Serving Bartlett & nearby Hanover Park, Carol Stream

Kitchen Faucet Installation in Bartlett, IL

Pull-down, touchless and two-handle kitchen faucets installed leak-free by licensed plumbers in Bartlett.

  • Installers working in Bartlett ZIP 60103, 60120
  • Hookups by licensed trades where the code calls for it
  • Old unit hauled away on request

Prefer a callback?

Leave your number and a Bartlett licensed plumber will call you.

Kitchen faucet problems we fix in Bartlett

Whether you picked a pull-down, a touchless or a bridge faucet, we fit it to your sink or counter in Bartlett, cover or reuse the extra holes, and connect it with new supply lines.

Scale on the aerator from lake water

White crust on the spray face is mineral buildup. Many Bartlett owners just need the aerator cleaned or swapped, not a new faucet.

Faucet loose or wobbling on the sink

Wobbly faucets loosen further over time and start leaking at the deck. A proper re-mount fixes it.

Hole count doesn't match the new faucet

Sinks and counters have one to four holes. A deck plate covers unused holes, or they can hold a soap dispenser, side sprayer or filtered-water tap.

Leaking from the handle

Water seeping out around the handle when the faucet runs is a cartridge or stem seal problem. Some brands make it easy to fix; others are cheaper to replace.

Shut-off valves that won't turn

If the valves under the sink are stuck, we shut the water elsewhere and install new ones before connecting the faucet.

Spout too short or too low

Spout height and reach matter as much as style. We match the faucet to your sink size so water lands in the center of the bowl.

Faucet leaking from the base

Water pooling around the base of the spout usually means worn O-rings inside the swivel. On an older faucet, replacement is often the better call.

Low flow or a sputtering spout

A spout that spits or barely runs usually has debris or mineral buildup in the aerator. If cleaning doesn't help, the cartridge or supply valve may be partly blocked.

What the install includes

  • Check the sink and suppliesA check of the sink holes, shut-offs and clearances so the faucet fits.
  • Shut off and removeThe old faucet and side sprayer taken off without damaging the sink.
  • Replace valves when neededNew shut-off valves if the old ones won't close or weep.
  • Mount the faucetNew faucet mounted level and secure on the sink or counter.
  • Pull-down hose and weightSprayer hose connected and its counterweight placed correctly.
  • Extra holesUnused holes covered or fitted with a soap dispenser or filtered-water tap.
  • Flush and testAerator off, lines flushed of debris, then every joint checked under pressure.

Options to choose from

Filtered-water and pot-filler tapsA small second faucet for filtered water, or a wall-mounted pot filler by the range.
FinishesStainless, chrome, matte black and brass finishes, each with its own care.
Bridge and two-handle faucetsSeparate hot and cold handles on a bridge or widespread base for traditional kitchens.
Pull-out faucetsA shorter spout with a head that pulls straight out toward you.
Deck platesTrim that lets a one-hole faucet sit cleanly on a three-hole sink.

Kitchens like yours in Bartlett: before and after

Kitchen Faucet Installation in a 1980s-1990s two-story colonial / tract house — beforeBefore
Kitchen Faucet Installation in a 1980s-1990s two-story colonial / tract house — installedInstalled
Kitchen Faucet Installation in a 1980s-1990s two-story colonial / tract house — detailDetail

Bartlett kitchen, two-story colonial from the 1990s: kitchen faucet installation

The site: a two-story colonial from the 1990s in Bartlett. What we started with: white double sink. What bothered the owners most: a faucet too low to fill a stockpot. The result: a new single-handle pull-down faucet with a clean caulk line. On site this meant pull-down hose and weight, extra holes, plus flush and test.

Kitchen Faucet Installation project in Hanover Park, beforeBefore
Kitchen Faucet Installation project in Hanover Park, afterAfter

A Hanover Park 1990s two-story colonial: before and after

A 1990s two-story colonial near Ontarioville, a typical kitchen for Hanover Park. The kitchen as it was: solid-surface integrated sink. The main complaint was an old faucet that dripped and was crusted with scale. Finished kitchen: a new single-handle pull-down faucet with a clean caulk line. On site this meant check the sink and supplies, shut off and remove, plus extra holes.

