Serving Glendale Heights & nearby Bloomingdale, Carol Stream

Kitchen Island & Peninsula Installation in Glendale Heights, IL

We add, enlarge or replace kitchen islands and peninsulas in Glendale Heights, with seating, power and plumbing planned around real clearances.

  • Kitchen remodels across Glendale Heights ZIP 60139
  • One project manager from drawings to final walk-through
  • Permits and inspections handled for you

Prefer a callback?

Leave your number and a Glendale Heights island installer will call you.

Island and peninsula problems we solve in Glendale Heights

An island only helps if you can still walk around it. Before we build one in your Glendale Heights kitchen, we check aisle widths, door swings and where power and water can reach, then install a base anchored to the floor with a top, seating and outlets that work.

Dated peninsula with a half wall

A half wall on the peninsula hides the cook. We remove it, move the outlets to code-compliant spots and add seating.

Concrete floor in a condo

Condo kitchens often sit on a concrete slab, which makes island power and plumbing harder. We plan routes the building allows or suggest a peninsula fed from a wall.

Cracked overhang on a stone top

If your bar top has a crack near the edge, it likely lacked support. New tops get hidden steel or visible corbels.

Island that wobbles or shifts

If the island moves or rocks, it was never anchored. We secure a new base to the floor framing before the top goes on.

Clutter with no storage

An island adds drawers for pots, a trash pull-out and shelves for cookbooks, which clears the perimeter counters.

Island too small to be useful

Small islands often leave unused floor around them. A longer or deeper island uses that space for storage and seats.

No place to sit in the kitchen

If everyone stands around while you cook, a seating side on an island or peninsula gives them a place without blocking the work zone.

Aisles too tight around the island

If two people can't pass each other between the island and the counters, the walkway is short. We rework the footprint so traffic flows.

What's included

  • Floor prepOld flooring patched where a previous island or peninsula stood, and blocking added for anchoring.
  • Electrical rough-inPower routed through the floor or from an adjacent wall, with boxes placed for outlets and lights.
  • Plumbing and ventingWater lines and a properly vented drain when the island gets a sink.
  • Panels and seating sideDecorative panels on the exposed sides and a clean seating face for the stools.
  • Overhang supportSteel brackets, support plates or corbels for seating overhangs on stone tops.
  • CountertopTop templated on the installed base and set with sink and cooktop cut-outs.
  • Outlets, pendants and hookupsFinal electrical and plumbing connections and a test of every outlet and light.

Materials and options

Legs, corbels and bracketsHidden steel brackets for a clean edge, or decorative corbels for a traditional style.
Waterfall endsA slab that wraps over the ends to the floor and protects the cabinet sides.
Quartz and granite topsStone tops give a large, durable work surface; long islands may need a seam or a single large slab.
Butcher blockWood tops add warmth and are pleasant for prep; they need oiling or sealing from time to time.
Counter or bar height seatingCounter height keeps one continuous surface; a raised bar hides prep clutter from the room.

What the work looks like in Glendale Heights homes

Kitchen Island & Peninsula Installation in a 1980s-1990s two-story colonial / tract house — beforeBefore
Kitchen Island & Peninsula Installation in a 1980s-1990s two-story colonial / tract house — in progressIn progress
Kitchen Island & Peninsula Installation in a 1980s-1990s two-story colonial / tract house — afterAfter

Before and after: a 1990s two-story colonial in Glendale Heights

This one is a 1990s two-story colonial in Glendale Heights. What we started with: honey-oak cathedral raised-panel cabinets with worn finish near the handles, brass knobs and almond laminate with a backsplash lip. The main complaint was too little counter space and nowhere to sit. The result: a new island in dusty blue with a black honed granite top and seating. Work included plumbing and venting, panels and seating side, plus outlets, pendants and hookups.

Kitchen Island & Peninsula Installation project in Bloomingdale, beforeBefore
Kitchen Island & Peninsula Installation project in Bloomingdale, afterAfter

Bloomingdale kitchen, 1990s two-story colonial: kitchen island & peninsula installation

A 1990s two-story colonial near Old Town Bloomingdale, a typical kitchen for Bloomingdale. The kitchen as it was: golden-oak cabinets with oak soffits above and white Corian-style solid surface with a yellowed seam. The main complaint was a kitchen without a place to sit. After: a new island in dusty blue with a dark soapstone-look quartz top and seating. Work included electrical rough-in, panels and seating side, plus countertop.

