Serving Berwyn & nearby Oak Park, Chicago

Kitchen Sink Installation & Replacement in Berwyn, IL

Undermount, drop-in and farmhouse sinks set, sealed and connected by licensed plumbers in Berwyn.

  • Installers working in Berwyn ZIP 60402
  • Hookups by licensed trades where the code calls for it
  • Old unit hauled away on request

Prefer a callback?

Leave your number and a Berwyn licensed plumber will call you.

Kitchen sink problems we fix in Berwyn

Swapping a sink looks simple until the new bowl doesn't match the cutout or the drain lands in the wrong spot. Our Berwyn crew measures first, then sets the sink and has a licensed plumber hook up the drain and supplies.

Original sink in an older Berwyn kitchen

Older Berwyn kitchens often have cast-iron sinks and galvanized or brass drains behind them. We replace the worn drain parts along with the sink.

Sink cabinet floor wet or swollen

A sink that leaked for months often leaves a soft cabinet floor. We replace the sink, fix the leak source and can put a new panel or mat in the base.

Undermount sink pulling away from the counter

Undermount sinks hang from the countertop. When the anchors let go, we clean the old sealant off, refasten the bowl and run a fresh bead of silicone.

Old drain parts that won't line up

Deeper bowls lower the drain outlet. If it ends up below the wall connection, we adjust the trap arm so the sink still drains properly.

Sink that drains slowly after replacement

Slow draining right after an install points to the connection, not the bowl. We correct the pitch and the fittings.

Dated sink in an otherwise good kitchen

A worn sink in a kitchen you otherwise like is one of the easier updates. We swap the bowl and the faucet without touching the cabinets.

New sink doesn't match the counter cutout

Before you buy, we check the existing cutout and the cabinet width. That avoids a sink that overhangs, shows gaps or won't drop in.

Sink installed with the counter replacement

If new stone is going in, the sink usually goes to the fabricator for the cutout. We set it and reconnect the plumbing once the tops are down.

Included with the install

  • Measure the cutout and cabinetA check of the cutout, cabinet width and plumbing so the new sink fits.
  • Shut off and disconnectWe close the valves and take apart the drain, supply and appliance connections.
  • Remove the old sinkOld sealant cut, clips released and the old bowl lifted out.
  • Cabinet changes for farmhouse sinksCabinet front modified and the sink supported from below.
  • Set and seal the sinkThe bowl mounted level and sealed to the counter.
  • New strainers and drainDrain rebuilt to suit the new bowl and outlet position.
  • Supply valves and linesFresh supply connections from the valves to the faucet.

Models, parts and fittings

Farmhouse (apron-front)Apron sinks sit forward of the cabinets and need support built in.
Granite compositeA dense, matte sink made of stone particles and resin that hides water spots.
UndermountHung under the countertop; needs a finished cutout edge and a strong counter.
Stainless steelEasy-care steel; a lower gauge number means thicker metal.
Enameled cast ironVery heavy and long-lasting, with a glossy enamel that can chip if struck.

What the work looks like in Berwyn homes

Kitchen Sink Installation & Replacement in a prewar house — beforeBefore
Kitchen Sink Installation & Replacement in a prewar house — installedInstalled
Kitchen Sink Installation & Replacement in a prewar house — detailDetail

Berwyn kitchen, 1920s bungalow: kitchen sink installation & replacement

The site: a 1920s bungalow near LaVergne. Before: stainless double sink under a window. The reason for the call: two small bowls where big pots never fit. Finished kitchen: a new undermount stainless single-bowl sink with a pull-down faucet. Work included measure the cutout and cabinet, set and seal the sink, plus supply valves and lines.

Kitchen Sink Installation & Replacement project in Oak Brook, beforeBefore
Kitchen Sink Installation & Replacement project in Oak Brook, afterAfter

An Oak Brook 1980s two-story: before and after

The site: a 1980s two-story in Oak Brook. The kitchen as it was: white double sink. What bothered the owners most: a divided sink too narrow for sheet pans. Finished kitchen: a new undermount stainless single-bowl sink with a pull-down faucet. On site this meant cabinet changes for farmhouse sinks, set and seal the sink, plus supply valves and lines.

