1950s hood on an old duct
Many 1950s kitchens still have the original hood on a small duct. We often replace both, so the new hood isn't held back by the old pipe.
Serving Villa Park & nearby Elmhurst, Lombard
Range Hood Installation in Villa Park, IL
We install under-cabinet, wall chimney, island and insert range hoods in Villa Park, ducted outside wherever the house allows.
- Installers working in Villa Park ZIP 60181
- Hookups by licensed trades where the code calls for it
- Old unit hauled away on request
Range hood installs we handle in Villa Park
Swapping a tired hood for a new one can be a short job, and adding a hood where there was none takes more planning. Either way, we work out in Villa Park where the duct can run, what the wiring needs and whether the village wants a permit, before you order.
Flexible foil duct behind the old hood
If the old hood was hooked up with flexible foil, that duct comes out. Smooth metal duct moves more air and is easier to keep clean.
Custom hood cover that needs an insert
If your cabinetmaker built a decorative hood, the working part is a hood insert. We fit it, duct it outside and wire it to the switch.
Island hood over a new island cooktop
An island hood hangs in open air, so it needs a wider canopy, solid ceiling blocking and a duct route through the joists. We plan the route before the ceiling is opened.
Gas range that needs stronger ventilation
Pro-style gas ranges with high-output burners often need a larger hood and a bigger duct. We follow the range and hood makers' guidance.
Hood too narrow for the cooktop
A hood narrower than the burners lets smoke roll past its edges. We usually match the cooktop width at a minimum, and go wider over gas or pro-style ranges.
Hood that vents into the attic or soffit
We sometimes find an old hood ending in the attic with no cap at all. The duct is carried through to the outdoors and fitted with a damper.
Old hood that only recirculates
If your current hood has no duct and just pushes air back toward you, the fix is usually a ducted replacement with a proper exterior cap.
Included with the install
- Site check and sizingWe measure the cooktop, the space above it and the possible duct routes, then size the hood.
- Permit and approvalsPermits, condo approvals and any makeup-air requirement are confirmed up front.
- Removing the old hoodPower off, old hood disconnected and taken down, the old duct inspected or removed.
- Blocking and mountingMounting points set at the height in the maker's instructions.
- Wall cap or roof jackThe duct ends outside under a damper that closes when the fan is off.
- Recirculating setupWhere ducting outside isn't possible, a recirculating kit with charcoal filters is installed.
- Test and cleanupWe run the hood, confirm the damper opens and closes, and haul away the old unit.
Options to choose from
Inserts and linersThe working core of a decorative hood, ducted like any other hood.
Island hoodsHoods suspended above an island, supported from the ceiling framing.
Wall chimney hoodsWall-mounted hoods with a tall cover, often used where there is no cabinet above the range.
Duct, caps and dampersRigid galvanized or stainless duct, wall caps and roof jacks with backdraft dampers.
Internal and remote blowersMost hoods carry the fan inside; some use an inline or exterior blower to cut noise in the kitchen.
Kitchens like yours in Villa Park: before and after
Before
Installed
DetailVilla Park kitchen, two-story colonial from the 1990s: range hood installation
This one is a two-story colonial from the 1990s in Villa Park. What we started with: almond appliances and honey-oak cathedral raised-panel cabinets with worn finish near the handles, brass knobs. What bothered the owners most: a decades-old hood that blew grease back into the room. Finished kitchen: a new stainless chimney range hood ducted to the outside. The job covered removing the old hood, blocking and mounting, plus wall cap or roof jack.
Before
AfterRange Hood Installation in a two-story colonial from the 1990s, Elmhurst
A two-story colonial from the 1990s in Elmhurst, a typical kitchen for Elmhurst. Before: black appliances and golden-oak cabinets with oak soffits above. The reason for the call: an old hood that was loud and pulled very little air. The result: a new stainless chimney range hood ducted to the outside. On site this meant site check and sizing, permit and approvals, plus wall cap or roof jack.
