1960s wall oven and cooktop combo
A 1960s built-in oven and drop-in cooktop can usually be replaced in place, though cutouts and wiring often need updating.
Serving Wood Dale & nearby Itasca, Elk Grove Village
Oven, Range & Cooktop Installation in Wood Dale, IL
We install gas and electric ranges, wall ovens and cooktops in Wood Dale, connected safely, leveled and checked before we go.
- Serving Wood Dale ZIP 60191
- Installed level, sealed and tested before we leave
- Clear price for the install before the visit
Range, oven and cooktop installs we handle in Wood Dale
Gas ranges, slide-in electrics, induction cooktops and double wall ovens each need something different behind them: a gas shutoff and connector, a 240-volt circuit of the right size, or an exact cabinet cutout. Our Wood Dale installers sort out what your kitchen has and what the new appliance needs.
New range delivered but not hooked up
Many delivery crews drop off a gas range without connecting it. We hook it up with a new connector, leak-test the joints and light every burner.
Range that tips forward when the oven door opens
If you can rock the range by leaning on the door, it isn't anchored. We add the maker's bracket and slide the unit back until it locks in.
Double wall oven on an undersized circuit
Before a bigger wall oven goes in, the breaker and wire size must match the maker's spec. If they don't, an electrician corrects them.
Pro-style range that needs more gas and space
Larger pro-style ranges can need a bigger gas supply, a specific regulator and wider clearances. We check the specs against the line and the space.
Old gas connector that shouldn't be reused
Reusing the old flex line saves nothing if it fails. A new certified connector goes on with the new range, and the shutoff valve is checked too.
Downdraft or venting questions
A cooktop with downdraft venting needs space in the base cabinet and a duct path. We check both before choosing a model.
Electric range with a mismatched cord or outlet
Older homes may have a three-prong range outlet while new ranges are set up for four-wire. We fit the correct cord for your wiring per the maker's instructions.
What we hook up and check
- Supply and opening checkWe look at the gas shutoff or circuit, measure the opening and compare it to the new unit's specs.
- Disconnecting the old applianceWe isolate the supply and take out the old unit without damaging the floor or counter.
- Cabinet and counter adjustmentsWall oven boxes and cooktop cutouts resized to the maker's spec when needed.
- Electrical connectionThe appliance tied into the correct 240-volt or 120-volt supply, with panel and circuit work handled by an electrician.
- Anti-tip bracket and levelingAnti-tip bracket fastened and engaged, range leveled side to side and front to back.
- Burner, element and oven testEvery burner lit and checked for flame, every element and oven mode heated.
- Haul-away and cleanupWe remove the old unit, cartons and debris.
Options to choose from
Freestanding rangesThe standard range type that stands between cabinets or at the end of a run.
Slide-in and front-control rangesControls on the front, no backguard, the cooktop overlapping the counter for a built-in look.
Gas, electric and dual-fuelPick the fuel by what you cook and what your kitchen has; dual-fuel combines both.
Single and double wall ovensWall ovens need the right cutout, support and a dedicated circuit.
Induction cooktops and rangesFast, precise heat through magnetic cookware; usually needs a 240-volt circuit with enough capacity.
Kitchens like yours in Wood Dale: before and after
Before
Installed
DetailOven, Range & Cooktop Installation in a 1990s two-story colonial, Wood Dale
A 1990s two-story colonial in Wood Dale, a typical kitchen for Wood Dale. The kitchen as it was: white appliances. What bothered the owners most: an old stove that needed replacing. The result: a new stainless range installed level with a new gas connector. Work included supply and opening check, burner, element and oven test, plus haul-away and cleanup.
Before
AfterItasca kitchen, two-story colonial from the 1990s: oven, range & cooktop installation
A two-story colonial from the 1990s near Itasca Historical District, a typical kitchen for Itasca. What we started with: almond appliances. What bothered the owners most: an old range they no longer trusted. The result: a new stainless range installed level with a new gas connector. The job covered disconnecting the old appliance, cabinet and counter adjustments, plus anti-tip bracket and leveling.