Kitchen Sink Installation & Replacement in Oak Brook →
Kitchen Sink Installation & Replacement project in Elmhurst, beforeBefore
Kitchen Sink Installation & Replacement project in Elmhurst, afterAfter

Elmhurst kitchen, 1980s two-story: kitchen sink installation & replacement

The site: a 1980s two-story in Elmhurst. What we started with: solid-surface integrated sink. The reason for the call: a scratched integrated sink that never looked clean. The result: a new undermount stainless single-bowl sink with a pull-down faucet. Work included measure the cutout and cabinet, set and seal the sink, plus new strainers and drain.

Kitchen Sink Installation & Replacement in Elmhurst →
Kitchen Remodeling project near Berwyn, beforeBefore
Kitchen Remodeling project near Berwyn, afterAfter

A Berwyn prewar brick bungalow: before and after

What changed: soft sage-green inset-style cabinets with unlacquered brass hardware, honed white marble-look quartz counters, a white handmade-look square tile backsplash, restored oak strip floor and schoolhouse pendant lights.

Kitchen Remodeling in Berwyn →
Kitchen Cabinet Painting project near Berwyn, beforeBefore
Kitchen Cabinet Painting project near Berwyn, afterAfter

A Berwyn 1920s bungalow: before and after

What changed: the same doors sprayed in soft white, new matte black pulls; counters and floor stayed as they were.

Kitchen Cabinet Painting in Berwyn →

Install day

  1. Pick the sinkSend the model you like or let us suggest a few that fit.
  2. Measure and planA visit to confirm the fit and the connections before ordering.
  3. Written estimateA clear quote listing the sink work, parts and any cabinet modifications.
  4. Install and connectWe mount the sink and hook up the drain, faucet and appliances.
  5. Cure and testAfter the bond sets, the sink is tested in full use.

Kitchen Sink Installation & Replacement questions from Berwyn homeowners

Will Lake Michigan water mark my new sink?
Some spotting is normal. A quick dry-off and an occasional vinegar rinse keep the bowl clean.
Undermount or drop-in: which is better?
Undermount for a clean counter edge, drop-in for simplicity and any counter material. Both drain and work the same.
What does a farmhouse sink need?
Space in the sink base, a support frame for the weight and a counter cut for the apron style.
How long does a sink replacement take?
A straight swap is often done in a day. Undermount adhesive needs time to cure before heavy use, and farmhouse conversions take longer.
What size sink fits my cabinet?
It depends on the base cabinet and the counter cutout. We confirm both on site.
Does Berwyn have lead service lines?
City states it has identified lead service lines; inventory posted on water department page. A filter certified for lead reduction is a sensible step until your line is confirmed or replaced.
Do I need a Berwyn-registered contractor for sink replacement?
Contractors must be licensed and bonded with Berwyn; $10,000 surety bond and liability insurance naming the City per license (per licensing form. We take care of that before work starts.
Is Berwyn water hard, and does it matter for sink replacement?
Berwyn's water source: Lake Michigan water via City of Chicago (Jardine plant). We plan fittings and filters around it.
What is the Berwyn building department phone number?
Permits go through Building Department, City of Berwyn, phone 708-788-2660. When your scope needs one, we prepare the application and schedule the inspections.
Do I need a permit for sink replacement in Berwyn?
It depends on the scope. Berwyn's rule in short: City permit list includes any kitchen and bathroom remodeling, all electrical work, and plumbing/sewer work (faucet or toilet replacement excluded). We handle the permit when one is needed with Building Department, City of Berwyn.
Do you work in my part of Berwyn?
Yes. Our crews work across Berwyn, including South Berwyn, South Oak Park area, Depot District, LaVergne — ZIP 60402 — and nearby Oak Park, Chicago, Oak Brook.

Working in Berwyn

  • Most Berwyn homes are prewar. We work around plaster walls, radiators and out-of-square rooms every week.
  • Most Berwyn homes are single-family. We protect floors and driveways and leave the site clean every day.
  • Live in the Central Berwyn Bungalow Historic District? Interior kitchen work is usually not reviewed. We check before anything touches the exterior.

South BerwynSouth Oak Park areaDepot DistrictLaVergneOgden Avenue

ZIP 60402

Kitchen Sink Installation & Replacement nearby

Planning a kitchen project in Berwyn?

Call us — we'll check your ZIP, answer your questions and book an in-home estimate.

Call now (708) 400-7049
Call (708) 400-7049Callback