Moving the microwave off the counter
A countertop microwave eats prep space. Mounting one over the range, under the counter or inside a cabinet gives that space back.
Serving Geneva & nearby Batavia, St. Charles
Microwave Installation in Geneva, IL
Over-the-range, drawer and built-in microwaves installed in Geneva: anchored into the wall, bolted to the cabinet and vented the right way.
- Installers working in Geneva ZIP 60134, 60510
- Hookups by licensed trades where the code calls for it
- Old unit hauled away on request
Microwave installs we take on in Geneva
An over-the-range microwave is heavy, hangs in front of a hot cooktop and doubles as the exhaust fan, so how it's hung matters. In Geneva we fasten the wall plate into studs, bolt the top through the cabinet, set the blower for your vent path and check the outlet before the unit goes up.
Old microwave swap where the holes don't line up
Replacing one over-the-range microwave with another sounds like a straight swap, but the bracket and bolt pattern change between brands. We redo both so the new unit hangs tight.
Convection or air-fry microwave on an old circuit
Bigger multi-mode microwaves may trip a breaker that also feeds the toaster and coffee maker. A dedicated circuit fixes that.
Microwave drawer in an island or base cabinet
Drawer models need an exact opening, support underneath and a receptacle where the drawer won't hit it. We set all three before sliding the unit in.
Microwave above a pro-style or high-output range
Over a large pro range, a real hood usually does the job better than a microwave. If the specs allow a microwave, we install it with the required clearance.
Over-the-range microwave replacing a range hood
Trading a hood for a microwave means a new mounting plate, holes drilled through the cabinet bottom and a receptacle where the hood wire used to be. All three get done in one visit.
Duct that doesn't line up with the new unit
If the duct is undersized, crushed or blocked, we tell you before install so the fan isn't pushing against a dead end.
Not enough height above the range
Every maker lists a minimum distance from the cooktop to the bottom of the microwave. If the cabinet is too low, a low-profile model or a cabinet change may be the answer.
Included with the install
- Pre-install checkMeasurements, power and venting are checked against the installation instructions.
- Old unit or hood removedThe old microwave or range hood is taken down, its wiring made safe and the bracket removed.
- Outlet and circuitPower where the new unit needs it, with any new circuit wired by a licensed electrician.
- Cabinet drilled to the templateThe upper cabinet is marked and drilled so the bolts and cord line up.
- Unit hung and boltedTwo installers lift the microwave onto the plate and draw it tight to the cabinet with the top bolts.
- Drawer and built-in cutoutsCutouts framed for drawer and trim-kit models so they sit flush.
- Testing and haul-awayHeating, exhaust and light tested, old appliance and boxes removed.
Options to choose from
Venting partsDamper, duct transitions, charcoal filters and wall or roof caps.
Low-profile over-the-range modelsSlimmer microwaves for kitchens with limited space over the range.
Built-in and trim-kit microwavesUnits framed into cabinetry so they look part of the kitchen.
Convection and air-fry combosMulti-mode microwaves that can stand in for a second oven.
Microwave drawersDrawer units set in a base cabinet, reachable without lifting dishes overhead.
What the work looks like in Geneva homes
Before
Installed
DetailGeneva kitchen, 1990s two-story colonial: microwave installation
The site: a 1990s two-story colonial near Mill Creek. Before: almond appliances. The main complaint was a decades-old hood and a microwave crowding the counter. The result: a new over-the-range microwave installed above the range and vented. Work included unit hung and bolted, drawer and built-in cutouts, plus testing and haul-away.
Before
AfterMicrowave Installation in a two-story colonial from the 1990s, Warrenville
A two-story colonial from the 1990s near Fox Hollow, a typical kitchen for Warrenville. Before: white appliances. The main complaint was an old hood and a countertop microwave eating prep space. Finished kitchen: a new over-the-range microwave installed above the range and vented. On site this meant old unit or hood removed, drawer and built-in cutouts, plus testing and haul-away.
Microwave Installation in Warrenville →
Before
AfterBefore and after: a 1980s two-story in Geneva
Cabinets in warm taupe with satin brass pulls, warm walnut butcher block counters, a gray beveled subway tile backsplash, light beige 18x18 porcelain tile flooring and recessed lights and under-cabinet LED strips.
Kitchen Remodeling in Geneva →
Before
AfterBefore and after: a 1980s two-story in Geneva
Finished: the same doors sprayed in cream uppers and walnut-stained lowers, new satin brass pulls; counters and floor stayed as they were.
Kitchen Cabinet Painting in Geneva →From the old unit to the new one
- Send the model and photosTell us which microwave you bought and show us where it goes.
- Fit and power checkClearances, power and duct are checked against the installation guide.
- Written estimateA clear written price with electrical or cabinet changes listed separately.
- Install and testOld unit down, new one mounted and vented, everything tested and the old microwave hauled off.
Microwave Installation questions from Geneva homeowners
Do I need an electrician to install an over-the-range microwave?
Only when the power isn't ready. We check for the outlet and circuit before install day and arrange the wiring if needed.
Can you put a microwave drawer in my island?
We can. We check the island's cabinet layout and wiring path first.
Will you take the old microwave or hood away?
We do. Removal and haul-away are part of the job.
How much does microwave installation cost?
Mounting type, venting, electrical work and haul-away drive the price. We put it in writing before we start.
How long does microwave installation take?
Most swaps are done in one visit; built-in and drawer units with cabinet work may need more time.
Can Geneva bulk pickup take my old appliance or cabinets?
Hauler LRS (customer service 844-633-3577); yard waste and bulk items require waste stickers. If you'd rather not deal with it, we haul old units and debris away.
What is the Geneva building department phone number?
Permits go through Building & Zoning Division (Building Division), 109 James St., phone 630-262-0280. When your scope needs one, we prepare the application and schedule the inspections.
Do I need a Geneva-registered contractor for microwave installation?
None: the City does not have contractor registration (contractor name, address, phone and license numbers if required go on the application). We take care of that before work starts.
Do I need a permit for microwave installation in Geneva?
It depends on the scope. Geneva's rule in short: A building permit is required before any construction or alteration; separate Kitchen Remodel permit form exists. We handle the permit when one is needed with Building & Zoning Division (Building Division), 109 James St..
Do you work in my part of Geneva?
Yes. Our crews work across Geneva, including Mill Creek — ZIP 60134, 60510 — and nearby Batavia, St. Charles, West Chicago.
Working in Geneva
- A lot of Geneva kitchens date from the 1990s. We know these layouts well and what is worth keeping.
- Most Geneva homes are single-family. We protect floors and driveways and leave the site clean every day.
- Live in the Geneva Historic District and designated Historic Landmarks? Interior kitchen work is usually not reviewed. We check before anything touches the exterior.
Mill Creek
ZIP 60134ZIP 60510
Microwave Installation nearby
Other kitchen services in Geneva
Dishwasher InstallationOld unit out, new dishwasher connected, leveled and leak-tested.
Oven, Range & Cooktop InstallationGas and electric ranges, wall ovens and cooktops, safely connected.
Built-In Refrigerator InstallationBuilt-in and panel-ready fridges fitted flush, anchored and connected.
Kitchen RemodelingFull kitchen remodels, from layout to last cabinet pull.
Kitchen Cabinet PaintingFactory-smooth painted cabinets without replacing them.