Serving Lombard & nearby Villa Park, Glen Ellyn

Kitchen Faucet Installation in Lombard, IL

Pull-down, touchless and two-handle kitchen faucets installed leak-free by licensed plumbers in Lombard.

  • Serving Lombard ZIP 60148
  • Installed level, sealed and tested before we leave
  • Clear price for the install before the visit

Prefer a callback?

Leave your number and a Lombard licensed plumber will call you.

Kitchen faucet problems we fix in Lombard

A kitchen faucet swap is quick when the valves turn, the holes match and the old nuts come loose. In Lombard our licensed plumbers handle the cases where they don't, and leave you with a faucet that doesn't drip at the base.

Scale on the aerator from lake water

Treated Lake Michigan water still leaves some mineral scale in aerators and spray heads over time. Cleaning them restores the spray pattern.

Worried about lead at the kitchen tap

If Lombard lists your line as lead, a new faucet plus a filter certified for lead reduction is a sensible step for drinking water.

Drip from the spout that won't stop

If the spout drips day and night, the seal inside the valve has worn. We repair it or put in a new faucet.

Low flow or a sputtering spout

Before you replace a faucet for low pressure, we check the aerator, the cartridge and the shut-off valves. Often one of them is the cause.

Hole count doesn't match the new faucet

A single-hole faucet on a three-hole sink needs a deck plate. A widespread faucet needs three holes, which we can drill in stone counters.

Faucet loose or wobbling on the sink

If the faucet turns or tilts when you push the handle, the nut below has backed off. We secure it from inside the cabinet.

Wanting a touchless faucet

Touchless faucets need power under the sink, either batteries or a plug-in adapter. We plan the control box and its power when we install.

Leaking from the handle

Leaks at the lever come from the valve inside the body. We replace the cartridge or the whole faucet, depending on its age.

What we hook up and check

  • Check the sink and suppliesA check of the sink holes, shut-offs and clearances so the faucet fits.
  • Shut off and removeWater off, supply lines disconnected and the old faucet unbolted.
  • Clean the deckThe sink or counter around the holes cleaned so the new base seals.
  • Replace valves when neededNew shut-off valves if the old ones won't close or weep.
  • Pull-down hose and weightSpray hose routed clear of the drain and disposal, weight set so it retracts.
  • Power for touchless modelsSensor faucet wiring and power placed where it can be serviced.
  • Flush and testAerator off, lines flushed of debris, then every joint checked under pressure.

What to pick before the install

Filtered-water and pot-filler tapsA small second faucet for filtered water, or a wall-mounted pot filler by the range.
Pull-down faucetsA spray head that pulls down into the sink; the most popular kitchen style.
FinishesStainless, chrome, matte black and brass finishes, each with its own care.
Bridge and two-handle faucetsThree-hole faucets with a classic look, often with a side sprayer.
Deck platesA cover plate that hides extra holes under a single-hole faucet.

Kitchens like yours in Lombard: before and after

Kitchen Faucet Installation in a suburban condo / townhome — beforeBefore
Kitchen Faucet Installation in a suburban condo / townhome — installedInstalled
Kitchen Faucet Installation in a suburban condo / townhome — detailDetail

Before and after: a 1980s condo in Lombard

This one is a 1980s condo in Lombard. The kitchen as it was: stainless double sink. The main complaint was a leaking two-handle faucet with a side sprayer. Finished kitchen: a new single-handle pull-down faucet with a clean caulk line. Work included clean the deck, replace valves when needed, plus pull-down hose and weight.

Kitchen Faucet Installation project in Villa Park, beforeBefore
Kitchen Faucet Installation project in Villa Park, afterAfter

A Villa Park 1990s two-story colonial: before and after

A 1990s two-story colonial in Villa Park, a typical kitchen for Villa Park. What we started with: white double sink. The main complaint was a leaking two-handle faucet with a side sprayer. The result: a new single-handle pull-down faucet with a clean caulk line. On site this meant check the sink and supplies, replace valves when needed, plus flush and test.

