Serving Villa Park & nearby Elmhurst, Lombard

Kitchen Faucet Installation in Villa Park, IL

Pull-down, touchless and two-handle kitchen faucets installed leak-free by licensed plumbers in Villa Park.

  • Installers working in Villa Park ZIP 60181
  • Hookups by licensed trades where the code calls for it
  • Old unit hauled away on request

Prefer a callback?

Leave your number and a Villa Park licensed plumber will call you.

Kitchen faucet problems we fix in Villa Park

Whether you picked a pull-down, a touchless or a bridge faucet, we fit it to your sink or counter in Villa Park, cover or reuse the extra holes, and connect it with new supply lines.

Scale on the aerator from lake water

Treated Lake Michigan water still leaves some mineral scale in aerators and spray heads over time. Cleaning them restores the spray pattern.

Leak under the sink at the faucet lines

If the faucet looks fine on top but the cabinet is wet, check the lines under it. Worn supply hoses and spray hoses are common culprits.

Faucet leaking from the base

When the faucet leaks where it meets the sink, either the internal seals or the mounting gasket has failed. We find which and fix it.

Hole count doesn't match the new faucet

A single-hole faucet on a three-hole sink needs a deck plate. A widespread faucet needs three holes, which we can drill in stone counters.

Faucet loose or wobbling on the sink

Wobbly faucets loosen further over time and start leaking at the deck. A proper re-mount fixes it.

Drip from the spout that won't stop

If the spout drips day and night, the seal inside the valve has worn. We repair it or put in a new faucet.

Spout too short or too low

A low spout makes it hard to fill stockpots and leaves water splashing at the back. A high-arc or pull-down faucet gives more room.

Wanting a touchless faucet

Hands-free faucets have a sensor, a solenoid valve and a battery pack or outlet connection. We mount it all where it's reachable for service.

Included with the install

  • Check the sink and suppliesWe look at the hole layout, the valves and the space under the sink before you choose.
  • Shut off and removeThe old faucet and side sprayer taken off without damaging the sink.
  • Replace valves when neededNew shut-off valves if the old ones won't close or weep.
  • Mount the faucetFaucet set with its gasket or deck plate and tightened from below.
  • Supply connectionsHot and cold lines hooked up to the valves.
  • Power for touchless modelsControl box mounted and battery pack or plug-in adapter set up.
  • Flush and testAerator off, lines flushed of debris, then every joint checked under pressure.

What to pick before the install

Filtered-water and pot-filler tapsA small second faucet for filtered water, or a wall-mounted pot filler by the range.
Bridge and two-handle faucetsThree-hole faucets with a classic look, often with a side sprayer.
Pull-out faucetsA shorter spout with a head that pulls straight out toward you.
FinishesChrome wipes clean easily; matte and brushed finishes hide spots.
Deck platesA cover plate that hides extra holes under a single-hole faucet.

Kitchens like yours in Villa Park: before and after

Kitchen Faucet Installation in a 1980s-1990s two-story colonial / tract house — beforeBefore
Kitchen Faucet Installation in a 1980s-1990s two-story colonial / tract house — installedInstalled
Kitchen Faucet Installation in a 1980s-1990s two-story colonial / tract house — detailDetail

Before and after: a 1990s two-story colonial in Villa Park

A 1990s two-story colonial in Villa Park, a typical kitchen for Villa Park. What we started with: white double sink. The main complaint was a leaking two-handle faucet with a side sprayer. The result: a new single-handle pull-down faucet with a clean caulk line. Work included check the sink and supplies, shut off and remove, plus supply connections.

Kitchen Faucet Installation project in Lombard, beforeBefore
Kitchen Faucet Installation project in Lombard, afterAfter

Before and after: a 1980s condo in Lombard

This one is a 1980s condo in Lombard. The kitchen as it was: stainless double sink. The reason for the call: a faucet too low to fill a stockpot. After: a new single-handle pull-down faucet with a clean caulk line. The job covered check the sink and supplies, mount the faucet, plus flush and test.

Kitchen Faucet Installation in Lombard →
Kitchen Faucet Installation project in Addison, beforeBefore
Kitchen Faucet Installation project in Addison, afterAfter

Kitchen Faucet Installation in a 1990s two-story colonial, Addison

This one is a 1990s two-story colonial in Addison. The kitchen as it was: white cast-iron double sink. What bothered the owners most: an old two-handle faucet that dripped into a worn porcelain bowl. The result: a new single-handle pull-down faucet with a clean caulk line. On site this meant replace valves when needed, mount the faucet, plus flush and test.

