Wall oven or cooktop that doesn't fit the cutout
New wall ovens and cooktops often need a slightly different opening. We adjust the cabinet or counter to the maker's cutout spec.
Oven, Range & Cooktop Installation →Serving Geneva & nearby Batavia, St. Charles
Kitchen Appliance Installation in Geneva, IL
New range, dishwasher, built-in fridge or microwave? We install kitchen appliances in Geneva and take the old ones away.
- Installers working in Geneva ZIP 60134, 60510
- Hookups by licensed trades where the code calls for it
- Old unit hauled away on request
Appliance installation jobs we handle in Geneva
Getting a new appliance into the kitchen is the easy part. In Geneva we check what's behind it first: the gas shutoff, the circuit, the water valve, the drain and the size of the opening. Then we connect it per the maker's instructions, test it and haul the old unit away.
New gas range needs a hookup
We connect gas ranges with a new flexible connector, check every joint for leaks and light each burner before leaving.
Oven, Range & Cooktop Installation →Circuits and gas that may not be ready
Gas lines, 240-volt circuits, water valves and vent paths are checked up front, so you know what's ready and what isn't.
Whole appliance package at once
We install a full kitchen appliance package, checking each hookup before any unit goes in.
Ice maker with no water line
No water where the fridge goes? We arrange a supply line and check it for drips after the first fill.
Built-In Refrigerator Installation →Built-in refrigerator that needs an exact fit
A built-in fridge is installed to the maker's cutout, anchored into framing and finished with panels that match the cabinet fronts.
Built-In Refrigerator Installation →Dishwasher waiting to be connected
If the store delivered the dishwasher without hooking it up, we connect water, drain and power and run a test cycle.
Dishwasher Installation →Switching to induction
Before buying an induction range, it pays to know your electrical service. We look at the panel and the circuit at the range.
Oven, Range & Cooktop Installation →What we hook up and check
- Readiness checkModel numbers matched against your gas, power, water, venting and the opening.
- Cabinet and counter prepOpenings and cutouts adjusted to the maker's spec when needed.
- Gas connectionsGas hookup with fresh fittings and a leak check.
- Electrical connectionsPower matched to the appliance, with panel and circuit work by an electrician.
- Water and drain connectionsSupply lines, drains, high loops or air gaps per code.
- TestingWe run every appliance before we go.
- Haul-away and cleanupWe take the old units and cartons with us.
Options to choose from
Panels and trim kitsFronts and trim matched to the cabinets around the appliance.
MicrowavesMicrowaves mounted over the range or set into cabinets.
Ranges, wall ovens and cooktopsFreestanding and slide-in ranges, wall ovens and drop-in cooktops.
DishwashersBuilt-in dishwashers of any size and control style.
Built-in refrigeratorsFridges designed to sit flush in a cabinet opening.
What the work looks like in Geneva homes
Before
Installed
DetailBefore and after: a 1990s two-story colonial in Geneva
This one is a 1990s two-story colonial near Mill Creek. Before: black appliances. The reason for the call: new appliances waiting to be connected. Finished kitchen: a new range installed and level, anti-tip bracket in place. The job covered readiness check, cabinet and counter prep, plus testing.
Before
AfterBefore and after: a 1990s two-story colonial in Batavia
The site: a 1990s two-story colonial in Batavia. Before: almond appliances. The main complaint was decades-old appliances that kept breaking down. Finished kitchen: a new range installed and level, anti-tip bracket in place. Work included water and drain connections, testing, plus haul-away and cleanup.
Kitchen Appliance Installation in Batavia →
Before
AfterSt. Charles kitchen, 1990s two-story colonial: kitchen appliance installation
This one is a 1990s two-story colonial in St. Charles. The kitchen as it was: white appliances. The reason for the call: old appliances that no longer worked well. The result: a new range installed and level, anti-tip bracket in place. On site this meant cabinet and counter prep, testing, plus haul-away and cleanup.
Kitchen Appliance Installation in St. Charles →
Before
AfterKitchen Remodeling in a 1980s two-story, Geneva
Cabinets in warm taupe with satin brass pulls, warm walnut butcher block counters, a gray beveled subway tile backsplash, light beige 18x18 porcelain tile flooring and recessed lights and under-cabinet LED strips.
Kitchen Remodeling in Geneva →
Before
AfterGeneva kitchen, 1980s two-story: kitchen cabinet painting
Finished: the same doors sprayed in cream uppers and walnut-stained lowers, new satin brass pulls; counters and floor stayed as they were.
Kitchen Cabinet Painting in Geneva →Install day
- Send the model numbersShare the model and the space where it goes.
- Readiness checkWe confirm gas, power, water, venting and fit, and list anything that must change.
- Written estimateA clear written quote listing each appliance and any prep work.
- Install, test and haul awayWe install, test, clean up and remove the old appliances.
Kitchen Appliance Installation questions from Geneva homeowners
Do you haul away old appliances?
Yes, haul-away is available with any install.
Who should connect a gas appliance?
A licensed professional. It's a safety job, not a DIY shortcut.
Can you install a full appliance package?
Yes. We plan the order so the kitchen is back in use quickly.
How long does appliance installation take?
It depends on how many units and how much prep. We give you a schedule with the estimate.
Is the install done to the manufacturer's instructions?
Yes. Every appliance is installed per the maker's instructions, including anchoring, clearances and connections.
Do I need a Geneva-registered contractor for appliance installation?
None: the City does not have contractor registration (contractor name, address, phone and license numbers if required go on the application). We take care of that before work starts.
Can Geneva bulk pickup take my old appliance or cabinets?
Hauler LRS (customer service 844-633-3577); yard waste and bulk items require waste stickers. If you'd rather not deal with it, we haul old units and debris away.
What is the Geneva building department phone number?
Permits go through Building & Zoning Division (Building Division), 109 James St., phone 630-262-0280. When your scope needs one, we prepare the application and schedule the inspections.
Do I need a permit for appliance installation in Geneva?
It depends on the scope. Geneva's rule in short: A building permit is required before any construction or alteration; separate Kitchen Remodel permit form exists. We handle the permit when one is needed with Building & Zoning Division (Building Division), 109 James St..
Do you work in my part of Geneva?
Yes. Our crews work across Geneva, including Mill Creek — ZIP 60134, 60510 — and nearby Batavia, St. Charles, West Chicago.
Working in Geneva
- A lot of Geneva kitchens date from the 1990s. We know these layouts well and what is worth keeping.
- Most Geneva homes are single-family. We protect floors and driveways and leave the site clean every day.
- Live in the Geneva Historic District and designated Historic Landmarks? Interior kitchen work is usually not reviewed. We check before anything touches the exterior.
Mill Creek
ZIP 60134ZIP 60510
Kitchen Appliance Installation nearby
Other kitchen services in Geneva
Kitchen RemodelingFull kitchen remodels, from layout to last cabinet pull.
Kitchen Cabinet PaintingFactory-smooth painted cabinets without replacing them.
Cabinet RefacingNew doors and fronts on your existing cabinet boxes.
Countertop Fabrication & InstallationQuartz, granite and butcher block, templated and installed.
Kitchen Backsplash InstallationTile backsplashes with clean lines and flush outlets.