Kitchen Faucet Installation in Villa Park →
Kitchen Faucet Installation project in Glen Ellyn, beforeBefore
Kitchen Faucet Installation project in Glen Ellyn, afterAfter

Glen Ellyn kitchen, 1990s two-story colonial: kitchen faucet installation

The site: a 1990s two-story colonial in Glen Ellyn. What we started with: solid-surface integrated sink. The reason for the call: a leaking faucet with handles that were hard to turn. Finished kitchen: a new single-handle pull-down faucet with a clean caulk line. The job covered clean the deck, replace valves when needed, plus power for touchless models.

Kitchen Faucet Installation in Glen Ellyn →
Kitchen Plumbing Relocation project near Lombard, beforeBefore
Kitchen Plumbing Relocation project near Lombard, afterAfter

Kitchen Plumbing Relocation in a 1960s ranch, Lombard

Finished: a new island with a prep sink, the drain, vent and water lines relocated from the old wall.

Kitchen Plumbing Relocation in Lombard →
Kitchen Remodeling project near Lombard, beforeBefore
Kitchen Remodeling project near Lombard, afterAfter

Before and after: a 1950s ranch in Lombard

What changed: cabinets in dark teal with brushed nickel bar pulls, charcoal concrete-look quartz counters, a white 2x8 tile in a vertical stack backsplash, hickory luxury vinyl plank flooring and recessed lights and under-cabinet LED strips.

Kitchen Remodeling in Lombard →

Install day

  1. Pick a faucetSend the model you like and a photo of your sink.
  2. Check the setupWe confirm the hole count, valves and clearances.
  3. Written estimateYou get the price in writing, including any valve replacement.
  4. Install and testInstalled, flushed and checked for leaks, usually in one visit.

Kitchen Faucet Installation questions from Lombard homeowners

How long does it take to install a kitchen faucet?
Most installs take a couple of hours from shut-off to final test.
Pull-down or pull-out: which should I choose?
If there's room above the sink, a pull-down. If space is tight, a pull-out.
Can you add a filtered-water faucet?
Yes, through a spare hole or a newly drilled one, paired with a carbon or reverse osmosis system.
Should I replace the shut-off valves too?
If they are old multi-turn valves or won't close fully, yes. It's easiest while the faucet is already off.
Why is my faucet leaking from the base?
Worn spout seals. We tell you if a repair kit fixes it or if a new faucet is the better buy.
Does Lombard require a licensed plumber for faucet installation?
Registration requires a copy of a current State of Illinois Department of Public Health plumbing registration. Our plumbing connections are made by licensed plumbers.
Do Lombard condo associations need to approve faucet installation?
Associations usually set rules for work hours, elevators, deliveries and insurance, and many require approval for plumbing, electrical or structural changes. We provide the certificate of insurance and follow the building's rules.
What is the Lombard building department phone number?
Permits go through Building Division, Community Development and Building, phone (630) 620-5750. When your scope needs one, we prepare the application and schedule the inspections.
Lombard contractor registration: do kitchen contractors need it?
Contractors must register with the Village: $100 fee, valid 1 year, online or via Building Division; insurance certificate with at least $300,000 liability coverage. We take care of that before work starts.
What is Lombard doing about lead water lines?
Village has a Lead Water Service Replacement Plan and service line map; Village replaces main-to-curb-stop portion at no cost and offers reimbursement for the private portion. A filter certified for lead reduction is a sensible step until your line is confirmed or replaced.
Do I need a permit for faucet installation in Lombard?
It depends on the scope. Lombard's rule in short: Village requires a building permit for new structures and updates to existing structures; replacing interior doors and fixtures at the same size with no structural change needs no permit. We handle the permit when one is needed with Building Division, Community Development and Building.
Do you work in my part of Lombard?
Yes. Our crews work across Lombard — ZIP 60148 — and nearby Villa Park, Glen Ellyn, Addison.

Working in Lombard

  • A lot of Lombard kitchens date from the 1960s. We know these layouts well and what is worth keeping.
  • Condo or townhome? We follow association rules on work hours and elevators and bring the insurance certificate your board asks for.
  • We know how Building Division, Community Development and Building handles kitchen permits and pull them for you.

ZIP 60148

Kitchen Faucet Installation nearby

Planning a kitchen project in Lombard?

Call us — we'll check your ZIP, answer your questions and book an in-home estimate.

Call now (708) 400-7049
Call (708) 400-7049Callback