchen Drywall & Finish Work in Northbrook →
Before
AfterA Skokie 1960s ranch: before and after
The site: a 1960s ranch in Skokie. Before: original birch cabinets painted white decades ago, sagging doors, chrome pulls and a round fluorescent ceiling ring. The main complaint was a dropped ceiling and an old light box. Finished kitchen: soffits removed, ceiling and walls refinished smooth and painted, new crown molding. The job covered soffit and damaged board removal, framing and backing, plus crown, casing and trim.
Kitchen Drywall & Finish Work in Skokie →
Before
AfterBefore and after: a postwar Cape Cod in Glenview
A new layout with an island, cabinets in warm white shaker, light gray quartz counters and a flush drum fixture and under-cabinet lights.
Kitchen Design & Layout Planning in Glenview →
Before
AfterA Glenview postwar Cape Cod: before and after
What changed: a lowered black honed granite counter section with knee space under the sink, cabinets in deep burgundy with polished nickel pulls, pull-down shelves in the uppers, drawers instead of base doors, a side-opening wall oven, a lever faucet and black cage pendants and slim recessed lights.
Accessible Kitchen Remodeling in Glenview →The project, step by step
- Look and measureWe inspect the walls and ceiling, check for moisture and confirm the scope.
- Written estimateWe send a written price with every repair spelled out.
- Repair and finishWork runs over a few days because compound needs time to dry.
- Prime, paint and cleanWe seal the finish, clean up and walk through the work with you.
Kitchen Drywall & Finish Work questions from Glenview homeowners
Do soffit removals need a permit in Glenview?
Permit rules vary from town to town and by the work involved. We find out what applies to your project before we start.
Should I remove the soffits before new cabinets?
If you want taller cabinets or more storage, yes. Removing them first gives a clean ceiling to work from.
What affects the cost of drywall and finish work?
Area size, plaster or drywall, soffit contents, texture matching and trim. We give a written, itemized estimate after the visit.
What is inside a kitchen soffit?
Soffits may hide the range hood duct, bath exhaust ducts or plumbing vents. Some are simply empty boxes.
Do I need moisture-resistant drywall in a kitchen?
It is not required everywhere, but it is a good choice near the sink and behind the range.
Do I need a Glenview-registered contractor for kitchen drywall and finish work?
General and demolition contractors register with the Village: $50 fee, $25,000 bond, certificate of insurance and workers comp proof. Unlisted contractor types need no registration. We take care of that before work starts.
Does kitchen drywall and finish work need a Glenview building permit, and who files it?
Permits go through Community Development, Inspectional Services Division (Development Center), phone (847) 904-4330. When your scope needs one, we prepare the application and schedule the inspections.
Do I need a permit for kitchen drywall and finish work in Glenview?
It depends on the scope. Glenview's rule in short: Permit required for remodeling/altering a structure, changing the number or location of plumbing fixtures or piping, and new electrical work. We handle the permit when one is needed with Community Development, Inspectional Services Division (Development Center).
Do you work in my part of Glenview?
Yes. Our crews work across Glenview, including The Park, The Glen, The Grove — ZIP 60025, 60026, 60062 — and nearby Northbrook, Park Ridge, Des Plaines.
Working in Glenview
- A lot of Glenview kitchens date from the 2000s. We know these layouts well and what is worth keeping.
- Most Glenview homes are single-family. We protect floors and driveways and leave the site clean every day.
- We know how Community Development, Inspectional Services Division (Development Center) handles kitchen permits and pull them for you.
The ParkThe GlenThe Grove
ZIP 60025ZIP 60026ZIP 60062
Kitchen Drywall & Finish Work nearby
More for Glenview homeowners
- All kitchen services in GlenviewRemodels, cabinets, counters, plumbing, appliances and repairs
- Kitchen Drywall & Finish Work across ChicagolandEvery town we cover for this service
-
Costs and budgetingKitchen Remodel Cost in Chicago: Budget Breakdown, Cost per Square Foot and LaborKitchen remodel cost is driven by scope more than size. National cost guides put a typical project between about $14,600 and $41,600, with an average…3 min read
-
Running the projectKitchen Remodel Timeline & Checklist: How Long Does a Kitchen Remodel Take?How long does a kitchen remodel take? For a same-layout kitchen, construction usually runs about four to eight weeks once cabinets and materials are…3 min read
-
Running the projectKitchen Remodel Permits: Do I Need a Permit to Remodel My Kitchen?Usually yes. Kitchen work that touches plumbing, electrical wiring, gas lines, ventilation or the structure almost always needs a permit and…3 min read
Other kitchen services in Glenview
Kitchen Design & Layout PlanningLayouts, 3D plans and material picks before work starts.
Accessible Kitchen RemodelingKitchens that work for every age and ability.
Kitchen AdditionsBump-outs that add room for an island or dining area.
Kitchen RemodelingFull kitchen remodels, from layout to last cabinet pull.
Kitchen Cabinet PaintingFactory-smooth painted cabinets without replacing them.