Gas burner clicking but not lighting
A burner that clicks without lighting usually has a wet or dirty igniter, a misaligned burner cap or a clogged port. Cleaning and seating the cap often fixes it.
Serving Winfield & nearby Wheaton, Carol Stream
Oven not heating, burner won't light or the temperature is off? We repair gas and electric ranges, wall ovens and cooktops in Winfield.
We repair freestanding and slide-in ranges, wall ovens and cooktops in Winfield homes, gas and electric. The visit starts with a diagnosis, because a cold oven can be a burned-out element, a weak igniter, a bad sensor or a control board, and each is a different fix.
A burner that clicks without lighting usually has a wet or dirty igniter, a misaligned burner cap or a clogged port. Cleaning and seating the cap often fixes it.
Burned bottoms and dark edges when the settings haven't changed often mean the temperature sensor or the control is at fault.
Hot spots usually mean heat isn't being spread or held. We check the convection fan, the elements and the door gasket.
If bake works but broil doesn't, the broil element or broil igniter is the likely cause. We test and replace it.
Self-clean cycles run extremely hot and are hard on the parts. Locks, sensors and fuses can fail during or after one, and we repair them.
A cold electric oven most often has a burned-out bake element. You may see a break or a blister on it. Other causes are a bad sensor, a relay on the control board or a tripped breaker.
When the burners light but the oven stays cold, the oven igniter is usually too weak to open the gas valve. It may glow but never light the burner.
Cleaning cycles stress the wiring and parts. When the oven dies after one, we test the fuse, sensor and control.
Problem
Fixed
DetailThis one is a two-story colonial from the 1990s in Winfield. What we started with: black appliances. The reason for the call: an oven that ran hot and burned dinner. After: the oven with a new bake element installed, heating evenly with the oven light on. Work included sensor and control tests, burner and switch checks, plus test and leak check.
Before
AfterThe site: a 1990s two-story colonial near Danada Square area. Before: almond appliances. The main complaint was an older range with a burned-out bake element. After: the oven with a new bake element installed, heating evenly with the oven light on. The job covered sensor and control tests, door, lock and gasket check, plus written quote.
Oven, Stove & Cooktop Repair in Wheaton →
Before
AfterThis one is a 1980s two-story in Carol Stream. The kitchen as it was: white appliances. The main complaint was an oven that ran hot and burned dinner. The result: the oven with a new bake element installed, heating evenly with the oven light on. On site this meant temperature test, sensor and control tests, plus test and leak check.
Oven, Stove & Cooktop Repair in Carol Stream →
Before
AfterFinished: cabinets in light butter yellow with satin brass pulls, charcoal concrete-look quartz counters, a terracotta-look square tile backsplash, gray wood-look porcelain plank flooring and two glass pendants and recessed lights.
Kitchen Remodeling in Winfield →
Before
AfterWhat changed: the same doors sprayed in light sand beige, new brushed nickel bar pulls; counters and floor stayed as they were.
Kitchen Cabinet Painting in Winfield →ZIP 60190ZIP 60185
Refrigerator & Ice Maker RepairNot cooling, frost, leaks and dead ice makers diagnosed and fixed.
Dishwasher RepairDraining, cleaning, leaking and door problems found and fixed.
Microwave RepairOver-the-range and built-in microwaves diagnosed and repaired safely.
Kitchen RemodelingFull kitchen remodels, from layout to last cabinet pull.
Kitchen Cabinet PaintingFactory-smooth painted cabinets without replacing them.
Call us — we'll check your ZIP, answer your questions and book an in-home estimate.