Serving Geneva & nearby Batavia, St. Charles

Kitchen Plumbing Relocation in Geneva, IL

Sinks, dishwashers and water lines moved to the new layout in Geneva, with the drain sloped and vented to code.

  • Installers working in Geneva ZIP 60134, 60510
  • Hookups by licensed trades where the code calls for it
  • Old unit hauled away on request

Prefer a callback?

Leave your number and a Geneva licensed plumber will call you.

When the plumbing has to move in Geneva

Want the sink in the island or under the window on the other wall? We relocate kitchen plumbing in Geneva as part of a remodel or on its own, with a licensed plumber, a permit and an inspection where the village requires one.

House on a slab or crawlspace

With a basement below, new drain and supply lines hang from the joists. On a slab we cut a trench, lay the pipe at the right slope and restore the concrete.

Sink moved under a window

Putting the sink under a window is a common request. The drain and vent have to work around the window framing, and supply lines stay off the cold outside wall when possible.

Not sure if the move is even possible

Before you commit to a layout, we look at the basement or crawlspace, the stack and the floor framing and tell you what the move involves.

Drain too far from the stack

A drain that is too flat holds water and grease; one that drops too fast leaves solids behind. We lay out the run so the slope stays within code.

Island sink with no wall to vent into

Without a proper vent an island sink drains slowly and can siphon its trap dry, letting sewer gas into the kitchen. We plan the vent before the island is built.

Dishwasher on the wrong side of the sink

A dishwasher that sits in the way when its door is open can be moved. We run the drain hose and water line to the new bay and keep the connection under the sink tidy.

Gas line in the way of the new layout

A new range location means rerouting gas, which is handled as its own licensed job. We sequence it with the sink move so the walls only open once.

New fridge spot with no water

When the refrigerator moves to a new wall, the ice maker line has to follow. We run a new line to a recessed valve box behind the fridge.

What we hook up and check

  • Layout and route checkWe look at the floor, the basement or crawlspace and the walls to plan the drain and water route.
  • Shut-off and removalWater shut off, old supply lines capped and the abandoned drain sealed properly.
  • Opening walls or floorDrywall, subfloor or concrete opened only where the new pipe has to run.
  • New drain at the right slopeThe new drain is pitched, supported and joined to the existing line.
  • VentingEvery relocated fixture gets a vent so the trap holds its seal.
  • Dishwasher, fridge and pot filler linesWater and drain connections for every appliance that moved.
  • Pressure test and inspectionLines tested for leaks and left open for the village rough-in inspection.

What to pick before the install

Loop ventA vent loop inside the island cabinet that rises as high as possible before dropping to the drain.
PEX supply linesFlexible water lines that run in long pieces with few fittings inside the wall.
PVC drain and vent pipePlastic drain pipe that resists grease buildup better than old galvanized.
Copper supply linesRigid copper where the house is already copper or where you prefer it for exposed runs.
Quarter-turn shut-off valvesEasy-to-use valves so any fixture can be isolated without shutting off the house.

Kitchen Plumbing Relocation before and after — Geneva homes

Kitchen Plumbing Relocation in a 1980s-1990s two-story colonial / tract house — beforeBefore
Kitchen Plumbing Relocation in a 1980s-1990s two-story colonial / tract house — afterAfter

A Geneva 1990s two-story colonial: before and after

This one is a 1990s two-story colonial in Geneva. What we started with: white cast-iron double sink and honey-oak cathedral raised-panel cabinets with worn finish near the handles, brass knobs. The main complaint was no room to prep near the sink. Finished kitchen: a new island with a prep sink, the drain, vent and water lines relocated from the old wall. The job covered shut-off and removal, new drain at the right slope, plus venting.

Kitchen Plumbing Relocation project in Batavia, beforeBefore
Kitchen Plumbing Relocation project in Batavia, afterAfter

Batavia kitchen, 1990s two-story colonial: kitchen plumbing relocation

A 1990s two-story colonial in Batavia, a typical kitchen for Batavia. The kitchen as it was: solid-surface integrated sink and golden-oak cabinets with oak soffits above. What bothered the owners most: a layout tied to one old plumbing wall. Finished kitchen: a new island with a prep sink, the drain, vent and water lines relocated from the old wall. The job covered opening walls or floor, new drain at the right slope, plus pressure test and inspection.

