Tile that ends in the wrong place
A backsplash that ends in a tiny strip by the window looks off. We lay it out first and center the pattern where your eye lands.
Serving Geneva & nearby Batavia, St. Charles
Kitchen Backsplash Installation in Geneva, IL
Tile backsplashes set straight, grouted clean and finished around every outlet in Geneva kitchens.
- Serving Geneva ZIP 60134, 60510
- A new look without tearing the kitchen out
- Clean, protected work area every day
Backsplash problems we solve in Geneva
Most of the work in a good backsplash happens before the first tile goes up. Our Geneva tile setters flatten the wall, extend the outlet boxes and lay out the pattern, then set and grout subway, mosaic, stone or porcelain tile.
Awkward edges and ends
Where the tile stops at an open wall or the end of an upper cabinet, we finish it with a metal edge profile, a bullnose or a pencil liner.
Outlets sunk behind the tile
Outlets recessed behind new tile are a common shortcut. We use box extenders so receptacles and covers sit flush with the finished surface.
Grout stained or cracking
Cracked grout near the counter usually means the joint wasn't caulked. We use flexible caulk where tile meets the counter and grout everywhere else.
Peel-and-stick that didn't last
If the stick-on backsplash is curling at the edges, it's time for set tile. We take it off and prep the wall properly.
Uneven wall surface
Wavy walls make tile edges catch the light unevenly. We skim or patch the wall flat before setting, especially for large-format tile.
Bare wall behind the counters
Paint behind a stove never stays clean for long. A tiled backsplash takes the grease and the water and still looks good.
Grease-prone spot behind the range
The wall behind the stove takes the most grease. A tile with low porosity and fewer joints keeps cleaning easy.
What's included
- Protection and removalCounters and cabinets covered, outlets shut off, old tile or splash removed.
- Outlet box extendersReceptacles brought forward to the new surface, with cover plates that fit.
- Setting the tileTile set level from a straight starting line, with spacers for even joints.
- GroutingSanded, unsanded or epoxy grout chosen for the tile and joint width.
- Edges and trimFinished ends at open walls, cabinet sides and the ceiling line.
- Caulk at the counterFlexible caulk where tile meets the counter and the cabinets.
- Sealing and cleanupNatural stone and cement-based grout sealed when needed; the kitchen cleaned.
Finishes we offer
Subway tileClassic 3x6 or longer rectangles in a running bond, stacked or herringbone layout.
Slab backsplashA full-height sheet of quartz, stone or porcelain matching the counters, with no grout lines.
Natural stoneStone tile looks rich and needs a sealer to resist stains.
Mosaic and glassSmall tiles on mesh sheets for accents or full walls; glass needs careful setting and unsanded or epoxy grout.
Handmade-look and zelligeIrregular tile with depth and shine, set with care for its varying thickness.
Kitchen Backsplash Installation before and after — Geneva homes
Before
In progress
After
DetailGeneva kitchen, 1990s two-story colonial: kitchen backsplash installation
A 1990s two-story colonial near Mill Creek, a typical kitchen for Geneva. The kitchen as it was: white ceramic tile with dark stained grout lines. The main complaint was old tile with stained grout. The result: a gray beveled subway tile backsplash with clean edges and outlets set flush. On site this meant protection and removal, outlet box extenders, plus caulk at the counter.
Before
AfterBatavia kitchen, two-story colonial from the 1990s: kitchen backsplash installation
The site: a two-story colonial from the 1990s in Batavia. The kitchen as it was: blue-and-white decorative tile accent and white Corian-style solid surface with a yellowed seam. The reason for the call: a busy backsplash that clashed with the new look. After: a white 2x8 tile in a vertical stack backsplash with clean edges and outlets set flush. The job covered outlet box extenders, edges and trim, plus caulk at the counter.
Kitchen Backsplash Installation in Batavia →
Before
AfterBefore and after: a 1990s two-story colonial in St. Charles
The site: a 1990s two-story colonial in St. Charles. The kitchen as it was: almond laminate with a backsplash lip. The main complaint was the old laminate lip and bare wall above it. After: a terracotta-look square tile backsplash with clean edges and outlets set flush. Work included protection and removal, grouting, plus caulk at the counter.
Kitchen Backsplash Installation in St. Charles →
Before
AfterBefore and after: a two-story colonial from the 1990s in Geneva
Finished: black honed granite countertops with a tight seam, an undermount sink and a new faucet.
Countertop Fabrication & Installation in Geneva →
Before
AfterGeneva kitchen, 1980s two-story: kitchen flooring installation
What changed: hickory luxury vinyl plank flooring through the kitchen with clean transitions.
Kitchen Flooring Installation in Geneva →Day by day
- Pick tile and patternBring samples or ideas; we help you choose tile, grout color and layout.
- Measure and planWe measure the wall, mark outlets and windows and plan where the cuts fall.
- Prep and setWall repaired, outlets extended and tile set — often in a day or two for a typical kitchen.
- Grout and finishJoints filled, edges trimmed, counter line caulked and the room cleaned.
Kitchen Backsplash Installation questions from Geneva homeowners
Should I install the backsplash before or after the counters?
After. The tile sits on the counter, and stone counters are templated without it.
Do I need to remove the 4-inch splash?
It's your call; removal looks more finished, keeping it is simpler. We may need to patch the wall behind it.
What affects the price of a backsplash?
Wall size, the tile you choose, the pattern, how many outlets and cuts there are and whether old tile comes off. We give a written, itemized estimate after the visit.
How long does a backsplash installation take?
Most backsplashes are set one day and grouted the next; wall repairs or demo can add a day.
Can you install a backsplash in the bathroom too?
We do. Adding a bathroom vanity backsplash during the kitchen job is common.
Geneva contractor registration: do kitchen contractors need it?
None: the City does not have contractor registration (contractor name, address, phone and license numbers if required go on the application). We take care of that before work starts.
Do I need a permit for backsplash installation in Geneva?
It depends on the scope. Geneva's rule in short: A building permit is required before any construction or alteration; separate Kitchen Remodel permit form exists. We handle the permit when one is needed with Building & Zoning Division (Building Division), 109 James St..
Do you work in my part of Geneva?
Yes. Our crews work across Geneva, including Mill Creek — ZIP 60134, 60510 — and nearby Batavia, St. Charles, West Chicago.
Working in Geneva
- A lot of Geneva kitchens date from the 1990s. We know these layouts well and what is worth keeping.
- Most Geneva homes are single-family. We protect floors and driveways and leave the site clean every day.
- Live in the Geneva Historic District and designated Historic Landmarks? Interior kitchen work is usually not reviewed. We check before anything touches the exterior.
Mill Creek
ZIP 60134ZIP 60510
Kitchen Backsplash Installation nearby
Other kitchen services in Geneva
Countertop Fabrication & InstallationQuartz, granite and butcher block, templated and installed.
Kitchen Tile & Grout RepairCracked tiles swapped, loose tiles reset and tired grout redone.
Kitchen Flooring InstallationKitchen flooring: LVP, tile and hardwood.
Kitchen RemodelingFull kitchen remodels, from layout to last cabinet pull.
Kitchen Cabinet PaintingFactory-smooth painted cabinets without replacing them.