Serving Geneva & nearby Batavia, St. Charles

Kitchen Sink Installation & Replacement in Geneva, IL

Undermount, drop-in and farmhouse sinks set, sealed and connected by licensed plumbers in Geneva.

  • Installers working in Geneva ZIP 60134, 60510
  • Hookups by licensed trades where the code calls for it
  • Old unit hauled away on request

Prefer a callback?

Leave your number and a Geneva licensed plumber will call you.

Kitchen sink problems we fix in Geneva

A new kitchen sink is part fit, part plumbing. In Geneva we check the counter cutout and the cabinet below, mount the bowl so it stays put, and our licensed plumbers reconnect the drain, disposal, dishwasher and faucet.

1990s stainless double sink

Many 1990s kitchens still have the original drop-in double sink. We swap it for a deeper bowl and new strainers.

Sink cabinet floor wet or swollen

A sink that leaked for months often leaves a soft cabinet floor. We replace the sink, fix the leak source and can put a new panel or mat in the base.

Double bowl too small for big pans

Two narrow bowls make sheet pans and stockpots awkward. A large single bowl or a low-divide sink fits them, often in the same cabinet.

Strainer or drain leaking

Drips below the drain opening come from a worn basket strainer seal. New strainers bedded in putty or a gasket are part of every sink we set.

Chipped or stained porcelain sink

When the finish on a cast-iron or porcelain sink is worn through, it won't come back. A new bowl is quicker than chasing repairs.

Dated sink in an otherwise good kitchen

Not every update needs new counters. A new sink and faucet change how the kitchen looks and works in a day.

Sink installed with the counter replacement

If new stone is going in, the sink usually goes to the fabricator for the cutout. We set it and reconnect the plumbing once the tops are down.

Wanting a farmhouse sink

Converting to a farmhouse sink means changing the front of the sink base and often the countertop cutout. We plan both before ordering.

Included with the install

  • Shut off and disconnectWe close the valves and take apart the drain, supply and appliance connections.
  • Remove the old sinkOld sealant cut, clips released and the old bowl lifted out.
  • Prepare the openingCutout cleaned of old caulk and adhesive; enlarged or polished when needed.
  • Cabinet changes for farmhouse sinksSink base cut down or replaced, with a support frame for the apron sink.
  • New strainers and drainDrain rebuilt to suit the new bowl and outlet position.
  • Faucet and accessoriesYour old faucet reused or a new one mounted on the sink or counter.
  • Leak check and cleanupWe test the whole setup under use and clean up the cabinet.

Models, parts and fittings

Workstation sinksSinks with built-in rails that hold accessories over the basin.
Granite compositeA dense, matte sink made of stone particles and resin that hides water spots.
Drop-in (top-mount)Rests on the counter with a rim; works with laminate as well as stone.
Farmhouse (apron-front)Apron sinks sit forward of the cabinets and need support built in.
UndermountHung under the countertop; needs a finished cutout edge and a strong counter.

Before and after: kitchens near Geneva

Kitchen Sink Installation & Replacement in a 1980s-1990s two-story colonial / tract house — beforeBefore
Kitchen Sink Installation & Replacement in a 1980s-1990s two-story colonial / tract house — installedInstalled
Kitchen Sink Installation & Replacement in a 1980s-1990s two-story colonial / tract house — detailDetail

Before and after: a 1990s two-story colonial in Geneva

The site: a 1990s two-story colonial near Mill Creek. Before: white cast-iron double sink. The reason for the call: a chipped porcelain sink with stains that wouldn't scrub out. After: a new undermount stainless single-bowl sink with a pull-down faucet. The job covered prepare the opening, cabinet changes for farmhouse sinks, plus new strainers and drain.

Kitchen Sink Installation & Replacement project in Batavia, beforeBefore
Kitchen Sink Installation & Replacement project in Batavia, afterAfter

A Batavia two-story colonial from the 1990s: before and after

This one is a two-story colonial from the 1990s in Batavia. The kitchen as it was: white double sink. What bothered the owners most: two small bowls where big pots never fit. After: a new undermount stainless single-bowl sink with a pull-down faucet. Work included shut off and disconnect, remove the old sink, plus prepare the opening.

