Serving Wood Dale & nearby Itasca, Elk Grove Village

Kitchen Faucet Installation in Wood Dale, IL

Pull-down, touchless and two-handle kitchen faucets installed leak-free by licensed plumbers in Wood Dale.

  • Installers working in Wood Dale ZIP 60191
  • Hookups by licensed trades where the code calls for it
  • Old unit hauled away on request

Prefer a callback?

Leave your number and a Wood Dale licensed plumber will call you.

Kitchen faucet problems we fix in Wood Dale

Whether you picked a pull-down, a touchless or a bridge faucet, we fit it to your sink or counter in Wood Dale, cover or reuse the extra holes, and connect it with new supply lines.

Scale on the aerator from lake water

White crust on the spray face is mineral buildup. Many Wood Dale owners just need the aerator cleaned or swapped, not a new faucet.

Hole count doesn't match the new faucet

A single-hole faucet on a three-hole sink needs a deck plate. A widespread faucet needs three holes, which we can drill in stone counters.

Pull-down sprayer that won't retract

Sprayer heads that droop often need the weight moved or a worn hose replaced. It's a quick fix.

Drip from the spout that won't stop

If the spout drips day and night, the seal inside the valve has worn. We repair it or put in a new faucet.

Spout too short or too low

A low spout makes it hard to fill stockpots and leaves water splashing at the back. A high-arc or pull-down faucet gives more room.

Wanting a touchless faucet

A touchless kitchen faucet is a standard install with one extra piece: the control box and its power supply. We fit both.

Old two-handle faucet with a side sprayer

Many owners replace the old two-handle setup with a single lever and a pull-down spray. We cover the leftover holes with a deck plate.

Shut-off valves that won't turn

If the valves under the sink are stuck, we shut the water elsewhere and install new ones before connecting the faucet.

Included with the install

  • Check the sink and suppliesA check of the sink holes, shut-offs and clearances so the faucet fits.
  • Shut off and removeThe old faucet and side sprayer taken off without damaging the sink.
  • Clean the deckThe sink or counter around the holes cleaned so the new base seals.
  • Replace valves when neededNew shut-off valves if the old ones won't close or weep.
  • Supply connectionsHot and cold lines hooked up to the valves.
  • Power for touchless modelsControl box mounted and battery pack or plug-in adapter set up.
  • Flush and testWe run hot and cold, test the sprayer and look for drips below.

What to pick before the install

Pull-down faucetsHigh spout with a docking spray head for rinsing and filling pots.
Bridge and two-handle faucetsSeparate hot and cold handles on a bridge or widespread base for traditional kitchens.
Filtered-water and pot-filler tapsExtra taps that use a spare hole or a separate supply line.
Pull-out faucetsGood under low cabinets or windows where a tall spout won't fit.
FinishesStainless, chrome, matte black and brass finishes, each with its own care.

What the work looks like in Wood Dale homes

Kitchen Faucet Installation in a 1980s-1990s two-story colonial / tract house — beforeBefore
Kitchen Faucet Installation in a 1980s-1990s two-story colonial / tract house — installedInstalled
Kitchen Faucet Installation in a 1980s-1990s two-story colonial / tract house — detailDetail

Before and after: a two-story colonial from the 1990s in Wood Dale

This one is a two-story colonial from the 1990s in Wood Dale. Before: solid-surface integrated sink. What bothered the owners most: an old faucet that dripped and was crusted with scale. The result: a new single-handle pull-down faucet with a clean caulk line. On site this meant check the sink and supplies, clean the deck, plus supply connections.

Kitchen Faucet Installation project in Itasca, beforeBefore
Kitchen Faucet Installation project in Itasca, afterAfter

An Itasca 1980s two-story: before and after

This one is a 1980s two-story near Walnut Street downtown. The kitchen as it was: white double sink. The main complaint was a faucet too low to fill a stockpot. The result: a new single-handle pull-down faucet with a clean caulk line. On site this meant shut off and remove, replace valves when needed, plus flush and test.