Kitchen Faucet Installation in Addison →
Kitchen Plumbing Relocation project near Villa Park, beforeBefore
Kitchen Plumbing Relocation project near Villa Park, afterAfter

Kitchen Plumbing Relocation in a postwar Cape Cod, Villa Park

What changed: a new island with a prep sink, the drain, vent and water lines relocated from the old wall.

Kitchen Plumbing Relocation in Villa Park →
Kitchen Remodeling project near Villa Park, beforeBefore
Kitchen Remodeling project near Villa Park, afterAfter

Kitchen Remodeling in a 1960s ranch, Villa Park

What changed: cabinets in light gray uppers and dusty rose lowers with unlacquered brass knobs and cup pulls, light marble-look quartz counters, a gray beveled subway tile backsplash, large-format light stone-look porcelain tile flooring and two glass pendants and recessed lights.

Kitchen Remodeling in Villa Park →

How the install goes

  1. Pick a faucetChoose one yourself or ask us what fits your sink and holes.
  2. Check the setupA quick look under the sink tells us what else the job needs.
  3. Written estimateAn itemized quote for the install and parts before we start.
  4. Install and testThe faucet goes in, a licensed plumber connects it and we test every joint.

Kitchen Faucet Installation questions from Villa Park homeowners

Should I replace the shut-off valves too?
If they are old multi-turn valves or won't close fully, yes. It's easiest while the faucet is already off.
Are touchless faucets worth it?
For people who cook a lot, yes: no greasy handles. They need batteries or power under the sink and a little more upkeep.
Can you add a filtered-water faucet?
We install filtered-water faucets alongside the main one, connected to an under-sink filter.
How long does it take to install a kitchen faucet?
Most installs take a couple of hours from shut-off to final test.
Why is my faucet leaking from the base?
The O-rings around the spout have worn. Rebuilding is possible on some faucets; on older ones, replacement is often better.
Does Villa Park require a licensed plumber for faucet installation?
Plumbing must be done by Illinois state-licensed plumbers; plumber submits a Letter of Intent and valid State License with the permit application. Our plumbing connections are made by licensed plumbers.
Do I need a Villa Park-registered contractor for faucet installation?
No general contractor registration described. Homeowners acting as own general contractor submit a form and homeowner's insurance copy. We take care of that before work starts.
Villa Park water: how does it affect faucet installation?
Villa Park's water source: Purchased Lake Michigan surface water from City of Chicago (via DuPage Water Commission); reported hardness is Lake Michigan water via DuPage Water Commission; regional hardness about 8 grains per gallon (137 mg/L as CaCO3). Aerators and cartridges scale faster with harder water.
Does Villa Park have lead service lines?
Village has developed a service line material inventory, available at invillapark.com/1142. Counts not verified. A filter certified for lead reduction is a sensible step until your line is confirmed or replaced.
Does faucet installation need a Villa Park building permit, and who files it?
Permits go through Permitting Division, Community & Economic Development, phone 630-433-4300. When your scope needs one, we prepare the application and schedule the inspections.
Do I need a permit for faucet installation in Villa Park?
It depends on the scope. Villa Park's rule in short: Permit required for adding, replacing or relocating plumbing fixtures, electrical or HVAC systems, and for moving or building walls. We handle the permit when one is needed with Permitting Division, Community & Economic Development.
Do you work in my part of Villa Park?
Yes. Our crews work across Villa Park — ZIP 60181 — and nearby Elmhurst, Lombard, Addison.

Working in Villa Park

  • A lot of Villa Park kitchens date from the 1950s. We know these layouts well and what is worth keeping.
  • Most Villa Park homes are single-family. We protect floors and driveways and leave the site clean every day.
  • We know how Permitting Division, Community & Economic Development handles kitchen permits and pull them for you.

ZIP 60181

Kitchen Faucet Installation nearby

Planning a kitchen project in Villa Park?

Call us — we'll check your ZIP, answer your questions and book an in-home estimate.

Call now (708) 400-7049
Call (708) 400-7049Callback