Kitchen Sink Installation & Replacement in Batavia →
Kitchen Sink Installation & Replacement project in West Chicago, beforeBefore
Kitchen Sink Installation & Replacement project in West Chicago, afterAfter

Kitchen Sink Installation & Replacement in a two-story colonial from the 1990s, West Chicago

The site: a two-story colonial from the 1990s in West Chicago. What we started with: solid-surface integrated sink. The main complaint was a scratched integrated sink that never looked clean. The result: a new undermount stainless single-bowl sink with a pull-down faucet. On site this meant prepare the opening, faucet and accessories, plus leak check and cleanup.

Kitchen Sink Installation & Replacement in West Chicago →
Kitchen Remodeling project near Geneva, beforeBefore
Kitchen Remodeling project near Geneva, afterAfter

Geneva kitchen, 1990s two-story colonial: kitchen remodeling

Finished: cabinets in warm taupe with satin brass pulls, warm walnut butcher block counters, a gray beveled subway tile backsplash, light beige 18x18 porcelain tile flooring and recessed lights and under-cabinet LED strips.

Kitchen Remodeling in Geneva →
Kitchen Cabinet Painting project near Geneva, beforeBefore
Kitchen Cabinet Painting project near Geneva, afterAfter

Before and after: a 1980s two-story in Geneva

Finished: the same doors sprayed in cream uppers and walnut-stained lowers, new satin brass pulls; counters and floor stayed as they were.

Kitchen Cabinet Painting in Geneva →

Install day

  1. Pick the sinkChoose the material and style, or ask us what fits your counter and cabinet.
  2. Measure and planA visit to confirm the fit and the connections before ordering.
  3. Written estimateYou get an itemized estimate for removal, installation and plumbing.
  4. Install and connectThe old sink comes out, the new one is set and a licensed plumber makes the connections.
  5. Cure and testAfter the bond sets, the sink is tested in full use.

Kitchen Sink Installation & Replacement questions from Geneva homeowners

Do you need a plumber to install a kitchen sink?
A licensed plumber makes the connections on every sink we install. That covers the drain, the supplies, the disposal and the dishwasher.
Can I switch from a drop-in to an undermount sink?
With granite or quartz counters, it's possible: the cutout is finished and the sink mounted below. We check the opening size first.
Can you install a sink I bought myself?
Of course. Send us the model and we'll confirm the fit and what else is needed.
What does a new kitchen sink installation cost?
The sink type, the counter, any cabinet changes and how much plumbing is replaced drive the price. We give a written, itemized estimate after the visit.
What size sink fits my cabinet?
Measure the sink base, not the old sink. We check the inside width and depth so the new bowl and its clips fit.
Does Geneva have lead service lines?
The City has a 15-year program to replace all lead and galvanized service lines and publishes a service line inventory. A filter certified for lead reduction is a sensible step until your line is confirmed or replaced.
What is the Geneva building department phone number?
Permits go through Building & Zoning Division (Building Division), 109 James St., phone 630-262-0280. When your scope needs one, we prepare the application and schedule the inspections.
Geneva plumbing code: who can do the plumbing for sink replacement?
Homeowner may do own plumbing only if owner-occupied; otherwise an Illinois licensed plumber with Letter of Intent, plumbing license and state contractor license. Our plumbing connections are made by licensed plumbers.
Do I need a Geneva-registered contractor for sink replacement?
None: the City does not have contractor registration (contractor name, address, phone and license numbers if required go on the application). We take care of that before work starts.
Do I need a permit for sink replacement in Geneva?
It depends on the scope. Geneva's rule in short: A building permit is required before any construction or alteration; separate Kitchen Remodel permit form exists. We handle the permit when one is needed with Building & Zoning Division (Building Division), 109 James St..
Do you work in my part of Geneva?
Yes. Our crews work across Geneva, including Mill Creek — ZIP 60134, 60510 — and nearby Batavia, St. Charles, West Chicago.

Working in Geneva

  • A lot of Geneva kitchens date from the 1990s. We know these layouts well and what is worth keeping.
  • Most Geneva homes are single-family. We protect floors and driveways and leave the site clean every day.
  • Live in the Geneva Historic District and designated Historic Landmarks? Interior kitchen work is usually not reviewed. We check before anything touches the exterior.

Mill Creek

ZIP 60134ZIP 60510

Kitchen Sink Installation & Replacement nearby

Planning a kitchen project in Geneva?

Call us — we'll check your ZIP, answer your questions and book an in-home estimate.

Call now (708) 400-7049
Call (708) 400-7049Callback