Sinks and floor drains backing up
When the three-compartment sink or floor drains back up during service, the trap is often full or the line past it is coated with grease. We clean the trap and clear the line.
Serving Bolingbrook & nearby Woodridge, Naperville
Grease Trap Installation & Cleaning in Bolingbrook, IL
Grease traps and interceptors sized, installed, cleaned and kept on schedule for restaurants and food-service kitchens in Bolingbrook.
- Commercial kitchens across Bolingbrook ZIP 60440, 60490
- Nights, early mornings and closed days
- Coordination with the fire and health inspectors
Grease trap problems we handle in Bolingbrook
Every kitchen that washes greasy pans sends fats, oils and grease toward the sewer, and the trap or interceptor is what stops them. In Bolingbrook we size and install grease traps, clean and maintain them on a schedule, and keep the service records the sanitary district or village asks to see.
Interceptor overdue for pumping
When the outdoor interceptor hasn't been pumped in a long while, grease and solids crowd out the water. We arrange pumping by a licensed hauler and check the baffles and outlet.
Sewer or rotten-egg smell in the kitchen
A sour smell near the sinks or the back door often comes from a trap that is overdue for cleaning or has a bad lid seal. We clean it and check the seal and venting.
Moving into a space with an unknown trap
A second-generation restaurant space may have a trap nobody has opened in years. We locate it, pump or clean it and tell you if it suits your kitchen.
New restaurant needs a trap or interceptor
New food establishments usually need a grease trap or interceptor approved during plan review. We size it from your fixtures and flow and install it before inspection.
Grease clogs in the sewer line
Grease that escapes the trap cools and hardens in the pipe. We jet the line clean and fix the trap problem that let it through.
School, church or daycare kitchen trap
A school or church kitchen trap can go a long time between services, but not forever. We check it and set a realistic schedule.
Staff cleaning the trap themselves
Small under-sink traps can be cleaned by trained staff, but grease has to be disposed of properly and a log kept. We can take that over or set up the routine.
Scope of work
- SizingTrap or interceptor sized by fixtures, flow rate and the local requirements that apply.
- Permits and plan reviewPlumbing permit and plan review for new or replaced traps, where the village requires it.
- InstallationNew traps installed with proper venting, flow control and access for cleaning.
- Cleaning and pump-outGrease and solids removed, the trap scraped and baffles cleared.
- Inspection of baffles and outletWe look inside the empty trap for damage that lets grease pass.
- Line jettingJetting for lines that have built up grease past the trap.
- Service log and manifestsEach visit is recorded with date, measurements and work done; pumped waste is documented with the hauler's manifest.
Equipment and options
Under-sink trap or interceptorIndoor traps suit lighter grease loads; interceptors suit busy kitchens and many fixtures.
Under-sink grease trapsCompact hydromechanical traps that sit under or next to a sink and are cleaned often.
Flow control fittingsA fitting that limits flow so the trap can do its job.
In-ground grease interceptorsLarge outdoor or below-slab tanks that hold more grease and are pumped less often.
Poly and coated steel trapsPlastic traps resist corrosion; steel traps are still used where size or listing calls for them.
What the work looks like in Bolingbrook homes
Before
AfterBefore and after: a commercial kitchen in Bolingbrook
A commercial kitchen near Westbury, a typical kitchen for Bolingbrook. The main complaint was a grease trap that kept backing up the prep sinks. The result: the same interceptor pumped and the lid closed, service hose coiled on the truck. The job covered permits and plan review, installation, plus cleaning and pump-out.
Before
AfterWoodridge kitchen, cafe kitchen: grease trap installation & cleaning
This one is a cafe kitchen near Seven Bridges. The reason for the call: a grease trap that kept backing up the prep sinks. The result: the same interceptor pumped and the lid closed, service hose coiled on the truck. The job covered permits and plan review, line jetting, plus service log and manifests.
Grease Trap Installation & Cleaning in Woodridge →
Before
AfterCommercial Hood Cleaning in a commercial kitchen, Bolingbrook
What changed: the same hood degreased to bare stainless with an inspection sticker area.
Commercial Hood Cleaning in Bolingbrook →
Before
AfterBefore and after: a 1980s two-story in Bolingbrook
Finished: cabinets in white uppers and deep green lowers with unlacquered brass knobs and cup pulls, warm walnut butcher block counters, a green zellige-look tile backsplash, warm oak luxury vinyl plank flooring and recessed lights and under-cabinet LED strips.
Kitchen Remodeling in Bolingbrook →
Before
AfterBefore and after: a two-story colonial from the 1990s in Bolingbrook
The same doors sprayed in forest green, new satin brass pulls; counters and floor stayed as they were.
Kitchen Cabinet Painting in Bolingbrook →How the project goes
- Call or book a visitTell us about the kitchen, the backup or notice and when the trap was last cleaned.
- Inspect the trapWe open the trap, measure grease and solids and check its size and condition.
- Written estimateA clear written quote for the work and the recommended schedule.
- Clean, pump or installThe trap is cleaned or pumped, repaired or replaced, often before or after service hours.
- Log and scheduleYou get a dated service record and the next visit on the calendar.
Grease Trap Installation & Cleaning questions from Bolingbrook businesses
Can you service the trap outside our hours?
Off-hours service is common for us, so the trap is handled without stopping the line.
Do I need a permit to install a grease trap?
In most villages a new trap needs a plumbing permit. We file it and schedule the inspection.
What records do inspectors want?
A maintenance log with service dates and what was done, and for pumped interceptors the hauler's manifests.
How is a grease trap sized?
By the fixtures that drain into it and their flow rate, plus local rules. Interceptors are also sized by meals served and kitchen volume.
What can't go down a grease trap?
Don't pour used cooking oil down the sink; scrape plates before washing and keep food solids out of the drain.
Do I need a Bolingbrook-registered contractor for grease trap service?
The Village has a Contractor Registration form on its permit portal. We take care of that before work starts.
What are Bolingbrook's grease trap rules?
Village Public Works (Wastewater); household FOG guidance and a FOG Guide on the sanitary sewer page. We size and service interceptors to meet them.
Bolingbrook building permit for grease trap service: where do I apply?
Permits go through Building Division (Community Development), Village of Bolingbrook, phone (630) 226-8470. When your scope needs one, we prepare the application and schedule the inspections.
Do you work in my part of Bolingbrook?
Yes. Our crews work across Bolingbrook, including Westbury, Colonial Village, Heritage Creek — ZIP 60440, 60490 — and nearby Woodridge, Naperville, Lisle.
Working in Bolingbrook
- Kitchens in Bolingbrook keep cooking as long as possible: we schedule the noisy work for off-hours.
- When a permit is required, we prepare the submittal for Building Division (Community Development), Village of Bolingbrook and meet the fire inspector on site.
- We handle the paperwork landlords and property managers ask for: insurance, access times and scope sign-off.
WestburyColonial VillageHeritage Creek
ZIP 60440ZIP 60490
Grease Trap Installation & Cleaning nearby
Other kitchen services in Bolingbrook
Commercial Kitchen Hood InstallationType I and II hoods, grease duct, fans and makeup air, built to NFPA 96.
Commercial Hood CleaningHood, duct and roof fan degreased to bare metal, after hours.
Kitchen RemodelingFull kitchen remodels, from layout to last cabinet pull.
Kitchen Cabinet PaintingFactory-smooth painted cabinets without replacing them.
Cabinet RefacingNew doors and fronts on your existing cabinet boxes.