Serving Bloomingdale & nearby Roselle, Glendale Heights

Kitchen Faucet Installation in Bloomingdale, IL

Pull-down, touchless and two-handle kitchen faucets installed leak-free by licensed plumbers in Bloomingdale.

  • Serving Bloomingdale ZIP 60108
  • Installed level, sealed and tested before we leave
  • Clear price for the install before the visit

Prefer a callback?

Leave your number and a Bloomingdale licensed plumber will call you.

Kitchen faucet problems we fix in Bloomingdale

We install kitchen faucets in Bloomingdale: the old one off, seized shut-off valves replaced when needed, the new faucet mounted to fit your sink holes and every supply connection checked under pressure.

Scale on the aerator from lake water

Treated Lake Michigan water still leaves some mineral scale in aerators and spray heads over time. Cleaning them restores the spray pattern.

Hole count doesn't match the new faucet

Sinks and counters have one to four holes. A deck plate covers unused holes, or they can hold a soap dispenser, side sprayer or filtered-water tap.

Old two-handle faucet with a side sprayer

If the side sprayer dribbles and the handles drip, it's time for a new faucet. One-handle pull-downs are the usual replacement.

Drip from the spout that won't stop

Drips that keep going no matter how you set the lever point to the cartridge. It's a repair on a good faucet and a replacement on a tired one.

Pull-down sprayer that won't retract

If the spray head won't dock, the weight on the hose may have slipped or the hose is rubbing on the disposal or drain. We reset it.

Shut-off valves that won't turn

If the valves under the sink are stuck, we shut the water elsewhere and install new ones before connecting the faucet.

Faucet loose or wobbling on the sink

If the faucet turns or tilts when you push the handle, the nut below has backed off. We secure it from inside the cabinet.

Leaking from the handle

Leaks at the lever come from the valve inside the body. We replace the cartridge or the whole faucet, depending on its age.

Included with the install

  • Shut off and removeThe old faucet and side sprayer taken off without damaging the sink.
  • Clean the deckThe sink or counter around the holes cleaned so the new base seals.
  • Replace valves when neededNew shut-off valves if the old ones won't close or weep.
  • Mount the faucetFaucet set with its gasket or deck plate and tightened from below.
  • Pull-down hose and weightSpray hose routed clear of the drain and disposal, weight set so it retracts.
  • Power for touchless modelsSensor faucet wiring and power placed where it can be serviced.
  • Extra holesDeck plate, soap pump or second faucet for any leftover holes.

What to pick before the install

Filtered-water and pot-filler tapsA small second faucet for filtered water, or a wall-mounted pot filler by the range.
Pull-down faucetsHigh spout with a docking spray head for rinsing and filling pots.
Pull-out faucetsGood under low cabinets or windows where a tall spout won't fit.
Bridge and two-handle faucetsThree-hole faucets with a classic look, often with a side sprayer.
Touchless and touch faucetsSensor or tap-to-start faucets that need batteries or an outlet under the sink.

Kitchen Faucet Installation before and after — Bloomingdale homes

Kitchen Faucet Installation in a 1980s-1990s two-story colonial / tract house — beforeBefore
Kitchen Faucet Installation in a 1980s-1990s two-story colonial / tract house — installedInstalled
Kitchen Faucet Installation in a 1980s-1990s two-story colonial / tract house — detailDetail

A Bloomingdale 1980s two-story: before and after

This one is a 1980s two-story near Old Town Bloomingdale. The kitchen as it was: white double sink. The main complaint was a faucet too low to fill a stockpot. Finished kitchen: a new single-handle pull-down faucet with a clean caulk line. Work included shut off and remove, replace valves when needed, plus extra holes.

Kitchen Faucet Installation project in Roselle, beforeBefore
Kitchen Faucet Installation project in Roselle, afterAfter

A Roselle 1990s two-story colonial: before and after

This one is a 1990s two-story colonial in Roselle. The kitchen as it was: solid-surface integrated sink. What bothered the owners most: an old faucet that dripped and was crusted with scale. The result: a new single-handle pull-down faucet with a clean caulk line. On site this meant replace valves when needed, power for touchless models, plus extra holes.