Kitchen Island & Peninsula Installation in Bloomingdale →
Kitchen Island & Peninsula Installation project in Carol Stream, beforeBefore
Kitchen Island & Peninsula Installation project in Carol Stream, afterAfter

Before and after: a two-story colonial from the 1990s in Carol Stream

A two-story colonial from the 1990s in Carol Stream, a typical kitchen for Carol Stream. Before: white thermofoil cabinets peeling at the edges, oak trim and white ceramic tile with dark stained grout lines. The main complaint was a kitchen with no room to prep or gather. The result: a new island in terracotta with a warm walnut butcher block top and seating. The job covered plumbing and venting, countertop, plus outlets, pendants and hookups.

Kitchen Island & Peninsula Installation in Carol Stream →
Pantry Design & Installation project near Glendale Heights, beforeBefore
Pantry Design & Installation project near Glendale Heights, afterAfter

A Glendale Heights two-story colonial from the 1990s: before and after

What changed: the closet next to the kitchen rebuilt as a pantry with solid wood shelves, pull-out baskets on the bottom and a light.

Pantry Design & Installation in Glendale Heights →
Built-In Breakfast Nook & Banquette project near Glendale Heights, beforeBefore
Built-In Breakfast Nook & Banquette project near Glendale Heights, afterAfter

Glendale Heights kitchen, 1980s two-story: built-in breakfast nook & banquette

Finished: a built-in banquette bench with storage drawers and cushions under the window, with a round pedestal table.

Built-In Breakfast Nook & Banquette in Glendale Heights →

How your island project goes

  1. Measure and mock-upWe measure the kitchen and tape the island outline on the floor so you can test the walkways.
  2. Plan and written estimateA layout with dimensions and a written estimate covering carpentry, electrical and plumbing.
  3. Rough-in and permitsPermits filed when wiring or plumbing is added; rough-ins done and inspected before the base goes in.
  4. Build and countertopCabinets fastened down, sides finished, then the countertop is measured and set.
  5. Hookups and walk-throughFinal connections, cleanup and a look at the finished island together.

Kitchen Island & Peninsula Installation questions from Glendale Heights homeowners

Should the island be fixed or freestanding?
Most islands we install are fixed so they can carry stone and power safely; freestanding units are lighter and simpler.
Island or peninsula — which is better?
An island needs walkways on every side; a peninsula attaches to a wall or cabinet run and needs fewer. In smaller kitchens a peninsula often works better.
Will my floor hold a stone island?
Most residential floors carry a typical stone island without trouble. For very large slabs we check the framing from below and add blocking if needed.
Can you put a cooktop or range in the island?
It's possible in most kitchens. Ventilation is the main question, followed by getting gas or power to the island.
Does a kitchen island need an electrical outlet?
Most building codes require one, and it's practical regardless. We place it where it's safe and easy to reach.
Does Glendale Heights require a licensed plumber for island project?
Plumbers exempt from purchasing a Village license but must submit current registration, application and bond. Our plumbing connections are made by licensed plumbers.
Glendale Heights building permit for island project: where do I apply?
Permits go through Community Development Department, phone 630-260-6030. When your scope needs one, we prepare the application and schedule the inspections.
Do Glendale Heights condo associations need to approve island project?
Associations usually set rules for work hours, elevators, deliveries and insurance, and many require approval for plumbing, electrical or structural changes. We provide the certificate of insurance and follow the building's rules.
What does Glendale Heights ask for on electrical work?
Electricians exempt from purchasing a Village license but must submit current city/state registration, application and bond. New circuits and wiring are done by licensed electricians.
Glendale Heights contractor registration: do kitchen contractors need it?
Contractors must be licensed with the Village before working; $20,000 surety/license bond required. We take care of that before work starts.
Do I need a permit for island project in Glendale Heights?
It depends on the scope. Glendale Heights's rule in short: Permits required for most construction projects; a Residential Remodel/Alteration application exists; call Community Development if unsure. We handle the permit when one is needed with Community Development Department.
Do you work in my part of Glendale Heights?
Yes. Our crews work across Glendale Heights — ZIP 60139 — and nearby Bloomingdale, Carol Stream, Addison.

Working in Glendale Heights

  • A lot of Glendale Heights kitchens date from the 1970s. We know these layouts well and what is worth keeping.
  • Condo or townhome? We follow association rules on work hours and elevators and bring the insurance certificate your board asks for.
  • We know how Community Development Department handles kitchen permits and pull them for you.

ZIP 60139

Kitchen Island & Peninsula Installation nearby

Planning a kitchen project in Glendale Heights?

Call us — we'll check your ZIP, answer your questions and book an in-home estimate.

Call now (708) 400-7049
Call (708) 400-7049Callback