Serving Elgin & nearby St. Charles, Bartlett

Kitchen Faucet Installation in Elgin, IL

Pull-down, touchless and two-handle kitchen faucets installed leak-free by licensed plumbers in Elgin.

  • Installers working in Elgin ZIP 60123, 60124, 60120, 60140
  • Hookups by licensed trades where the code calls for it
  • Old unit hauled away on request

Prefer a callback?

Leave your number and a Elgin licensed plumber will call you.

Kitchen faucet problems we fix in Elgin

A kitchen faucet swap is quick when the valves turn, the holes match and the old nuts come loose. In Elgin our licensed plumbers handle the cases where they don't, and leave you with a faucet that doesn't drip at the base.

Leaking from the handle

Water seeping out around the handle when the faucet runs is a cartridge or stem seal problem. Some brands make it easy to fix; others are cheaper to replace.

Faucet leaking from the base

Water pooling around the base of the spout usually means worn O-rings inside the swivel. On an older faucet, replacement is often the better call.

Drip from the spout that won't stop

Drips that keep going no matter how you set the lever point to the cartridge. It's a repair on a good faucet and a replacement on a tired one.

Old two-handle faucet with a side sprayer

If the side sprayer dribbles and the handles drip, it's time for a new faucet. One-handle pull-downs are the usual replacement.

Pull-down sprayer that won't retract

If the spray head won't dock, the weight on the hose may have slipped or the hose is rubbing on the disposal or drain. We reset it.

Wanting a touchless faucet

A touchless kitchen faucet is a standard install with one extra piece: the control box and its power supply. We fit both.

Shut-off valves that won't turn

Seized stops are the most common surprise on a faucet job. New quarter-turn valves make the next repair easy.

Faucet loose or wobbling on the sink

If the faucet turns or tilts when you push the handle, the nut below has backed off. We secure it from inside the cabinet.

What the install includes

  • Check the sink and suppliesWe look at the hole layout, the valves and the space under the sink before you choose.
  • Shut off and removeThe old faucet and side sprayer taken off without damaging the sink.
  • Replace valves when neededSeized or leaking stops replaced with quarter-turn valves.
  • Pull-down hose and weightSprayer hose connected and its counterweight placed correctly.
  • Supply connectionsHot and cold lines hooked up to the valves.
  • Power for touchless modelsSensor faucet wiring and power placed where it can be serviced.
  • Extra holesDeck plate, soap pump or second faucet for any leftover holes.

Models, parts and fittings

Filtered-water and pot-filler tapsExtra taps that use a spare hole or a separate supply line.
Deck platesA cover plate that hides extra holes under a single-hole faucet.
FinishesChrome wipes clean easily; matte and brushed finishes hide spots.
Pull-down faucetsHigh spout with a docking spray head for rinsing and filling pots.
Bridge and two-handle faucetsSeparate hot and cold handles on a bridge or widespread base for traditional kitchens.

Before and after: kitchens near Elgin

Kitchen Faucet Installation in a 1980s-1990s two-story colonial / tract house — beforeBefore
Kitchen Faucet Installation in a 1980s-1990s two-story colonial / tract house — installedInstalled
Kitchen Faucet Installation in a 1980s-1990s two-story colonial / tract house — detailDetail

An Elgin 1980s two-story: before and after

A 1980s two-story in Elgin, a typical kitchen for Elgin. Before: white cast-iron double sink. The main complaint was an old two-handle faucet that dripped into a worn porcelain bowl. Finished kitchen: a new single-handle pull-down faucet with a clean caulk line. The job covered shut off and remove, pull-down hose and weight, plus supply connections.

Kitchen Faucet Installation project in St. Charles, beforeBefore
Kitchen Faucet Installation project in St. Charles, afterAfter

St. Charles kitchen, two-story colonial from the 1990s: kitchen faucet installation

A two-story colonial from the 1990s in St. Charles, a typical kitchen for St. Charles. Before: white double sink. What bothered the owners most: a leaking two-handle faucet with a side sprayer. The result: a new single-handle pull-down faucet with a clean caulk line. On site this meant replace valves when needed, pull-down hose and weight, plus extra holes.

