Serving Aurora & nearby Batavia, Warrenville

Kitchen Sink Installation & Replacement in Aurora, IL

Undermount, drop-in and farmhouse sinks set, sealed and connected by licensed plumbers in Aurora.

  • Installers working in Aurora ZIP 60506, 60502, 60505, 60504, 60503
  • Hookups by licensed trades where the code calls for it
  • Old unit hauled away on request

Prefer a callback?

Leave your number and a Aurora licensed plumber will call you.

Kitchen sink problems we fix in Aurora

Swapping a sink looks simple until the new bowl doesn't match the cutout or the drain lands in the wrong spot. Our Aurora crew measures first, then sets the sink and has a licensed plumber hook up the drain and supplies.

1990s stainless double sink

If your sink dates from the 1990s, the drain parts usually do too. We replace both at once.

Sink installed with the counter replacement

When counters are replaced, the sink is set to the new tops and our licensed plumber reconnects the drain, faucet and disposal.

Double bowl too small for big pans

Many owners trade a divided sink for one wide basin. We reconfigure the drain for the single outlet and reconnect the disposal.

New sink doesn't match the counter cutout

Before you buy, we check the existing cutout and the cabinet width. That avoids a sink that overhangs, shows gaps or won't drop in.

Undermount sink pulling away from the counter

Undermount sinks hang from the countertop. When the anchors let go, we clean the old sealant off, refasten the bowl and run a fresh bead of silicone.

Strainer or drain leaking

Drips below the drain opening come from a worn basket strainer seal. New strainers bedded in putty or a gasket are part of every sink we set.

Sink cabinet floor wet or swollen

Water damage in the sink base usually comes from the strainer, the trap or a failed undermount seal. We repair the cause along with the sink.

Wanting a farmhouse sink

Converting to a farmhouse sink means changing the front of the sink base and often the countertop cutout. We plan both before ordering.

What we hook up and check

  • Remove the old sinkThe old sink taken out without damaging the counter edge.
  • Prepare the openingCutout cleaned of old caulk and adhesive; enlarged or polished when needed.
  • Cabinet changes for farmhouse sinksCabinet front modified and the sink supported from below.
  • Set and seal the sinkUndermount sinks clipped and bonded; drop-ins bedded in sealant and clamped.
  • Disposal and dishwasher hookupDisposal remounted to the new flange and dishwasher drain reconnected.
  • Supply valves and linesFresh supply connections from the valves to the faucet.
  • Leak check and cleanupBoth bowls filled and drained, every joint checked dry.

Models, parts and fittings

FireclayA smooth, hard-glazed bowl that needs solid support in the cabinet.
Enameled cast ironClassic cast iron, often drop-in, that needs a sturdy counter and cabinet.
Farmhouse (apron-front)Apron sinks sit forward of the cabinets and need support built in.
UndermountMounted below a stone or solid-surface counter so you wipe crumbs straight in.
Stainless steelEasy-care steel; a lower gauge number means thicker metal.

Before and after: kitchens near Aurora

Kitchen Sink Installation & Replacement in a 1980s-1990s two-story colonial / tract house — beforeBefore
Kitchen Sink Installation & Replacement in a 1980s-1990s two-story colonial / tract house — installedInstalled
Kitchen Sink Installation & Replacement in a 1980s-1990s two-story colonial / tract house — detailDetail

Aurora kitchen, two-story colonial from the 1990s: kitchen sink installation & replacement

The site: a two-story colonial from the 1990s in Aurora. The kitchen as it was: white cast-iron double sink. The main complaint was a chipped porcelain sink with stains that wouldn't scrub out. Finished kitchen: a new undermount stainless single-bowl sink with a pull-down faucet. Work included cabinet changes for farmhouse sinks, set and seal the sink, plus leak check and cleanup.

Kitchen Sink Installation & Replacement project in Batavia, beforeBefore
Kitchen Sink Installation & Replacement project in Batavia, afterAfter

A Batavia 1990s two-story colonial: before and after

A 1990s two-story colonial in Batavia, a typical kitchen for Batavia. The kitchen as it was: white double sink. The main complaint was a divided sink too narrow for sheet pans. After: a new undermount stainless single-bowl sink with a pull-down faucet. The job covered prepare the opening, cabinet changes for farmhouse sinks, plus leak check and cleanup.

