Serving St. Charles & nearby Geneva, West Chicago

Kitchen Appliance Installation in St. Charles, IL

New range, dishwasher, built-in fridge or microwave? We install kitchen appliances in St. Charles and take the old ones away.

  • Installers working in St. Charles ZIP 60174, 60175
  • Hookups by licensed trades where the code calls for it
  • Old unit hauled away on request

Prefer a callback?

Leave your number and a St. Charles appliance installer will call you.

Appliance installation jobs we handle in St. Charles

Getting a new appliance into the kitchen is the easy part. In St. Charles we check what's behind it first: the gas shutoff, the circuit, the water valve, the drain and the size of the opening. Then we connect it per the maker's instructions, test it and haul the old unit away.

Leaks after a previous install

A slow drip from a supply line or drain joint can ruin a floor. We trace the leak and reconnect the appliance properly.

Dishwasher Installation →

Whole appliance package at once

Bought a full set of new appliances? We install the range, dishwasher, fridge and microwave in one coordinated visit where possible.

Built-in refrigerator that needs an exact fit

A built-in fridge is installed to the maker's cutout, anchored into framing and finished with panels that match the cabinet fronts.

Built-In Refrigerator Installation →

Circuits and gas that may not be ready

Gas lines, 240-volt circuits, water valves and vent paths are checked up front, so you know what's ready and what isn't.

Dishwasher waiting to be connected

We take a boxed dishwasher to a finished install: old unit out, new one connected, secured and checked for leaks.

Dishwasher Installation →

Old appliances that need to go

We remove old units with the floors protected; refrigerators go for proper refrigerant recovery and recycling.

Kitchen Appliance Removal →

Included with the install

  • Readiness checkWe compare the installation guide with what your kitchen has.
  • Old appliance disconnectedGas, power or water shut off and the old unit disconnected.
  • Cabinet and counter prepCabinet and counter changes so the new unit fits and is supported.
  • Gas connectionsGas hookup with fresh fittings and a leak check.
  • Electrical connectionsCord or hardwire connection; dedicated circuits are added by an electrician.
  • Water and drain connectionsSupply lines, drains, high loops or air gaps per code.
  • Anchoring and levelingAnti-tip brackets, mounting clips and leveling legs set per the instructions.

Options to choose from

Install partsFresh connection parts instead of reused old ones.
DishwashersBuilt-in dishwashers of any size and control style.
Built-in refrigeratorsBuilt-in, column and panel-ready refrigerators, plus undercounter units.
MicrowavesMicrowaves mounted over the range or set into cabinets.
Panels and trim kitsCustom panels and trim kits that make appliances look built in.

Before and after: kitchens near St. Charles

Kitchen Appliance Installation in a 1980s-1990s two-story colonial / tract house — beforeBefore
Kitchen Appliance Installation in a 1980s-1990s two-story colonial / tract house — installedInstalled
Kitchen Appliance Installation in a 1980s-1990s two-story colonial / tract house — detailDetail

Before and after: a 1990s two-story colonial in St. Charles

A 1990s two-story colonial in St. Charles, a typical kitchen for St. Charles. What we started with: white appliances. The reason for the call: old appliances that no longer worked well. After: a new range installed and level, anti-tip bracket in place. Work included cabinet and counter prep, water and drain connections, plus anchoring and leveling.

Kitchen Appliance Installation project in Geneva, beforeBefore
Kitchen Appliance Installation project in Geneva, afterAfter

Before and after: a two-story colonial from the 1990s in Geneva

A two-story colonial from the 1990s near Mill Creek, a typical kitchen for Geneva. What we started with: black appliances. The main complaint was new appliances waiting to be connected. Finished kitchen: a new range installed and level, anti-tip bracket in place. Work included gas connections, water and drain connections, plus anchoring and leveling.

