Hood that hums but won't spin
When you hear the motor trying but nothing turns, we check the capacitor where there is one and whether the shaft turns freely.
Serving Hanover Park & nearby Bartlett, Roselle
Range Hood Repair in Hanover Park, IL
Fan dead, lights out or a hood that rattles and roars? We repair range hoods in Hanover Park and tell you plainly when replacing makes more sense.
- Repairs across Hanover Park ZIP 60133
- We find the cause, not just the symptom
- Parts and labor quoted before work starts
Range hood problems we fix in Hanover Park
Before you buy a new hood, it is worth knowing what actually broke. We look at the motor, the controls, the wiring and the duct behind the hood in Hanover Park kitchens, then give you a straight answer on repair versus replacement.
Backdraft damper stuck open or shut
Dampers at the hood or the wall cap get gummed up with grease. We clean or replace them so they open with the fan and close after.
Fan runs but barely pulls air
Weak suction is often clogged filters, a grease-packed blower wheel or a damper that no longer opens. The motor itself may be fine.
Loud rattling or grinding
We listen to where the noise starts, then tighten, rebalance or replace the wheel, motor mount or damper.
Light not working but the fan is
A dark light with a working fan is usually a bulb, a socket or the light switch. We swap the bulb type the hood calls for or replace the socket.
Dripping grease or water from the hood
We trace drips back to filters, the duct or the roof jack, then clean, seal or replace whatever is letting it through.
Fan stuck on one speed
If the hood only runs on high, or only on low, the speed switch or the control board has usually failed. We replace the part for your model.
Buttons or touch panel not responding
Unresponsive controls can sometimes be cleared by cutting power for a minute; when they can't, we replace the keypad or board.
Where we look first
- DiagnosisWe test power, switches, controls, motor and lights to find the failed part.
- Blower wheel serviceGrease-packed or loose blower wheels cleaned, tightened or replaced.
- Switches and control boardsRocker switches, speed controls, keypads and boards replaced as needed.
- Lights and socketsWorking lights restored with the correct bulb type or LED part.
- Damper and duct checkBackdraft dampers freed or replaced, the duct and exterior cap checked for blockage.
- Filter replacementBent mesh or baffle filters and spent charcoal filters replaced with matching ones.
- Final testEvery speed, light and button tested with the hood reassembled.
Parts we replace
FiltersMetal filters catch grease; charcoal filters treat odor in ductless setups.
Switches, keypads and boardsControls range from basic switches to electronic boards with timers.
Fan motors and blower wheelsThe parts that move air, and the ones most often worn out.
Island hoods and insertsInserts inside custom covers, serviced through the filter opening.
Under-cabinet and chimney hoodsThe most common hoods we repair, with fans and controls reachable from below.
Range Hood Repair before and after — Hanover Park homes
Problem
Fixed
DetailHanover Park kitchen, two-story colonial from the 1990s: range hood repair
The site: a two-story colonial from the 1990s near Ontarioville. What we started with: black appliances and two hanging glass pendants. The main complaint was a loud, rattling range hood. Finished kitchen: the same hood with a new fan motor and working LED lights. On site this meant diagnosis, blower wheel service, plus damper and duct check.
Before
AfterBefore and after: a two-story colonial from the 1990s in Bartlett
The site: a two-story colonial from the 1990s in Bartlett. Before: almond appliances and a fluorescent box light in the ceiling. What bothered the owners most: an old hood whose fan finally quit. After: the same hood with a new fan motor and working LED lights. Work included blower wheel service, lights and sockets, plus final test.
Range Hood Repair in Bartlett →
Before
AfterBefore and after: a 1990s two-story colonial in Roselle
A 1990s two-story colonial in Roselle, a typical kitchen for Roselle. Before: white appliances and a brass chandelier over the nook. What bothered the owners most: a hood fan that stopped working. After: the same hood with a new fan motor and working LED lights. Work included blower wheel service, switches and control boards, plus lights and sockets.
Range Hood Repair in Roselle →
Before
AfterHanover Park kitchen, two-story colonial from the 1990s: residential kitchen hood cleaning
The same hood with clean, shining filters.
Residential Kitchen Hood Cleaning in Hanover Park →
Before
AfterBefore and after: a 1970s tract home in Hanover Park
Cabinets in white uppers and dusty blue lowers with satin brass pulls, white quartz with soft gray veining counters, a white 2x8 tile in a vertical stack backsplash, hickory luxury vinyl plank flooring and a flush drum fixture and under-cabinet lights.
Kitchen Remodeling in Hanover Park →The repair visit
- Describe the problemTell us what the hood does or doesn't do, and send the brand and model from the label inside.
- Diagnosis on siteA technician checks the power, controls, motor and damper.
- Repair or replaceYou get a written estimate for the repair, or a straight recommendation to replace.
- Fix and testWe repair, reassemble and run the hood before leaving.
Range Hood Repair questions from Hanover Park homeowners
What bulb does my range hood need?
Check the old bulb or the label for the base and wattage. Using the wrong bulb can overheat the socket.
Can a range hood be repaired?
Yes, most hoods can be fixed. We check part availability before recommending the repair.
Why does my range hood fan not work but the light does?
Because the light and fan run on separate circuits inside the hood. A failed fan switch, speed control, thermal cutoff or motor is usually behind it.
Why won't my range hood fan turn off?
Most often the switch or the board is stuck closed. We replace the faulty part.
Why does my range hood have weak suction?
Weak airflow is usually a blockage, not a weak motor. We find where the air is being held up.
Do you work in my part of Hanover Park?
Yes. Our crews work across Hanover Park, including Ontarioville — ZIP 60133 — and nearby Bartlett, Roselle, Bloomingdale.
Working in Hanover Park
- A lot of Hanover Park kitchens date from the 1970s. We know these layouts well and what is worth keeping.
- Most Hanover Park homes are single-family. We protect floors and driveways and leave the site clean every day.
- Live in a historic district? Interior kitchen work is usually not reviewed. We check before anything touches the exterior.
Ontarioville
ZIP 60133
Range Hood Repair nearby
Other kitchen services in Hanover Park
Range Hood InstallationUnder-cabinet, chimney, island and insert hoods, ducted to the outside.
Residential Kitchen Hood CleaningDegreased filters, fan, hood interior and the duct you can reach.
Kitchen RemodelingFull kitchen remodels, from layout to last cabinet pull.
Kitchen Cabinet PaintingFactory-smooth painted cabinets without replacing them.
Cabinet RefacingNew doors and fronts on your existing cabinet boxes.