Kitchen Sink Installation & Replacement in Batavia →
Kitchen Remodeling project near Aurora, beforeBefore
Kitchen Remodeling project near Aurora, afterAfter

Aurora kitchen, 1980s two-story: kitchen remodeling

Cabinets in white uppers and deep green lowers with unlacquered brass knobs and cup pulls, warm walnut butcher block counters, a green zellige-look tile backsplash, warm oak luxury vinyl plank flooring and recessed lights and under-cabinet LED strips.

Kitchen Remodeling in Aurora →
Kitchen Cabinet Painting project near Aurora, beforeBefore
Kitchen Cabinet Painting project near Aurora, afterAfter

Aurora kitchen, two-story colonial from the 1990s: kitchen cabinet painting

The same doors sprayed in creamy white uppers and navy lowers, new matte black pulls; counters and floor stayed as they were.

Kitchen Cabinet Painting in Aurora →

From the old unit to the new one

  1. Pick the sinkChoose the material and style, or ask us what fits your counter and cabinet.
  2. Measure and planA visit to confirm the fit and the connections before ordering.
  3. Written estimateA clear quote listing the sink work, parts and any cabinet modifications.
  4. Install and connectWe mount the sink and hook up the drain, faucet and appliances.
  5. Cure and testAdhesive and sealant cure, then we run water and check every joint.

Kitchen Sink Installation & Replacement questions from Aurora homeowners

Who would you call to install a new sink?
A plumber, or a company like ours that does both the fitting and the plumbing. That way one crew handles the cutout, the mounting and the hookups.
Can a fallen undermount sink be reattached?
Usually yes. We support the sink, clean off old sealant, refasten it with new clips or a support rail and reseal it.
Undermount or drop-in: which is better?
Undermount is easier to clean and looks sleeker, but it needs a stone or solid-surface counter. Drop-in works on any counter and is the simpler swap.
Can I switch from a drop-in to an undermount sink?
With granite or quartz counters, it's possible: the cutout is finished and the sink mounted below. We check the opening size first.
Can you install a sink I bought myself?
Yes. We check that it fits the cutout and the cabinet before install day.
Aurora plumbing code: who can do the plumbing for sink replacement?
Interior plumbing work requires a permit. The City pages do not state plumber licensing rules (Illinois state license applies). Our plumbing connections are made by licensed plumbers.
What is Aurora doing about lead water lines?
About 16,200 lead service lines; City submitted its service line material inventory to Illinois EPA. A filter certified for lead reduction is a sensible step until your line is confirmed or replaced.
Does sink replacement need a Aurora building permit, and who files it?
Permits go through Division of Building and Permits, City of Aurora, phone (630) 256-3130. When your scope needs one, we prepare the application and schedule the inspections.
Aurora contractor registration: do kitchen contractors need it?
Contractors must be registered/licensed with the City (application, required testing if applicable, proof of insurance naming the City as additional insured). Homeowners may act as own contractor if owner-occupied 6+ months with a Homeowner Liability Waiver. We take care of that before work starts.
Aurora water: how does it affect sink replacement?
Aurora's water source: Fox River surface water plus deep and shallow wells (about 60% surface / 40% well, varies); reported hardness is 7 to 8 grains per gallon (120-137 mg/L). We plan fittings and filters around it.
Do I need a permit for sink replacement in Aurora?
It depends on the scope. Aurora's rule in short: Interior remodels, structural changes and interior plumbing always need a permit; electrical/mechanical may. We handle the permit when one is needed with Division of Building and Permits, City of Aurora.
Do you work in my part of Aurora?
Yes. Our crews work across Aurora, including Near Eastside, Tanner, Riddle Highlands, Palace Street — ZIP 60506, 60502, 60505, 60504, 60503 — and nearby Batavia, Warrenville, Naperville.

Working in Aurora

  • A lot of Aurora kitchens date from the 1990s. We know these layouts well and what is worth keeping.
  • Most Aurora homes are single-family. We protect floors and driveways and leave the site clean every day.
  • Live in a historic district? Interior kitchen work is usually not reviewed. We check before anything touches the exterior.

Near EastsideTannerRiddle HighlandsPalace StreetWest SideFar East Side

ZIP 60506ZIP 60502ZIP 60505ZIP 60504ZIP 60503

Kitchen Sink Installation & Replacement nearby

Planning a kitchen project in Aurora?

Call us — we'll check your ZIP, answer your questions and book an in-home estimate.

Call now (708) 400-7049
Call (708) 400-7049Callback