Range Hood Installation in Elmhurst →
Before
AfterRange Hood Installation in a 1980s condo, Lombard
This one is a 1980s condo in Lombard. What we started with: white appliances and oak flat-panel cabinets. What bothered the owners most: an old hood that was loud and pulled very little air. The result: a new stainless chimney range hood ducted to the outside. Work included wall cap or roof jack, recirculating setup, plus test and cleanup.
Range Hood Installation in Lombard →
Before
AfterA Villa Park 1960s ranch: before and after
What changed: cabinets in light gray uppers and dusty rose lowers with unlacquered brass knobs and cup pulls, light marble-look quartz counters, a gray beveled subway tile backsplash, large-format light stone-look porcelain tile flooring and two glass pendants and recessed lights.
Kitchen Remodeling in Villa Park →
Before
AfterBefore and after: a 1960s ranch in Villa Park
The same doors sprayed in light warm taupe, new unlacquered brass knobs and cup pulls; counters and floor stayed as they were.
Kitchen Cabinet Painting in Villa Park →How the install goes
- Photos and modelTell us what you cook on and show us the space; a model number helps.
- Duct route and sizingWe decide where the duct can run and which hood fits that route.
- Written estimateAn itemized estimate for the hood install, duct, exterior cap, wiring and any permit.
- Install and testWe install, test the airflow and clean up the same day in most cases.
Range Hood Installation questions from Villa Park homeowners
How high should a range hood be above the stove?
Every hood has a mounting height in its installation guide. Too high and it misses smoke; too low and it gets in the way.
How many CFM does my range hood need?
There's no one answer. Gas, pro-style burners and heavy searing push it up; induction and light cooking need less.
How much does range hood installation cost?
A swap on an existing duct and a new island hood with a roof jack are very different jobs. You get a line-item estimate before work starts.
Do I need makeup air for a big hood in Villa Park?
Possibly. High-CFM hoods can trigger a makeup-air requirement under local code. We check with the village before you pick the hood.
Who installs a range hood: a plumber, an electrician or a contractor?
A contractor who handles ducting and mounting is the right call. Plumbers don't usually do hoods; new circuits go to an electrician.
Does Villa Park require a licensed electrician for range hood installation?
New electrical work must be done by a licensed electrician with current bond and insurance; homeowners may do small repairs like changing outlets or switches. New circuits and wiring are done by licensed electricians.
Do I need a Villa Park-registered contractor for range hood installation?
No general contractor registration described. Homeowners acting as own general contractor submit a form and homeowner's insurance copy. We take care of that before work starts.
Does range hood installation need a Villa Park building permit, and who files it?
Permits go through Permitting Division, Community & Economic Development, phone 630-433-4300. When your scope needs one, we prepare the application and schedule the inspections.
Do I need a permit for range hood installation in Villa Park?
It depends on the scope. Villa Park's rule in short: Permit required for adding, replacing or relocating plumbing fixtures, electrical or HVAC systems, and for moving or building walls. We handle the permit when one is needed with Permitting Division, Community & Economic Development.
Do you work in my part of Villa Park?
Yes. Our crews work across Villa Park — ZIP 60181 — and nearby Elmhurst, Lombard, Addison.
Working in Villa Park
- A lot of Villa Park kitchens date from the 1950s. We know these layouts well and what is worth keeping.
- Most Villa Park homes are single-family. We protect floors and driveways and leave the site clean every day.
- We know how Permitting Division, Community & Economic Development handles kitchen permits and pull them for you.
ZIP 60181
Range Hood Installation nearby
Other kitchen services in Villa Park
Range Hood RepairFans, motors, switches, lights and rattles on kitchen range hoods.
Oven, Range & Cooktop InstallationGas and electric ranges, wall ovens and cooktops, safely connected.
Kitchen Electrical WorkNew circuits and outlets for kitchen appliances.
Kitchen RemodelingFull kitchen remodels, from layout to last cabinet pull.
Kitchen Cabinet PaintingFactory-smooth painted cabinets without replacing them.