1990s hood on an old duct
A 1990s hood swap usually turns up a small, greasy duct and a damper that no longer closes. Those get replaced with the hood.
Serving Naperville & nearby Lisle, Warrenville
Range Hood Installation in Naperville, IL
We install under-cabinet, wall chimney, island and insert range hoods in Naperville, ducted outside wherever the house allows.
- Serving Naperville ZIP 60540, 60563, 60564, 60565
- Installed level, sealed and tested before we leave
- Clear price for the install before the visit
Range hood installs we handle in Naperville
Swapping a tired hood for a new one can be a short job, and adding a hood where there was none takes more planning. Either way, we work out in Naperville where the duct can run, what the wiring needs and whether the village wants a permit, before you order.
Gas range that needs stronger ventilation
Cooking on gas puts more into the kitchen air than electric or induction does. A ducted hood with enough capture area and airflow is the right match.
Hood too narrow for the cooktop
Upgrading to a 36-inch range under an old 30-inch hood is a common mismatch. The new hood should cover the full cooking surface.
Swapping an over-the-range microwave for a hood
An over-the-range microwave is a weak ventilator. Replacing it with an under-cabinet or chimney hood is a common install for us.
Duct too small for the new hood
Putting a powerful fan on a narrow duct mostly adds noise. We size the duct to the hood's outlet and keep it that size all the way out.
Old hood that only recirculates
A hood that blows air back into the room through a charcoal filter catches some grease but leaves heat, moisture and smoke inside. When a duct route exists, we convert it to vent outdoors.
High-CFM hood and makeup air
A big fan in a well-sealed home can backdraft a water heater or furnace flue. We confirm what your village requires and plan makeup air when it applies.
Long duct run with many elbows
A duct that snakes across the ceiling to a far wall can starve even a strong fan. We look for a shorter path, sometimes straight up through the roof.
What we hook up and check
- Site check and sizingWe measure the cooktop, the space above it and the possible duct routes, then size the hood.
- Permit and approvalsPermits, condo approvals and any makeup-air requirement are confirmed up front.
- Removing the old hoodPower off, old hood disconnected and taken down, the old duct inspected or removed.
- Duct runA short, direct duct with as few elbows as possible.
- Electrical connectionPower brought to the hood and connected per the maker's instructions.
- Recirculating setupWhere ducting outside isn't possible, a recirculating kit with charcoal filters is installed.
- Test and cleanupEvery fan speed and light tested, the damper checked from outside, the area cleaned up.
Options to choose from
Duct, caps and dampersSmooth metal pipe and a damper-equipped exterior termination.
Ducted vs recirculatingVenting outdoors removes heat and moisture; ductless filtering is the fallback when no duct path exists.
Wall chimney hoodsWall-mounted hoods with a tall cover, often used where there is no cabinet above the range.
Island hoodsHoods suspended above an island, supported from the ceiling framing.
Inserts and linersThe working core of a decorative hood, ducted like any other hood.
Before and after: kitchens near Naperville
Before
Installed
DetailA Naperville 1980s two-story: before and after
The site: a 1980s two-story near Highlands. What we started with: white appliances and white thermofoil cabinets peeling at the edges, oak trim. What bothered the owners most: an old hood that was loud and pulled very little air. Finished kitchen: a new stainless chimney range hood ducted to the outside. The job covered permit and approvals, recirculating setup, plus test and cleanup.
Before
AfterBefore and after: a suburban townhome in Lisle
A suburban townhome near The Meadows, a typical kitchen for Lisle. The kitchen as it was: white appliances and oak flat-panel cabinets. What bothered the owners most: an old hood that was loud and pulled very little air. After: a new stainless chimney range hood ducted to the outside. The job covered site check and sizing, removing the old hood, plus recirculating setup.
Range Hood Installation in Lisle →
Before
AfterRange Hood Installation in a 1990s two-story colonial, Warrenville
The site: a 1990s two-story colonial near Saddle Ridge. The kitchen as it was: black appliances and golden-oak cabinets with oak soffits above. The main complaint was cooking smells that stayed in the house for hours. After: a new stainless chimney range hood ducted to the outside. On site this meant site check and sizing, removing the old hood, plus test and cleanup.
