Fan stuck on one speed
A fan that ignores the speed buttons often has a worn switch or a failing board, both of which can be replaced.
Serving Aurora & nearby Batavia, Warrenville
Range Hood Repair in Aurora, IL
Fan dead, lights out or a hood that rattles and roars? We repair range hoods in Aurora and tell you plainly when replacing makes more sense.
- Repairs across Aurora ZIP 60506, 60502, 60505, 60504, 60503
- We find the cause, not just the symptom
- Parts and labor quoted before work starts
Range hood problems we fix in Aurora
A hood that hums but won't spin, a light that stays dark, a fan stuck on one speed or a rattle that gets louder every week: these are everyday repairs. Our Aurora technicians diagnose the hood in place and fix it without tearing out cabinets.
Loud rattling or grinding
We listen to where the noise starts, then tighten, rebalance or replace the wheel, motor mount or damper.
Burning smell when the fan runs
Burning odors from a hood should not be ignored. Overheated motors, scorched wiring and heavy grease are what we look for.
Fan runs but barely pulls air
If the fan spins but smoke still rolls past, we check the filters, the wheel, the duct and the exterior cap before blaming the motor.
Light not working but the fan is
Hood lights fail at the bulb more often than anywhere else, but heat and grease also wear out sockets and switches. We find which it is.
Buttons or touch panel not responding
Unresponsive controls can sometimes be cleared by cutting power for a minute; when they can't, we replace the keypad or board.
Fan and light both dead
Total failure usually means power isn't reaching the controls, or the board that runs everything has failed. We test and find out which.
Fan not working but the light is
Working lights mean the hood has power. A dead fan then points to the switch, the control board, a thermal cutoff or a failed motor.
What the repair visit covers
- Blower wheel serviceGrease-packed or loose blower wheels cleaned, tightened or replaced.
- Switches and control boardsFaulty controls swapped so every speed and setting responds again.
- Lights and socketsWorking lights restored with the correct bulb type or LED part.
- Damper and duct checkBackdraft dampers freed or replaced, the duct and exterior cap checked for blockage.
- Filter replacementBent mesh or baffle filters and spent charcoal filters replaced with matching ones.
- Noise and vibration fixesLoose mounts, filters, wheels and duct connections tightened to stop rattles.
- Final testWe run the hood and check airflow before we leave.
Repair options
Fan motors and blower wheelsShaded-pole and capacitor motors, squirrel-cage and centrifugal wheels.
Switches, keypads and boardsControls range from basic switches to electronic boards with timers.
LightsIncandescent, halogen and LED lamps, sockets and modules.
Under-cabinet and chimney hoodsThe most common hoods we repair, with fans and controls reachable from below.
Island hoods and insertsCeiling-hung and built-in hoods, often with internal or inline blowers.
Kitchens like yours in Aurora: before and after
Problem
Fixed
DetailAn Aurora two-story colonial from the 1990s: before and after
The site: a two-story colonial from the 1990s near Riddle Highlands. What we started with: white appliances and a brass chandelier over the nook. The main complaint was a hood fan that stopped working. The result: the same hood with a new fan motor and working LED lights. Work included lights and sockets, damper and duct check, plus filter replacement.
Before
AfterWarrenville kitchen, two-story colonial from the 1990s: range hood repair
This one is a two-story colonial from the 1990s near Timber Creek. The kitchen as it was: almond appliances and a fluorescent box light in the ceiling. The main complaint was an old hood whose fan finally quit. The result: the same hood with a new fan motor and working LED lights. The job covered blower wheel service, switches and control boards, plus filter replacement.
Range Hood Repair in Warrenville →
Before
AfterBefore and after: a 1990s two-story colonial in Aurora
Finished: the same hood with clean, shining filters.
Residential Kitchen Hood Cleaning in Aurora →
Before
AfterBefore and after: a 1980s two-story in Aurora
What changed: cabinets in white uppers and deep green lowers with unlacquered brass knobs and cup pulls, warm walnut butcher block counters, a green zellige-look tile backsplash, warm oak luxury vinyl plank flooring and recessed lights and under-cabinet LED strips.
Kitchen Remodeling in Aurora →
Before
AfterAn Aurora 1990s two-story colonial: before and after
The same doors sprayed in creamy white uppers and navy lowers, new matte black pulls; counters and floor stayed as they were.
Kitchen Cabinet Painting in Aurora →From diagnosis to fixed
- Describe the problemA photo of the label behind the filter and a short description help us bring the likely parts.
- Diagnosis on siteA technician checks the power, controls, motor and damper.
- Repair or replaceYou get a written estimate for the repair, or a straight recommendation to replace.
- Fix and testWe repair, reassemble and run the hood before leaving.
Range Hood Repair questions from Aurora homeowners
Why won't my range hood fan turn off?
A stuck switch or failed relay on the control board is the usual cause. Some hoods also start the fan automatically when they sense heat.
What bulb does my range hood need?
It depends on the hood. The bulb type and wattage are listed in the manual or near the socket; many newer hoods use LED modules instead of bulbs.
When should I replace a range hood instead of repairing it?
When parts are no longer made, when several major parts have failed at once, or when the hood is too small or recirculating and you want better ventilation.
Do you repair all range hood brands?
We repair hoods from many makers; if parts are unavailable for yours, we'll tell you.
Why do I feel cold air coming from my hood?
A damper stuck open at the hood or the wall cap lets cold air drop into the kitchen. We free or replace it.
Do I need a permit for range hood repair in Aurora?
It depends on the scope. Aurora's rule in short: Interior remodels, structural changes and interior plumbing always need a permit; electrical/mechanical may. We handle the permit when one is needed with Division of Building and Permits, City of Aurora.
Do you work in my part of Aurora?
Yes. Our crews work across Aurora, including Near Eastside, Tanner, Riddle Highlands, Palace Street — ZIP 60506, 60502, 60505, 60504, 60503 — and nearby Batavia, Warrenville, Naperville.
Working in Aurora
- A lot of Aurora kitchens date from the 1990s. We know these layouts well and what is worth keeping.
- Most Aurora homes are single-family. We protect floors and driveways and leave the site clean every day.
- Live in a historic district? Interior kitchen work is usually not reviewed. We check before anything touches the exterior.
Near EastsideTannerRiddle HighlandsPalace StreetWest SideFar East Side
ZIP 60506ZIP 60502ZIP 60505ZIP 60504ZIP 60503
Range Hood Repair nearby
Other kitchen services in Aurora
Range Hood InstallationUnder-cabinet, chimney, island and insert hoods, ducted to the outside.
Residential Kitchen Hood CleaningDegreased filters, fan, hood interior and the duct you can reach.
Kitchen RemodelingFull kitchen remodels, from layout to last cabinet pull.
Kitchen Cabinet PaintingFactory-smooth painted cabinets without replacing them.
Cabinet RefacingNew doors and fronts on your existing cabinet boxes.