Serving Bartlett & nearby Hanover Park, Carol Stream

Kitchen Sink Installation & Replacement in Bartlett, IL

Undermount, drop-in and farmhouse sinks set, sealed and connected by licensed plumbers in Bartlett.

  • Installers working in Bartlett ZIP 60103, 60120
  • Hookups by licensed trades where the code calls for it
  • Old unit hauled away on request

Prefer a callback?

Leave your number and a Bartlett licensed plumber will call you.

Kitchen sink problems we fix in Bartlett

We replace kitchen sinks in Bartlett homes from removal to the last leak check: the old bowl out, the opening prepared, the new undermount, drop-in or farmhouse sink set and every connection under it made new.

1990s stainless double sink

The thin stainless double sink from the 1990s dents and drums. A heavier-gauge single or low-divide bowl is a common replacement.

Wanting a farmhouse sink

Farmhouse sinks are heavy, especially fireclay and cast iron. We frame a support inside the cabinet, trim the face and set the sink level with the counters.

Drop-in rim that traps grime

Grime along the rim of a drop-in sink is a common complaint. Undermount is cleaner, but it needs a solid-surface or stone counter with a finished cutout edge.

Undermount sink pulling away from the counter

A gap between the sink rim and the stone means the clips or adhesive have failed. We take the weight off, remount it with new clips or a support rail and reseal the joint.

Double bowl too small for big pans

If nothing big fits flat in either side, a single-bowl sink solves it. We adjust the trap and tailpiece for the new drain position.

Old drain parts that won't line up

A new sink often puts the drain in a different spot or depth. We rebuild the trap and tailpieces in new PVC so everything lines up without strain.

Sink that drains slowly after replacement

If a new sink gurgles or holds water, the drain geometry is off. We reset the trap and arm so water runs freely.

Sink installed with the counter replacement

New countertops are the best time for a new sink. We coordinate the cutout with the fabricator and do the hookup after install.

Included with the install

  • Measure the cutout and cabinetA check of the cutout, cabinet width and plumbing so the new sink fits.
  • Shut off and disconnectWe close the valves and take apart the drain, supply and appliance connections.
  • Remove the old sinkOld sealant cut, clips released and the old bowl lifted out.
  • Cabinet changes for farmhouse sinksCabinet front modified and the sink supported from below.
  • New strainers and drainNew basket strainers, tailpieces and P-trap assembled to the drain line.
  • Faucet and accessoriesYour old faucet reused or a new one mounted on the sink or counter.
  • Disposal and dishwasher hookupDisposal remounted to the new flange and dishwasher drain reconnected.

Models, parts and fittings

Farmhouse (apron-front)A deep bowl with an exposed front that needs a modified or dedicated sink base.
Granite compositeQuartz or granite composite bowls in solid colors, resistant to scratches.
Stainless steelThe most common kitchen sink: durable, light and quiet when it has sound padding.
Workstation sinksBowls with a ledge for cutting boards, colanders and drying racks.
FireclayA smooth, hard-glazed bowl that needs solid support in the cabinet.

Kitchens like yours in Bartlett: before and after

Kitchen Sink Installation & Replacement in a 1980s-1990s two-story colonial / tract house — beforeBefore
Kitchen Sink Installation & Replacement in a 1980s-1990s two-story colonial / tract house — installedInstalled
Kitchen Sink Installation & Replacement in a 1980s-1990s two-story colonial / tract house — detailDetail

A Bartlett 1990s two-story colonial: before and after

A 1990s two-story colonial in Bartlett, a typical kitchen for Bartlett. Before: white double sink. What bothered the owners most: two small bowls where big pots never fit. The result: a new undermount stainless single-bowl sink with a pull-down faucet. The job covered measure the cutout and cabinet, cabinet changes for farmhouse sinks, plus disposal and dishwasher hookup.

Kitchen Sink Installation & Replacement project in Hanover Park, beforeBefore
Kitchen Sink Installation & Replacement project in Hanover Park, afterAfter

Hanover Park kitchen, two-story colonial from the 1990s: kitchen sink installation & replacement

The site: a two-story colonial from the 1990s near Ontarioville. Before: white cast-iron double sink. The main complaint was a chipped porcelain sink with stains that wouldn't scrub out. Finished kitchen: a new undermount stainless single-bowl sink with a pull-down faucet. Work included measure the cutout and cabinet, remove the old sink, plus cabinet changes for farmhouse sinks.