Range Hood Installation in Warrenville →
Before
AfterA Naperville 1990s two-story colonial: before and after
Cabinets in light butter yellow with satin brass pulls, charcoal concrete-look quartz counters, a terracotta-look square tile backsplash, gray wood-look porcelain plank flooring and two glass pendants and recessed lights.
Kitchen Remodeling in Naperville →
Before
AfterKitchen Cabinet Painting in a 1990s two-story colonial, Naperville
The same doors sprayed in pale mint green, new matte black pulls; counters and floor stayed as they were.
Kitchen Cabinet Painting in Naperville →Install day
- Photos and modelSend photos of the range wall, the old hood and the cabinet above, plus the model you like.
- Duct route and sizingWe decide where the duct can run and which hood fits that route.
- Written estimateA clear written price with duct and electrical work listed separately.
- Install and testHood mounted, ducted and wired, then every speed tested and the damper checked.
Range Hood Installation questions from Naperville homeowners
Do I need a permit to install a range hood?
Replacing a hood in place is usually simple; new ductwork and roof or wall holes are what bring permits into play.
Can a range hood vent into the attic?
Never. We carry the duct through to an exterior termination.
Do I need makeup air for a big hood in Naperville?
Possibly. High-CFM hoods can trigger a makeup-air requirement under local code. We check with the village before you pick the hood.
Can I duct a hood outside in my Naperville condo?
Many condo boards must approve any exterior penetration. If it's not allowed, a recirculating hood is the option.
Can I install a range hood myself?
Some do. The hard parts are cutting through the exterior, sealing the cap and sizing the duct, and those are the parts that cause leaks and weak airflow.
Which Naperville office signs off on hood work?
Naperville Fire Dept Community Risk Reduction Division, 1380 Aurora Ave. We schedule the inspection and have the paperwork ready.
Naperville building permit for range hood installation: where do I apply?
Permits go through Transportation, Engineering and Development (TED) Business Group, Building Permits, phone (630) 420-6100, Option 2. When your scope needs one, we prepare the application and schedule the inspections.
Do I need historic review for range hood installation in Naperville?
Naperville has locally reviewed areas, including Naperville Historic District (local, designated 1986 and National Register 1977). Exterior changes there can need review; interior-only work usually does not. We check before anything changes on the outside.
What does Naperville ask for on electrical work?
City guide says electricians must be licensed; it advises insisting on seeing a current license. New circuits and wiring are done by licensed electricians.
Do I need a permit for range hood installation in Naperville?
It depends on the scope. Naperville's rule in short: Remodeling such as kitchens requires a permit, as do electrical work (minor repairs and low-voltage excepted), plumbing pipe/fixture installation or rearrangement, and structural changes. We handle the permit when one is needed with Transportation, Engineering and Development (TED) Business Group, Building Permits.
Do you work in my part of Naperville?
Yes. Our crews work across Naperville, including Downtown Naperville, Highlands, Tamarack — ZIP 60540, 60563, 60564, 60565 — and nearby Lisle, Warrenville, Bolingbrook.
Working in Naperville
- A lot of Naperville kitchens date from the 1990s. We know these layouts well and what is worth keeping.
- Most Naperville homes are single-family. We protect floors and driveways and leave the site clean every day.
- Live in the Naperville Historic District? Interior kitchen work is usually not reviewed. We check before anything touches the exterior.
Downtown NapervilleHighlandsTamarack
ZIP 60540ZIP 60563ZIP 60564ZIP 60565
Range Hood Installation nearby
Other kitchen services in Naperville
Range Hood RepairFans, motors, switches, lights and rattles on kitchen range hoods.
Oven, Range & Cooktop InstallationGas and electric ranges, wall ovens and cooktops, safely connected.
Kitchen Electrical WorkNew circuits and outlets for kitchen appliances.
Kitchen RemodelingFull kitchen remodels, from layout to last cabinet pull.
Kitchen Cabinet PaintingFactory-smooth painted cabinets without replacing them.