Oven, Range & Cooktop Installation in Itasca →
Before
AfterElmhurst kitchen, 1990s two-story colonial: oven, range & cooktop installation
This one is a 1990s two-story colonial in Elmhurst. The kitchen as it was: black appliances. What bothered the owners most: an old stove that needed replacing. Finished kitchen: a new stainless range installed level with a new gas connector. The job covered supply and opening check, electrical connection, plus anti-tip bracket and leveling.
Oven, Range & Cooktop Installation in Elmhurst →
Before
AfterKitchen Remodeling in a 1960s ranch, Wood Dale
What changed: cabinets in soft white with unlacquered brass knobs and cup pulls, warm walnut butcher block counters, a blue handmade-look tile backsplash, warm oak luxury vinyl plank flooring and recessed lights and under-cabinet LED strips.
Kitchen Remodeling in Wood Dale →
Before
AfterA Wood Dale 1960s ranch: before and after
The same doors sprayed in powder blue, new satin brass pulls; counters and floor stayed as they were.
Kitchen Cabinet Painting in Wood Dale →How the install goes
- Model and photosSend the model number and photos of the space, the shutoff or outlet behind the old unit.
- Readiness checkWe confirm the gas supply or circuit, the cutout and the clearances, and flag any permit work.
- Written estimateAn itemized estimate for removal, installation, parts and any gas line or electrical work.
- Install and testWe install, check for leaks, test heat and haul away the old appliance.
Oven, Range & Cooktop Installation questions from Wood Dale homeowners
Does a wall oven need its own circuit?
They do. If your circuit is undersized for the new oven, an electrician upgrades it before installation.
Does a gas range need to be professionally installed?
Connecting gas should be done by a qualified installer per local code, followed by a leak test. Mistakes here are a safety risk, not just an inconvenience.
Can you replace a cooktop with a different size?
Usually. Cutout size is what matters, and we check it before you buy.
Do you install ranges and ovens I bought elsewhere?
Yes. Many of our installs are units the owner purchased on their own.
Do I need a permit to install a gas range in Wood Dale?
A like-for-like swap usually doesn't; a new or extended gas line normally needs a permit and inspection. We check locally.
Can Wood Dale bulk pickup take my old appliance or cabinets?
Hauler Flood Brothers (exclusive franchise): bulk items by request, white goods (appliances) and electronics by appointment; call (630) 261-0400. If you'd rather not deal with it, we haul old units and debris away.
Do I need a Wood Dale-registered contractor for range or oven installation?
All contractors (general, HVAC, electrical, plumbing, roofing, etc.) must register with the City before a permit is issued. Requires Certificate of Insurance ($2,000,000 public liability) naming the City, state license/IDPH registration if applicable. We take care of that before work starts.
What does Wood Dale ask for on electrical work?
Electrical contractors must register with the City (insurance certificate, fee/bond per fee schedule); city adopts the 2014 National Electrical Code with local amendments. New circuits and wiring are done by licensed electricians.
Wood Dale building permit for range or oven installation: where do I apply?
Permits go through Community Development Department (https://my.wooddale.com), phone 630-766-5133. When your scope needs one, we prepare the application and schedule the inspections.
Do I need a permit for range or oven installation in Wood Dale?
It depends on the scope. Wood Dale's rule in short: A permit is required for any alteration or repair of a building. We handle the permit when one is needed with Community Development Department.
Do you work in my part of Wood Dale?
Yes. Our crews work across Wood Dale — ZIP 60191 — and nearby Itasca, Elk Grove Village, Addison.
Working in Wood Dale
- A lot of Wood Dale kitchens date from the 1960s. We know these layouts well and what is worth keeping.
- Most Wood Dale homes are single-family. We protect floors and driveways and leave the site clean every day.
- We know how Community Development Department handles kitchen permits and pull them for you.
ZIP 60191
Oven, Range & Cooktop Installation nearby
Other kitchen services in Wood Dale
Dishwasher InstallationOld unit out, new dishwasher connected, leveled and leak-tested.
Built-In Refrigerator InstallationBuilt-in and panel-ready fridges fitted flush, anchored and connected.
Microwave InstallationOver-the-range, drawer and built-in microwaves mounted, powered and vented.
Kitchen RemodelingFull kitchen remodels, from layout to last cabinet pull.
Kitchen Cabinet PaintingFactory-smooth painted cabinets without replacing them.