Kitchen Appliance Installation in Geneva →
Kitchen Appliance Installation project in West Chicago, beforeBefore
Kitchen Appliance Installation project in West Chicago, afterAfter

Before and after: a two-story colonial from the 1990s in West Chicago

This one is a two-story colonial from the 1990s in West Chicago. What we started with: almond appliances. The main complaint was appliances older than the kids. After: a new range installed and level, anti-tip bracket in place. The job covered readiness check, old appliance disconnected, plus electrical connections.

Kitchen Appliance Installation in West Chicago →
Kitchen Remodeling project near St. Charles, beforeBefore
Kitchen Remodeling project near St. Charles, afterAfter

A St. Charles 1980s two-story: before and after

What changed: cabinets in deep olive with unlacquered brass knobs and cup pulls, charcoal concrete-look quartz counters, a white 3x12 tile in a stacked pattern backsplash, gray wood-look porcelain plank flooring and black cage pendants and slim recessed lights.

Kitchen Remodeling in St. Charles →
Kitchen Cabinet Painting project near St. Charles, beforeBefore
Kitchen Cabinet Painting project near St. Charles, afterAfter

St. Charles kitchen, two-story colonial from the 1990s: kitchen cabinet painting

The same doors sprayed in light butter yellow, new brushed nickel bar pulls; counters and floor stayed as they were.

Kitchen Cabinet Painting in St. Charles →

Install day

  1. Send the model numbersShare the model and the space where it goes.
  2. Readiness checkWe confirm gas, power, water, venting and fit, and list anything that must change.
  3. Written estimateAn itemized estimate for removal, installation, parts and any electrical, plumbing or cabinet work.
  4. Install, test and haul awayOld units out, new ones connected, secured, tested and the old ones taken away.

Kitchen Appliance Installation questions from St. Charles homeowners

Is the install done to the manufacturer's instructions?
We follow the installation guide for each model, which is also what manufacturers expect.
Do I need a permit for a gas range swap in St. Charles?
Usually not for a like-for-like swap; yes for new gas piping. We check before starting.
How long does appliance installation take?
Most single installs are done in one visit; bigger jobs are scheduled in steps.
Will my kitchen need new electrical work?
It depends on the appliance and your wiring. We check before install day.
How much does appliance installation cost?
A simple swap and an install with new circuits or gas lines are priced very differently. You get a line-item quote.
What does St. Charles ask for on electrical work?
Electrical contractors must be licensed in an Illinois municipality (good standing evidence) and provide a $10,000 surety bond payable to the City. New circuits and wiring are done by licensed electricians.
Do I need a St. Charles-registered contractor for appliance installation?
No registration fee; contractor requirements (general contractor certificate of insurance, with City as certificate holder) must be submitted before a permit is issued. We take care of that before work starts.
Can St. Charles bulk pickup take my old appliance or cabinets?
Hauler Lakeshore Recycling Systems, 844-633-3577: call before refuse day; items and appliances under 50 lb need one sticker each. If you'd rather not deal with it, we haul old units and debris away.
St. Charles building permit for appliance installation: where do I apply?
Permits go through Building Division, Community Development, 2 E. Main St., phone (630) 377-4406. When your scope needs one, we prepare the application and schedule the inspections.
Do I need a permit for appliance installation in St. Charles?
It depends on the scope. St. Charles's rule in short: Permits required for construction, alteration, repair or demolition of any structure; major residential projects including remodels require 5 sets of drawings. We handle the permit when one is needed with Building Division, Community Development, 2 E. Main St..
Do you work in my part of St. Charles?
Yes. Our crews work across St. Charles — ZIP 60174, 60175 — and nearby Geneva, West Chicago, Batavia.

Working in St. Charles

  • A lot of St. Charles kitchens date from the 2000s. We know these layouts well and what is worth keeping.
  • Most St. Charles homes are single-family. We protect floors and driveways and leave the site clean every day.
  • Live in a historic district? Interior kitchen work is usually not reviewed. We check before anything touches the exterior.

ZIP 60174ZIP 60175

Kitchen Appliance Installation nearby

Planning a kitchen project in St. Charles?

Call us — we'll check your ZIP, answer your questions and book an in-home estimate.

Call now (708) 400-7049
Call (708) 400-7049Callback