Kitchen Faucet Installation in Hanover Park →
Kitchen Faucet Installation project in Carol Stream, beforeBefore
Kitchen Faucet Installation project in Carol Stream, afterAfter

Before and after: a 1990s two-story colonial in Carol Stream

The site: a 1990s two-story colonial in Carol Stream. Before: white cast-iron double sink. What bothered the owners most: handles that leaked and a sprayer that dribbled. Finished kitchen: a new single-handle pull-down faucet with a clean caulk line. On site this meant check the sink and supplies, replace valves when needed, plus mount the faucet.

Kitchen Faucet Installation in Carol Stream →
Kitchen Plumbing Relocation project near Bartlett, beforeBefore
Kitchen Plumbing Relocation project near Bartlett, afterAfter

Kitchen Plumbing Relocation in a two-story colonial from the 1990s, Bartlett

Finished: a new island with a prep sink, the drain, vent and water lines relocated from the old wall.

Kitchen Plumbing Relocation in Bartlett →
Kitchen Remodeling project near Bartlett, beforeBefore
Kitchen Remodeling project near Bartlett, afterAfter

A Bartlett two-story colonial from the 1990s: before and after

What changed: cabinets in warm taupe with satin brass pulls, warm walnut butcher block counters, a gray beveled subway tile backsplash, light beige 18x18 porcelain tile flooring and recessed lights and under-cabinet LED strips.

Kitchen Remodeling in Bartlett →

Install day

  1. Pick a faucetSend the model you like and a photo of your sink.
  2. Check the setupA quick look under the sink tells us what else the job needs.
  3. Written estimateYou get the price in writing, including any valve replacement.
  4. Install and testThe faucet goes in, a licensed plumber connects it and we test every joint.

Kitchen Faucet Installation questions from Bartlett homeowners

Are touchless faucets worth it?
For people who cook a lot, yes: no greasy handles. They need batteries or power under the sink and a little more upkeep.
Can a handyman install a kitchen faucet?
Our faucet installs are done by licensed plumbers, which matters when a valve or supply line turns out to need replacing.
Pull-down or pull-out: which should I choose?
Pull-down suits deep sinks and tall clearance; pull-out works better under low cabinets or a window.
Can you add a filtered-water faucet?
We install filtered-water faucets alongside the main one, connected to an under-sink filter.
Should I replace the shut-off valves too?
Often yes. A new faucet on old valves is the most common setup for a future leak.
Bartlett contractor registration: do kitchen contractors need it?
All contractors must be licensed by the Village of Bartlett (per trade); licensing questions via Main Office 630-837-0800. We take care of that before work starts.
Bartlett building permit for faucet installation: where do I apply?
Permits go through Building Division (Planning & Development Services), phone 630-540-5920. When your scope needs one, we prepare the application and schedule the inspections.
Is Bartlett water hard, and does it matter for faucet installation?
Bartlett's water source: Lake Michigan water supplied via City of Chicago (surface source). Aerators and cartridges scale faster with harder water.
Does Bartlett have lead service lines?
Village has a Water Inventory page on lead service lines; call Public Works 630-837-0811 to learn pipe material. A filter certified for lead reduction is a sensible step until your line is confirmed or replaced.
Do I need a permit for faucet installation in Bartlett?
It depends on the scope. Bartlett's rule in short: Building permits are required for all construction and home improvement projects, whether done by homeowner or contractor; Remodel is a listed permit type. We handle the permit when one is needed with Building Division (Planning & Development Services).
Do you work in my part of Bartlett?
Yes. Our crews work across Bartlett — ZIP 60103, 60120 — and nearby Hanover Park, Carol Stream, Bloomingdale.

Working in Bartlett

  • A lot of Bartlett kitchens date from the 1990s. We know these layouts well and what is worth keeping.
  • Most Bartlett homes are single-family. We protect floors and driveways and leave the site clean every day.
  • We know how Building Division (Planning & Development Services) handles kitchen permits and pull them for you.

ZIP 60103ZIP 60120

Kitchen Faucet Installation nearby

Planning a kitchen project in Bartlett?

Call us — we'll check your ZIP, answer your questions and book an in-home estimate.

Call now (708) 400-7049
Call (708) 400-7049Callback