Kitchen Plumbing Relocation in Batavia →
Kitchen Plumbing Relocation project in Warrenville, beforeBefore
Kitchen Plumbing Relocation project in Warrenville, afterAfter

Kitchen Plumbing Relocation in a two-story colonial from the 1990s, Warrenville

The site: a two-story colonial from the 1990s in Warrenville. The kitchen as it was: white double sink and white thermofoil cabinets peeling at the edges, oak trim. The main complaint was no room to prep near the sink. After: a new island with a prep sink, the drain, vent and water lines relocated from the old wall. On site this meant shut-off and removal, opening walls or floor, plus venting.

Kitchen Plumbing Relocation in Warrenville →
Kitchen Remodeling project near Geneva, beforeBefore
Kitchen Remodeling project near Geneva, afterAfter

Kitchen Remodeling in a 1980s two-story, Geneva

Finished: cabinets in warm taupe with satin brass pulls, warm walnut butcher block counters, a gray beveled subway tile backsplash, light beige 18x18 porcelain tile flooring and recessed lights and under-cabinet LED strips.

Kitchen Remodeling in Geneva →
Kitchen Cabinet Painting project near Geneva, beforeBefore
Kitchen Cabinet Painting project near Geneva, afterAfter

Before and after: a 1990s two-story colonial in Geneva

What changed: the same doors sprayed in cream uppers and walnut-stained lowers, new satin brass pulls; counters and floor stayed as they were.

Kitchen Cabinet Painting in Geneva →

Install day

  1. Plan the moveWe visit, trace the drain and vent route and confirm the new layout works.
  2. Permit and rough-inWe pull the permit and install the new pipe while the kitchen is open.
  3. Test and inspectThe work is tested and inspected before drywall, flooring or concrete go back.
  4. Close up and connectAfter cabinets and counters, we set the sink, the faucet and the appliance hookups.

Kitchen Plumbing Relocation questions from Geneva homeowners

What happens to the old sink drain?
The abandoned drain is sealed at a point the inspector can see, not left open in the wall.
How long does a kitchen plumbing relocation take?
The rough-in itself often takes a day or a few days; inspections and the remodel schedule set the overall timeline.
Can a handyman move my sink plumbing?
Moving drains and water lines is licensed plumbing work in Illinois. It is inspected, so it should be done by a licensed plumber.
What if my house is on a slab?
Slab work means saw-cutting and trenching the floor. It adds time and some mess but is common.
How is an island sink vented?
A loop vent tied back into the venting system is the standard answer in Illinois kitchens; we plan its route before the island is built.
Geneva building permit for plumbing relocation: where do I apply?
Permits go through Building & Zoning Division (Building Division), 109 James St., phone 630-262-0280. When your scope needs one, we prepare the application and schedule the inspections.
Do I need a Geneva-registered contractor for plumbing relocation?
None: the City does not have contractor registration (contractor name, address, phone and license numbers if required go on the application). We take care of that before work starts.
Does Geneva require a licensed plumber for plumbing relocation?
Homeowner may do own plumbing only if owner-occupied; otherwise an Illinois licensed plumber with Letter of Intent, plumbing license and state contractor license. Our plumbing connections are made by licensed plumbers.
Do I need a permit for plumbing relocation in Geneva?
It depends on the scope. Geneva's rule in short: A building permit is required before any construction or alteration; separate Kitchen Remodel permit form exists. We handle the permit when one is needed with Building & Zoning Division (Building Division), 109 James St..
Do you work in my part of Geneva?
Yes. Our crews work across Geneva, including Mill Creek — ZIP 60134, 60510 — and nearby Batavia, St. Charles, West Chicago.

Working in Geneva

  • A lot of Geneva kitchens date from the 1990s. We know these layouts well and what is worth keeping.
  • Most Geneva homes are single-family. We protect floors and driveways and leave the site clean every day.
  • Live in the Geneva Historic District and designated Historic Landmarks? Interior kitchen work is usually not reviewed. We check before anything touches the exterior.

Mill Creek

ZIP 60134ZIP 60510

Kitchen Plumbing Relocation nearby

Planning a kitchen project in Geneva?

Call us — we'll check your ZIP, answer your questions and book an in-home estimate.

Call now (708) 400-7049
Call (708) 400-7049Callback