Serving Geneva & nearby Batavia, St. Charles

Oven, Range & Cooktop Installation in Geneva, IL

We install gas and electric ranges, wall ovens and cooktops in Geneva, connected safely, leveled and checked before we go.

  • Installers working in Geneva ZIP 60134, 60510
  • Hookups by licensed trades where the code calls for it
  • Old unit hauled away on request

Prefer a callback?

Leave your number and a Geneva range and oven installer will call you.

Range, oven and cooktop installs we handle in Geneva

A new range has to do more than fit the gap. In Geneva we check the gas or electrical supply first, connect the unit per the maker's instructions, put in the anti-tip bracket, level it and test every burner or element before calling it done.

1990s wall oven and cooktop combo

Original 1990s wall ovens leave odd-sized openings. We match a new oven to the box or adjust the cabinet to fit.

Range that tips forward when the oven door opens

Missing anti-tip brackets are common on older installs. We fasten one to the floor or wall and check it holds before we leave.

Double wall oven on an undersized circuit

A double oven can draw far more than a single unit. An electrician checks the panel and runs a circuit sized to the nameplate before we install it.

Downdraft or venting questions

Some cooktops and ranges need a hood above them, and gas cooking makes good ventilation more important. We look at what's there and recommend the right setup.

Switching from gas to induction

Moving to induction means power, not plumbing. We have the panel capacity checked, the circuit added and the old gas supply safely capped.

Slide-in range that won't sit flush

When a slide-in range leaves a gap at the back or rides high above the counter, it needs adjusting on its legs and sometimes a small change to the counter edge.

Wall oven doesn't fit the old cabinet

Wall oven cutouts differ between makers and model years. We compare the new cutout spec with your cabinet and enlarge or fill the opening as needed.

Switching from electric to gas

Going from an electric range to gas means running a new gas line to the kitchen, which needs a permit and a licensed installer. We plan it and get it inspected.

Included with the install

  • Disconnecting the old applianceWe isolate the supply and take out the old unit without damaging the floor or counter.
  • Gas connectionNew flexible connector and fittings on the shutoff, made by a qualified installer to local code and leak-tested.
  • Electrical connectionCord or hardwire connection to a circuit sized for the appliance; new circuits are run by an electrician.
  • Anti-tip bracket and levelingAnti-tip bracket fastened and engaged, range leveled side to side and front to back.
  • Wall oven and cooktop mountingWall ovens fastened into the cabinet; cooktops set and clamped into the counter.
  • Burner, element and oven testEvery burner lit and checked for flame, every element and oven mode heated.
  • Haul-away and cleanupWe remove the old unit, cartons and debris.

Options to choose from

Slide-in and front-control rangesRanges that sit flush with the cabinets and need a closer fit.
Single and double wall ovensOvens built into a cabinet at a comfortable height, alone or stacked with a second oven or a microwave.
Gas and electric cooktopsDrop-in cooktops in the counter, with gas, radiant electric or induction heat.
Pro-style rangesWide, heavy ranges with high-output burners and specific gas and clearance needs.
Gas, electric and dual-fuelPick the fuel by what you cook and what your kitchen has; dual-fuel combines both.

Oven, Range & Cooktop Installation before and after — Geneva homes

Oven, Range & Cooktop Installation in a 1980s-1990s two-story colonial / tract house — beforeBefore
Oven, Range & Cooktop Installation in a 1980s-1990s two-story colonial / tract house — installedInstalled
Oven, Range & Cooktop Installation in a 1980s-1990s two-story colonial / tract house — detailDetail

Oven, Range & Cooktop Installation in a 1990s two-story colonial, Geneva

A 1990s two-story colonial near Mill Creek, a typical kitchen for Geneva. Before: black appliances. The reason for the call: a new range waiting to be connected. After: a new stainless range installed level with a new gas connector. On site this meant anti-tip bracket and leveling, wall oven and cooktop mounting, plus haul-away and cleanup.

Oven, Range & Cooktop Installation project in Batavia, beforeBefore
Oven, Range & Cooktop Installation project in Batavia, afterAfter

Before and after: a 1980s two-story in Batavia

This one is a 1980s two-story in Batavia. Before: almond appliances. The main complaint was an old range they no longer trusted. Finished kitchen: a new stainless range installed level with a new gas connector. On site this meant disconnecting the old appliance, gas connection, plus haul-away and cleanup.