Kitchen Faucet Installation in Itasca →
Kitchen Faucet Installation project in Addison, beforeBefore
Kitchen Faucet Installation project in Addison, afterAfter

An Addison two-story colonial from the 1990s: before and after

This one is a two-story colonial from the 1990s in Addison. The kitchen as it was: white cast-iron double sink. The main complaint was handles that leaked and a sprayer that dribbled. After: a new single-handle pull-down faucet with a clean caulk line. Work included check the sink and supplies, shut off and remove, plus clean the deck.

Kitchen Faucet Installation in Addison →
Kitchen Plumbing Relocation project near Wood Dale, beforeBefore
Kitchen Plumbing Relocation project near Wood Dale, afterAfter

A Wood Dale postwar bi-level: before and after

A new island with a prep sink, the drain, vent and water lines relocated from the old wall.

Kitchen Plumbing Relocation in Wood Dale →
Kitchen Remodeling project near Wood Dale, beforeBefore
Kitchen Remodeling project near Wood Dale, afterAfter

A Wood Dale 1950s ranch: before and after

Cabinets in soft white with unlacquered brass knobs and cup pulls, warm walnut butcher block counters, a blue handmade-look tile backsplash, warm oak luxury vinyl plank flooring and recessed lights and under-cabinet LED strips.

Kitchen Remodeling in Wood Dale →

How the install goes

  1. Pick a faucetChoose one yourself or ask us what fits your sink and holes.
  2. Check the setupA quick look under the sink tells us what else the job needs.
  3. Written estimateAn itemized quote for the install and parts before we start.
  4. Install and testInstalled, flushed and checked for leaks, usually in one visit.

Kitchen Faucet Installation questions from Wood Dale homeowners

What does a faucet installation cost?
A plain swap costs less than a touchless install with new valves. You get a line-item price before work starts.
Do I need a plumber to install a faucet?
In Illinois, plumbing is done by plumbers licensed by the Illinois Department of Public Health. Our licensed plumbers install and connect your faucet.
Repair or replace a dripping faucet?
We look at the brand, age and condition and tell you which costs less over time.
Can a handyman install a kitchen faucet?
Illinois requires plumbing work to be done by licensed plumbers. We send a licensed plumber, so the valves and connections are covered too.
Can you install a faucet I already bought?
Of course. Have it on site, and we'll fit it with new supply lines.
Wood Dale water: how does it affect faucet installation?
Wood Dale's water source: Lake Michigan water purchased from the DuPage Water Commission (since 1992). Aerators and cartridges scale faster with harder water.
Wood Dale plumbing code: who can do the plumbing for faucet installation?
Plumbing contractors must register with the City and provide current State license/IDPH registration if applicable; city adopts the Illinois Plumbing Code 2014 with local amendments. Our plumbing connections are made by licensed plumbers.
Wood Dale contractor registration: do kitchen contractors need it?
All contractors (general, HVAC, electrical, plumbing, roofing, etc.) must register with the City before a permit is issued. Requires Certificate of Insurance ($2,000,000 public liability) naming the City, state license/IDPH registration if applicable. We take care of that before work starts.
What is the Wood Dale building department phone number?
Permits go through Community Development Department (https://my.wooddale.com), phone 630-766-5133. When your scope needs one, we prepare the application and schedule the inspections.
Do I need a permit for faucet installation in Wood Dale?
It depends on the scope. Wood Dale's rule in short: A permit is required for any alteration or repair of a building. We handle the permit when one is needed with Community Development Department.
Do you work in my part of Wood Dale?
Yes. Our crews work across Wood Dale — ZIP 60191 — and nearby Itasca, Elk Grove Village, Addison.

Working in Wood Dale

  • A lot of Wood Dale kitchens date from the 1960s. We know these layouts well and what is worth keeping.
  • Most Wood Dale homes are single-family. We protect floors and driveways and leave the site clean every day.
  • We know how Community Development Department handles kitchen permits and pull them for you.

ZIP 60191

Kitchen Faucet Installation nearby

Planning a kitchen project in Wood Dale?

Call us — we'll check your ZIP, answer your questions and book an in-home estimate.

Call now (708) 400-7049
Call (708) 400-7049Callback