Kitchen Faucet Installation in St. Charles →
Kitchen Faucet Installation project in Hanover Park, beforeBefore
Kitchen Faucet Installation project in Hanover Park, afterAfter

Kitchen Faucet Installation in a 1990s two-story colonial, Hanover Park

This one is a 1990s two-story colonial near Ontarioville. Before: solid-surface integrated sink. What bothered the owners most: a leaking faucet with handles that were hard to turn. Finished kitchen: a new single-handle pull-down faucet with a clean caulk line. On site this meant replace valves when needed, pull-down hose and weight, plus supply connections.

Kitchen Faucet Installation in Hanover Park →
Kitchen Plumbing Relocation project near Elgin, beforeBefore
Kitchen Plumbing Relocation project near Elgin, afterAfter

Before and after: a 1990s two-story colonial in Elgin

What changed: a new island with a prep sink, the drain, vent and water lines relocated from the old wall.

Kitchen Plumbing Relocation in Elgin →
Kitchen Remodeling project near Elgin, beforeBefore
Kitchen Remodeling project near Elgin, afterAfter

Kitchen Remodeling in a 1980s two-story, Elgin

What changed: cabinets in white uppers and deep green lowers with unlacquered brass knobs and cup pulls, warm walnut butcher block counters, a green zellige-look tile backsplash, warm oak luxury vinyl plank flooring and recessed lights and under-cabinet LED strips.

Kitchen Remodeling in Elgin →

How the install goes

  1. Pick a faucetSend the model you like and a photo of your sink.
  2. Check the setupWe confirm the hole count, valves and clearances.
  3. Written estimateYou get the price in writing, including any valve replacement.
  4. Install and testInstalled, flushed and checked for leaks, usually in one visit.

Kitchen Faucet Installation questions from Elgin homeowners

Do I need a plumber to install a faucet?
We recommend it, especially when the shut-off valves are old or the faucet needs a new hole. A licensed plumber makes the connections on every faucet we install.
My new faucet doesn't fit my sink holes. What now?
We cover leftover holes or use them for a soap dispenser or filter tap, and drill stone when needed.
Should I replace the shut-off valves too?
If they are old multi-turn valves or won't close fully, yes. It's easiest while the faucet is already off.
Are touchless faucets worth it?
For people who cook a lot, yes: no greasy handles. They need batteries or power under the sink and a little more upkeep.
Can a handyman install a kitchen faucet?
Our faucet installs are done by licensed plumbers, which matters when a valve or supply line turns out to need replacing.
Elgin plumbing code: who can do the plumbing for faucet installation?
Plumbing contractors need a current Illinois 055 license and notarized letter of intent; plumber must be present at inspection with 058 license. Our plumbing connections are made by licensed plumbers.
Elgin water: how does it affect faucet installation?
Elgin's water source: Fox River. Aerators and cartridges scale faster with harder water.
Elgin building permit for faucet installation: where do I apply?
Permits go through Community Development Department (Building permits), City of Elgin, 150 Dexter Court, phone 847-931-6001. When your scope needs one, we prepare the application and schedule the inspections.
Elgin contractor registration: do kitchen contractors need it?
City requires a notarized letter of intent from all licensed contractors; general contractors submit one for each licensed subcontractor. We take care of that before work starts.
Do I need a permit for faucet installation in Elgin?
It depends on the scope. Elgin's rule in short: No kitchen-specific rule; interior remodeling (including kitchens) uses the general Remodeling Permit Application. We handle the permit when one is needed with Community Development Department (Building permits), City of Elgin, 150 Dexter Court.
Do you work in my part of Elgin?
Yes. Our crews work across Elgin, including Gifford Park, West Side, Downtown — ZIP 60123, 60124, 60120, 60140 — and nearby St. Charles, Bartlett, Hoffman Estates.

Working in Elgin

  • A lot of Elgin kitchens date from the pre-1940. We know these layouts well and what is worth keeping.
  • Most Elgin homes are single-family. We protect floors and driveways and leave the site clean every day.
  • Live in the Spring-Douglas Historic District? Interior kitchen work is usually not reviewed. We check before anything touches the exterior.

Gifford ParkWest SideDowntown

ZIP 60123ZIP 60124ZIP 60120ZIP 60140

Kitchen Faucet Installation nearby

Planning a kitchen project in Elgin?

Call us — we'll check your ZIP, answer your questions and book an in-home estimate.

Call now (708) 400-7049
Call (708) 400-7049Callback