Oven, Range & Cooktop Installation in Batavia →
Oven, Range & Cooktop Installation project in Warrenville, beforeBefore
Oven, Range & Cooktop Installation project in Warrenville, afterAfter

Warrenville kitchen, two-story colonial from the 1990s: oven, range & cooktop installation

This one is a two-story colonial from the 1990s near Summerlakes. Before: white appliances. The main complaint was a new range waiting to be connected. The result: a new stainless range installed level with a new gas connector. On site this meant gas connection, electrical connection, plus haul-away and cleanup.

Oven, Range & Cooktop Installation in Warrenville →
Kitchen Remodeling project near Geneva, beforeBefore
Kitchen Remodeling project near Geneva, afterAfter

Geneva kitchen, 1980s two-story: kitchen remodeling

Finished: cabinets in warm taupe with satin brass pulls, warm walnut butcher block counters, a gray beveled subway tile backsplash, light beige 18x18 porcelain tile flooring and recessed lights and under-cabinet LED strips.

Kitchen Remodeling in Geneva →
Kitchen Cabinet Painting project near Geneva, beforeBefore
Kitchen Cabinet Painting project near Geneva, afterAfter

Kitchen Cabinet Painting in a 1980s two-story, Geneva

Finished: the same doors sprayed in cream uppers and walnut-stained lowers, new satin brass pulls; counters and floor stayed as they were.

Kitchen Cabinet Painting in Geneva →

From the old unit to the new one

  1. Model and photosTell us what you're installing, and show us the current hookup.
  2. Readiness checkWe confirm the gas supply or circuit, the cutout and the clearances, and flag any permit work.
  3. Written estimateAn itemized estimate for removal, installation, parts and any gas line or electrical work.
  4. Install and testWe install, check for leaks, test heat and haul away the old appliance.

Oven, Range & Cooktop Installation questions from Geneva homeowners

Do I need a permit to install a gas range in Geneva?
Swapping a range onto an existing gas outlet often doesn't need one, but running a new gas line does. We confirm the Geneva rules before starting.
Can you replace a cooktop with a different size?
Usually. Cutout size is what matters, and we check it before you buy.
Will you haul away my old stove?
We do. Removal of the old unit can be included in the same visit.
Do you install ranges and ovens I bought elsewhere?
We do. Send the model number and we bring the right connector and parts.
Can a gas range be converted to propane?
If the model supports it, a qualified installer converts it with the manufacturer's kit.
What is the Geneva building department phone number?
Permits go through Building & Zoning Division (Building Division), 109 James St., phone 630-262-0280. When your scope needs one, we prepare the application and schedule the inspections.
Do I need a Geneva-registered contractor for range or oven installation?
None: the City does not have contractor registration (contractor name, address, phone and license numbers if required go on the application). We take care of that before work starts.
What happens to the old appliance in Geneva?
Hauler LRS (customer service 844-633-3577); yard waste and bulk items require waste stickers. If you'd rather not deal with it, we haul old units and debris away.
Do I need a permit for range or oven installation in Geneva?
It depends on the scope. Geneva's rule in short: A building permit is required before any construction or alteration; separate Kitchen Remodel permit form exists. We handle the permit when one is needed with Building & Zoning Division (Building Division), 109 James St..
Do you work in my part of Geneva?
Yes. Our crews work across Geneva, including Mill Creek — ZIP 60134, 60510 — and nearby Batavia, St. Charles, West Chicago.

Working in Geneva

  • A lot of Geneva kitchens date from the 1990s. We know these layouts well and what is worth keeping.
  • Most Geneva homes are single-family. We protect floors and driveways and leave the site clean every day.
  • Live in the Geneva Historic District and designated Historic Landmarks? Interior kitchen work is usually not reviewed. We check before anything touches the exterior.

Mill Creek

ZIP 60134ZIP 60510

Oven, Range & Cooktop Installation nearby

Planning a kitchen project in Geneva?

Call us — we'll check your ZIP, answer your questions and book an in-home estimate.

Call now (708) 400-7049
Call (708) 400-7049Callback