Older hood with hard-to-find parts
Vintage hoods can often be kept running with generic motors and switches if they fit. If nothing fits, we'll say so.
Serving Evanston & nearby Skokie, Glenview
Range Hood Repair in Evanston, IL
Fan dead, lights out or a hood that rattles and roars? We repair range hoods in Evanston and tell you plainly when replacing makes more sense.
- Technicians covering Evanston ZIP 60201, 60202, 60208
- Diagnosis first, then a written price for the repair
- Honest advice when replacing makes more sense
Range hood problems we fix in Evanston
Most range hood failures come down to a handful of parts: the fan motor, the blower wheel, the switch or control board, the lights and the backdraft damper. In Evanston we find which one has quit, replace it with the right part and make sure the hood pulls air again.
Hood repair in a Evanston condo
Many condo hoods are ductless or tied into a shared vent. We repair the hood in your unit and point out anything that belongs to the building.
Light not working but the fan is
Hood lights fail at the bulb more often than anywhere else, but heat and grease also wear out sockets and switches. We find which it is.
Backdraft damper stuck open or shut
Dampers at the hood or the wall cap get gummed up with grease. We clean or replace them so they open with the fan and close after.
Fan not working but the light is
Working lights mean the hood has power. A dead fan then points to the switch, the control board, a thermal cutoff or a failed motor.
Buttons or touch panel not responding
When some buttons work and others don't, the keypad membrane is often worn. A full lockup is more often the control board.
Hood that hums but won't spin
Humming without spinning is a classic sign the motor is getting power but can't start. Often a new motor is the fix.
Fan and light both dead
Total failure usually means power isn't reaching the controls, or the board that runs everything has failed. We test and find out which.
What the repair visit covers
- DiagnosisWe test power, switches, controls, motor and lights to find the failed part.
- Fan motor replacementWorn or seized motors replaced with a motor matched to the hood.
- Blower wheel serviceThe wheel removed, degreased and balanced, or swapped for a new one.
- Switches and control boardsRocker switches, speed controls, keypads and boards replaced as needed.
- Damper and duct checkWe confirm air can leave the house and the damper closes when the fan stops.
- Filter replacementNew grease or charcoal filters fitted when the old ones are worn out.
- Final testEvery speed, light and button tested with the hood reassembled.
Repair options
Island hoods and insertsInserts inside custom covers, serviced through the filter opening.
Switches, keypads and boardsControls range from basic switches to electronic boards with timers.
LightsOlder halogen bulbs or newer LED strips, depending on the hood.
Fan motors and blower wheelsThe parts that move air, and the ones most often worn out.
Under-cabinet and chimney hoodsThe most common hoods we repair, with fans and controls reachable from below.
What the work looks like in Evanston homes
Problem
Fixed
DetailEvanston kitchen, brick bungalow from the 1920s: range hood repair
The site: a brick bungalow from the 1920s in Evanston. What we started with: a white range and a white refrigerator and a single pendant bowl light. The main complaint was a hood fan that stopped working. After: the same hood with a new fan motor and working LED lights. On site this meant blower wheel service, switches and control boards, plus final test.
Before
AfterSkokie kitchen, 1980s two-story: range hood repair
The site: a 1980s two-story in Skokie. Before: black appliances and two hanging glass pendants. What bothered the owners most: a loud, rattling range hood. Finished kitchen: the same hood with a new fan motor and working LED lights. Work included fan motor replacement, blower wheel service, plus damper and duct check.
Range Hood Repair in Skokie →
Before
AfterBefore and after: a 1990s two-story colonial in Glenview
This one is a 1990s two-story colonial near The Park. The kitchen as it was: almond appliances and a fluorescent box light in the ceiling. The reason for the call: a hood that rattled every time it ran. The result: the same hood with a new fan motor and working LED lights. The job covered fan motor replacement, damper and duct check, plus filter replacement.
Range Hood Repair in Glenview →
Before
AfterBefore and after: a brick bungalow from the 1920s in Evanston
What changed: the same hood with clean, shining filters.
Residential Kitchen Hood Cleaning in Evanston →
Before
AfterEvanston kitchen, brick bungalow from the 1920s: kitchen remodeling
Finished: soft sage-green inset-style cabinets with unlacquered brass hardware, honed white marble-look quartz counters, a white handmade-look square tile backsplash, restored oak strip floor and schoolhouse pendant lights.
Kitchen Remodeling in Evanston →How the repair goes
- Describe the problemTell us what the hood does or doesn't do, and send the brand and model from the label inside.
- Diagnosis on siteWe test the hood in place and find the failed part.
- Repair or replaceYou get a written estimate for the repair, or a straight recommendation to replace.
- Fix and testThe part is replaced and the hood tested on every speed and light.
Range Hood Repair questions from Evanston homeowners
Is a noisy range hood worth repairing?
It depends on the cause. Rattles are cheap to fix; a failing motor on an older hood may tip the decision toward replacement.
What bulb does my range hood need?
It depends on the hood. The bulb type and wattage are listed in the manual or near the socket; many newer hoods use LED modules instead of bulbs.
Why does my range hood fan not work but the light does?
The hood has power, so the problem is in the fan side: switch, board or motor. We test them in order.
Can you replace just the fan motor?
In most hoods, yes. We bring or order the motor for your model.
Why does my range hood have weak suction?
Weak airflow is usually a blockage, not a weak motor. We find where the air is being held up.
Can you do range hood repair in an Evanston condo?
Associations usually set rules for work hours, elevators, deliveries and insurance, and many require approval for plumbing, electrical or structural changes. We provide the certificate of insurance and follow the building's rules.
Do I need a permit for range hood repair in Evanston?
It depends on the scope. Evanston's rule in short: Residential permit applications go through the Citizen Portal; City worksheets signed by the contractors are required for any electrical, plumbing or HVAC work. We handle the permit when one is needed with Community Development Department, Building & Development Services (Building & Inspection Services).
Do you work in my part of Evanston?
Yes. Our crews work across Evanston — ZIP 60201, 60202, 60208 — and nearby Skokie, Glenview, Park Ridge.
Working in Evanston
- Most Evanston homes are prewar. We work around plaster walls, radiators and out-of-square rooms every week.
- Condo or townhome? We follow association rules on work hours and elevators and bring the insurance certificate your board asks for.
- Live in a historic district? Interior kitchen work is usually not reviewed. We check before anything touches the exterior.
ZIP 60201ZIP 60202ZIP 60208
Range Hood Repair nearby
Other kitchen services in Evanston
Range Hood InstallationUnder-cabinet, chimney, island and insert hoods, ducted to the outside.
Residential Kitchen Hood CleaningDegreased filters, fan, hood interior and the duct you can reach.
Kitchen RemodelingFull kitchen remodels, from layout to last cabinet pull.
Kitchen Cabinet PaintingFactory-smooth painted cabinets without replacing them.
Cabinet RefacingNew doors and fronts on your existing cabinet boxes.