Kitchen Sink Installation & Replacement in Hanover Park →
Kitchen Sink Installation & Replacement project in Bloomingdale, beforeBefore
Kitchen Sink Installation & Replacement project in Bloomingdale, afterAfter

Bloomingdale kitchen, 1980s two-story: kitchen sink installation & replacement

This one is a 1980s two-story near Old Town Bloomingdale. The kitchen as it was: solid-surface integrated sink. The main complaint was a scratched integrated sink that never looked clean. Finished kitchen: a new undermount stainless single-bowl sink with a pull-down faucet. The job covered remove the old sink, new strainers and drain, plus faucet and accessories.

Kitchen Sink Installation & Replacement in Bloomingdale →
Kitchen Remodeling project near Bartlett, beforeBefore
Kitchen Remodeling project near Bartlett, afterAfter

Bartlett kitchen, 1990s two-story colonial: kitchen remodeling

What changed: cabinets in warm taupe with satin brass pulls, warm walnut butcher block counters, a gray beveled subway tile backsplash, light beige 18x18 porcelain tile flooring and recessed lights and under-cabinet LED strips.

Kitchen Remodeling in Bartlett →
Kitchen Cabinet Painting project near Bartlett, beforeBefore
Kitchen Cabinet Painting project near Bartlett, afterAfter

A Bartlett two-story colonial from the 1990s: before and after

What changed: the same doors sprayed in creamy white uppers and navy lowers, new satin brass pulls; counters and floor stayed as they were.

Kitchen Cabinet Painting in Bartlett →

How the install goes

  1. Pick the sinkChoose the material and style, or ask us what fits your counter and cabinet.
  2. Measure and planWe check the cutout, the cabinet and the drain, and plan any cabinet changes.
  3. Written estimateA clear quote listing the sink work, parts and any cabinet modifications.
  4. Install and connectThe old sink comes out, the new one is set and a licensed plumber makes the connections.
  5. Cure and testAfter the bond sets, the sink is tested in full use.

Kitchen Sink Installation & Replacement questions from Bartlett homeowners

Will Lake Michigan water mark my new sink?
Treated lake water still carries some minerals, so water spots show on dark composite and stainless. Wiping the bowl dry keeps it looking new.
What size sink fits my cabinet?
The sink base width sets the limit. Most kitchen sinks are made for common base sizes, and we measure inside the cabinet before you buy.
What does a farmhouse sink need?
A cabinet built or modified for the apron, solid support under the bowl and usually a new countertop cutout.
Can I switch from a drop-in to an undermount sink?
With granite or quartz counters, it's possible: the cutout is finished and the sink mounted below. We check the opening size first.
What does a new kitchen sink installation cost?
The sink type, the counter, any cabinet changes and how much plumbing is replaced drive the price. We give a written, itemized estimate after the visit.
Is Bartlett water hard, and does it matter for sink replacement?
Bartlett's water source: Lake Michigan water supplied via City of Chicago (surface source). We plan fittings and filters around it.
Does sink replacement need a Bartlett building permit, and who files it?
Permits go through Building Division (Planning & Development Services), phone 630-540-5920. When your scope needs one, we prepare the application and schedule the inspections.
Bartlett contractor registration: do kitchen contractors need it?
All contractors must be licensed by the Village of Bartlett (per trade); licensing questions via Main Office 630-837-0800. We take care of that before work starts.
Does Bartlett have lead service lines?
Village has a Water Inventory page on lead service lines; call Public Works 630-837-0811 to learn pipe material. A filter certified for lead reduction is a sensible step until your line is confirmed or replaced.
Do I need a permit for sink replacement in Bartlett?
It depends on the scope. Bartlett's rule in short: Building permits are required for all construction and home improvement projects, whether done by homeowner or contractor; Remodel is a listed permit type. We handle the permit when one is needed with Building Division (Planning & Development Services).
Do you work in my part of Bartlett?
Yes. Our crews work across Bartlett — ZIP 60103, 60120 — and nearby Hanover Park, Carol Stream, Bloomingdale.

Working in Bartlett

  • A lot of Bartlett kitchens date from the 1990s. We know these layouts well and what is worth keeping.
  • Most Bartlett homes are single-family. We protect floors and driveways and leave the site clean every day.
  • We know how Building Division (Planning & Development Services) handles kitchen permits and pull them for you.

ZIP 60103ZIP 60120

Kitchen Sink Installation & Replacement nearby

Planning a kitchen project in Bartlett?

Call us — we'll check your ZIP, answer your questions and book an in-home estimate.

Call now (708) 400-7049
Call (708) 400-7049Callback