Kitchen Faucet Installation in Roselle →
Kitchen Faucet Installation project in Carol Stream, beforeBefore
Kitchen Faucet Installation project in Carol Stream, afterAfter

Carol Stream kitchen, two-story colonial from the 1990s: kitchen faucet installation

This one is a two-story colonial from the 1990s in Carol Stream. What we started with: white cast-iron double sink. The main complaint was an old two-handle faucet that dripped into a worn porcelain bowl. Finished kitchen: a new single-handle pull-down faucet with a clean caulk line. The job covered clean the deck, replace valves when needed, plus mount the faucet.

Kitchen Faucet Installation in Carol Stream →
Kitchen Plumbing Relocation project near Bloomingdale, beforeBefore
Kitchen Plumbing Relocation project near Bloomingdale, afterAfter

Kitchen Plumbing Relocation in a two-story colonial from the 1990s, Bloomingdale

What changed: a new island with a prep sink, the drain, vent and water lines relocated from the old wall.

Kitchen Plumbing Relocation in Bloomingdale →
Kitchen Remodeling project near Bloomingdale, beforeBefore
Kitchen Remodeling project near Bloomingdale, afterAfter

Kitchen Remodeling in a two-story colonial from the 1990s, Bloomingdale

What changed: cabinets in pale sage with unlacquered brass knobs and cup pulls, charcoal concrete-look quartz counters, a terracotta-look square tile backsplash, light oak hardwood flooring and black cage pendants and slim recessed lights.

Kitchen Remodeling in Bloomingdale →

How the install goes

  1. Pick a faucetSend the model you like and a photo of your sink.
  2. Check the setupA quick look under the sink tells us what else the job needs.
  3. Written estimateYou get the price in writing, including any valve replacement.
  4. Install and testThe faucet goes in, a licensed plumber connects it and we test every joint.

Kitchen Faucet Installation questions from Bloomingdale homeowners

Repair or replace a dripping faucet?
If the faucet is fairly new and parts are available, repair. If it's old, corroded or leaking in several places, replace.
Can you install a faucet I already bought?
Of course. Have it on site, and we'll fit it with new supply lines.
Can a handyman install a kitchen faucet?
Illinois requires plumbing work to be done by licensed plumbers. We send a licensed plumber, so the valves and connections are covered too.
Can you add a filtered-water faucet?
Yes. A separate filtered tap can use an existing hole or a new one, with the filter mounted under the sink.
Do I need a plumber to install a faucet?
We recommend it, especially when the shut-off valves are old or the faucet needs a new hole. A licensed plumber makes the connections on every faucet we install.
Does faucet installation need a Bloomingdale building permit, and who files it?
Permits go through Building & Zoning Department, phone (630) 671-5660. When your scope needs one, we prepare the application and schedule the inspections.
Bloomingdale contractor registration: do kitchen contractors need it?
No registration application or fee to work as a contractor in Bloomingdale. Permit submittals need a detailed written scope of work. We take care of that before work starts.
What is Bloomingdale doing about lead water lines?
Village has a service line material inventory (available from Public Works, 630-671-5800). A filter certified for lead reduction is a sensible step until your line is confirmed or replaced.
Is Bloomingdale water hard, and does it matter for faucet installation?
Bloomingdale's water source: Purchased from DuPage Water Commission; Lake Michigan water supplied via City of Chicago. Aerators and cartridges scale faster with harder water.
Bloomingdale plumbing code: who can do the plumbing for faucet installation?
Plumbing license required depending on permit type, and a Letter of Intent is required for all plumbing work. Our plumbing connections are made by licensed plumbers.
Do you work in my part of Bloomingdale?
Yes. Our crews work across Bloomingdale, including Old Town Bloomingdale — ZIP 60108 — and nearby Roselle, Glendale Heights, Carol Stream.

Working in Bloomingdale

  • A lot of Bloomingdale kitchens date from the 1970s. We know these layouts well and what is worth keeping.
  • Most Bloomingdale homes are single-family. We protect floors and driveways and leave the site clean every day.

Old Town Bloomingdale

ZIP 60108

Kitchen Faucet Installation nearby

Planning a kitchen project in Bloomingdale?

Call us — we'll check your ZIP, answer your questions and book an in-home estimate.

Call now (708) 400-7049
Call (708) 400-7049Callback