Serving Batavia & nearby Geneva, St. Charles

Kitchen Sink Installation & Replacement in Batavia, IL

Undermount, drop-in and farmhouse sinks set, sealed and connected by licensed plumbers in Batavia.

  • Serving Batavia ZIP 60510, 60539
  • Installed level, sealed and tested before we leave
  • Clear price for the install before the visit

Prefer a callback?

Leave your number and a Batavia licensed plumber will call you.

Kitchen sink problems we fix in Batavia

Swapping a sink looks simple until the new bowl doesn't match the cutout or the drain lands in the wrong spot. Our Batavia crew measures first, then sets the sink and has a licensed plumber hook up the drain and supplies.

1990s stainless double sink

The thin stainless double sink from the 1990s dents and drums. A heavier-gauge single or low-divide bowl is a common replacement.

Chipped or stained porcelain sink

Enameled cast iron and porcelain chip down to dark metal and hold stains no cleaner removes. Replacement is the lasting fix.

Sink that drains slowly after replacement

If a new sink gurgles or holds water, the drain geometry is off. We reset the trap and arm so water runs freely.

Drop-in rim that traps grime

A drop-in rim and its yellowing caulk are hard to keep clean. If the counter is stone or quartz, an undermount sink can often replace it.

Strainer or drain leaking

A leak at the drain flange is usually the strainer, not the sink. We replace it, and with a new sink we always fit new strainers.

Wanting a farmhouse sink

Converting to a farmhouse sink means changing the front of the sink base and often the countertop cutout. We plan both before ordering.

Double bowl too small for big pans

Many owners trade a divided sink for one wide basin. We reconfigure the drain for the single outlet and reconnect the disposal.

Dated sink in an otherwise good kitchen

A worn sink in a kitchen you otherwise like is one of the easier updates. We swap the bowl and the faucet without touching the cabinets.

What we hook up and check

  • Shut off and disconnectWater shut off, faucet, disposal and dishwasher lines disconnected.
  • Remove the old sinkOld sealant cut, clips released and the old bowl lifted out.
  • Cabinet changes for farmhouse sinksSink base cut down or replaced, with a support frame for the apron sink.
  • Set and seal the sinkThe bowl mounted level and sealed to the counter.
  • Faucet and accessoriesFaucet, sprayer, soap dispenser or deck plate installed.
  • Disposal and dishwasher hookupDisposal remounted to the new flange and dishwasher drain reconnected.
  • Supply valves and linesWorn shut-off valves replaced and new braided supply lines installed.

Models, parts and fittings

UndermountMounted below a stone or solid-surface counter so you wipe crumbs straight in.
Workstation sinksSinks with built-in rails that hold accessories over the basin.
Enameled cast ironClassic cast iron, often drop-in, that needs a sturdy counter and cabinet.
Granite compositeA dense, matte sink made of stone particles and resin that hides water spots.
Farmhouse (apron-front)A deep bowl with an exposed front that needs a modified or dedicated sink base.

Before and after: kitchens near Batavia

Kitchen Sink Installation & Replacement in a 1980s-1990s two-story colonial / tract house — beforeBefore
Kitchen Sink Installation & Replacement in a 1980s-1990s two-story colonial / tract house — installedInstalled
Kitchen Sink Installation & Replacement in a 1980s-1990s two-story colonial / tract house — detailDetail

Batavia kitchen, 1980s two-story: kitchen sink installation & replacement

The site: a 1980s two-story in Batavia. What we started with: white double sink. The main complaint was a divided sink too narrow for sheet pans. Finished kitchen: a new undermount stainless single-bowl sink with a pull-down faucet. Work included shut off and disconnect, remove the old sink, plus cabinet changes for farmhouse sinks.

Kitchen Sink Installation & Replacement project in Geneva, beforeBefore
Kitchen Sink Installation & Replacement project in Geneva, afterAfter

A Geneva 1990s two-story colonial: before and after

A 1990s two-story colonial in Geneva, a typical kitchen for Geneva. What we started with: white cast-iron double sink. What bothered the owners most: worn enamel and rust spots in the old bowl. Finished kitchen: a new undermount stainless single-bowl sink with a pull-down faucet. Work included remove the old sink, disposal and dishwasher hookup, plus supply valves and lines.

Kitchen Sink Installation & Replacement in Geneva →
Kitchen Sink Installation & Replacement project in West Chicago, beforeBefore
Kitchen Sink Installation & Replacement project in West Chicago, afterAfter

Kitchen Sink Installation & Replacement in a 1990s two-story colonial, West Chicago

This one is a 1990s two-story colonial in West Chicago. What we started with: solid-surface integrated sink. What bothered the owners most: a stained solid-surface bowl. After: a new undermount stainless single-bowl sink with a pull-down faucet. The job covered cabinet changes for farmhouse sinks, faucet and accessories, plus disposal and dishwasher hookup.

Kitchen Sink Installation & Replacement in West Chicago →
Kitchen Remodeling project near Batavia, beforeBefore
Kitchen Remodeling project near Batavia, afterAfter

Batavia kitchen, 1990s two-story colonial: kitchen remodeling

What changed: cabinets in pale sage with unlacquered brass knobs and cup pulls, charcoal concrete-look quartz counters, a terracotta-look square tile backsplash, light oak hardwood flooring and black cage pendants and slim recessed lights.

Kitchen Remodeling in Batavia →
Kitchen Cabinet Painting project near Batavia, beforeBefore
Kitchen Cabinet Painting project near Batavia, afterAfter

Kitchen Cabinet Painting in a 1980s two-story, Batavia

The same doors sprayed in forest green, new satin brass pulls; counters and floor stayed as they were.

Kitchen Cabinet Painting in Batavia →

Install day

  1. Pick the sinkChoose the material and style, or ask us what fits your counter and cabinet.
  2. Measure and planA visit to confirm the fit and the connections before ordering.
  3. Written estimateYou get an itemized estimate for removal, installation and plumbing.
  4. Install and connectThe old sink comes out, the new one is set and a licensed plumber makes the connections.
  5. Cure and testAdhesive and sealant cure, then we run water and check every joint.

Kitchen Sink Installation & Replacement questions from Batavia homeowners

What does a farmhouse sink need?
A cabinet built or modified for the apron, solid support under the bowl and usually a new countertop cutout.
Can you reuse my old faucet and disposal?
If they are in good shape and fit the new sink, yes. Many owners replace the faucet at the same time since it's already off.
What size sink fits my cabinet?
It depends on the base cabinet and the counter cutout. We confirm both on site.
Can a fallen undermount sink be reattached?
Usually yes. We support the sink, clean off old sealant, refasten it with new clips or a support rail and reseal it.
Can I switch from a drop-in to an undermount sink?
On stone or quartz, often yes, if the cutout edge can be polished and the new sink covers the opening. On laminate it generally isn't practical.
Batavia building permit for sink replacement: where do I apply?
Permits go through City of Batavia Community & Economic Development - Building Division, phone 630-454-2700. When your scope needs one, we prepare the application and schedule the inspections.
Batavia water: how does it affect sink replacement?
Batavia's water source: Groundwater: mix of shallow wells (St. Charles Aquifer) and deep wells (Ironton/Galesville Aquifer); deep-well water gets radium removal; reported hardness is About 25 grains per gallon (city FAQ, general average, not tied to a specific report year). We plan fittings and filters around it.
Does Batavia require a licensed plumber for sink replacement?
City adopts the 2014 Illinois Plumbing Code; projects installing new plumbing require a Residential Plumbing Review Sheet. Our plumbing connections are made by licensed plumbers.
Do I need a permit for sink replacement in Batavia?
It depends on the scope. Batavia's rule in short: Building permits are required for all construction; a Residential Alteration handout is available. We handle the permit when one is needed with City of Batavia Community & Economic Development - Building Division.
Do you work in my part of Batavia?
Yes. Our crews work across Batavia — ZIP 60510, 60539 — and nearby Geneva, St. Charles, West Chicago.

Working in Batavia

  • A lot of Batavia kitchens date from the 1990s. We know these layouts well and what is worth keeping.
  • Most Batavia homes are single-family. We protect floors and driveways and leave the site clean every day.
  • Live in the Downtown Historic District? Interior kitchen work is usually not reviewed. We check before anything touches the exterior.

ZIP 60510ZIP 60539

Kitchen Sink Installation & Replacement nearby

Planning a kitchen project in Batavia?

Call us — we'll check your ZIP, answer your questions and book an in-home estimate.

Call now (708) 400-7049
Call (708) 400-7049Callback