Painted walls in a home built before 1978
In older Villa Park homes, tearing out a backsplash can disturb lead paint. We work lead-safe: plastic sheeting, controlled dust and a careful final cleanup.
Serving Villa Park & nearby Elmhurst, Lombard
Kitchen Backsplash Installation in Villa Park, IL
Tile backsplashes set straight, grouted clean and finished around every outlet in Villa Park kitchens.
- Serving Villa Park ZIP 60181
- A new look without tearing the kitchen out
- Clean, protected work area every day
Backsplash problems we solve in Villa Park
Most of the work in a good backsplash happens before the first tile goes up. Our Villa Park tile setters flatten the wall, extend the outlet boxes and lay out the pattern, then set and grout subway, mosaic, stone or porcelain tile.
Bare wall behind the counters
If the wall above the counter is just paint, every spatter shows. Tile gives it a surface you can scrub.
Grease-prone spot behind the range
Behind the range we often suggest a full-height feature, a larger tile or a slab panel with fewer grout lines to clean.
Peel-and-stick that didn't last
If the stick-on backsplash is curling at the edges, it's time for set tile. We take it off and prep the wall properly.
Awkward edges and ends
Where the tile stops at an open wall or the end of an upper cabinet, we finish it with a metal edge profile, a bullnose or a pencil liner.
Uneven wall surface
Wavy walls make tile edges catch the light unevenly. We skim or patch the wall flat before setting, especially for large-format tile.
Grout stained or cracking
Dark, stained or cracking grout behind the sink is often a wrong grout choice. We match sanded, unsanded or epoxy grout to the tile and the spot.
Window or range hood in the middle
Windows and hoods are where layouts go wrong. We center the pattern on them and decide how far up the tile runs.
What the work covers
- Layout and tile selectionHelp choosing tile, grout color and pattern, and a layout planned around the range, sink and windows.
- Protection and removalWe protect the counters, cut power to the outlets and take down the old backsplash.
- Wall repair and prepThe wall is repaired, leveled out and primed so the tile bonds.
- GroutingSanded, unsanded or epoxy grout chosen for the tile and joint width.
- Edges and trimFinished ends at open walls, cabinet sides and the ceiling line.
- Caulk at the counterThe counter joint and inside corners sealed with caulk, not grout.
- Sealing and cleanupStone and grout sealed if they call for it, then a full cleanup.
Finishes we offer
Slab backsplashA full-height sheet of quartz, stone or porcelain matching the counters, with no grout lines.
Subway tileClassic 3x6 or longer rectangles in a running bond, stacked or herringbone layout.
Mosaic and glassSmall tiles on mesh sheets for accents or full walls; glass needs careful setting and unsanded or epoxy grout.
Grout typesUnsanded for narrow joints, sanded for wider ones, epoxy where stain resistance matters most.
Natural stoneStone tile looks rich and needs a sealer to resist stains.
Before and after: kitchens near Villa Park
Before
In progress
After
DetailKitchen Backsplash Installation in a 1950s ranch, Villa Park
The site: a 1950s ranch in Villa Park. Before: mint-green 4-inch ceramic tile and laminate with an aluminum edge band. The main complaint was a short 4-inch splash that looked unfinished. Finished kitchen: a white subway tile backsplash with clean edges and outlets set flush. Work included layout and tile selection, grouting, plus sealing and cleanup.
Before
AfterLombard kitchen, 1950s ranch: kitchen backsplash installation
This one is a 1950s ranch in Lombard. The kitchen as it was: yellow 4-inch tile and light beige laminate. What bothered the owners most: an old 4-inch tile strip that dated the room. Finished kitchen: a white 2x8 tile in a vertical stack backsplash with clean edges and outlets set flush. On site this meant protection and removal, wall repair and prep, plus grouting.
Kitchen Backsplash Installation in Lombard →
Before
AfterOak Brook kitchen, raised ranch: kitchen backsplash installation
This one is a raised ranch in Oak Brook. Before: patterned wallpaper and harvest-gold laminate. What bothered the owners most: a bare wall that never stayed clean. Finished kitchen: a white 3x12 tile in a stacked pattern backsplash with clean edges and outlets set flush. The job covered layout and tile selection, grouting, plus sealing and cleanup.
Kitchen Backsplash Installation in Oak Brook →
Before
AfterCountertop Fabrication & Installation in a 1950s ranch, Villa Park
What changed: white quartz with soft gray veining countertops with a tight seam, an undermount sink and a new faucet.
Countertop Fabrication & Installation in Villa Park →
Before
AfterKitchen Flooring Installation in a postwar Cape Cod, Villa Park
Finished: gray wood-look porcelain plank flooring through the kitchen with clean transitions.
Kitchen Flooring Installation in Villa Park →How the job goes
- Pick tile and patternChoose the tile and how it's laid; we figure out the quantity.
- Measure and planA site visit to check the wall and lay out the pattern on paper.
- Prep and setWall repaired, outlets extended and tile set — often in a day or two for a typical kitchen.
- Grout and finishGrout, caulk, trim, cover plates and cleanup, usually the next day.
Kitchen Backsplash Installation questions from Villa Park homeowners
Can you tile over my existing backsplash?
Occasionally. If the old tile is loose or uneven, it has to come off first.
Which grout should I use?
It depends on the joint width and the tile. Glass and polished stone often call for unsanded or epoxy grout to avoid scratches.
What affects the price of a backsplash?
Wall size, the tile you choose, the pattern, how many outlets and cuts there are and whether old tile comes off. We give a written, itemized estimate after the visit.
What is the easiest backsplash to keep clean?
Large glazed tiles or a slab with few grout joints. Epoxy grout helps too.
Can tile go over drywall?
Usually. Painted drywall is cleaned and scuffed or primed; soft or water-damaged spots are cut out and replaced.
Villa Park contractor registration: do kitchen contractors need it?
No general contractor registration described. Homeowners acting as own general contractor submit a form and homeowner's insurance copy. We take care of that before work starts.
Do I need a permit for backsplash installation in Villa Park?
It depends on the scope. Villa Park's rule in short: Permit required for adding, replacing or relocating plumbing fixtures, electrical or HVAC systems, and for moving or building walls. We handle the permit when one is needed with Permitting Division, Community & Economic Development.
Do you work in my part of Villa Park?
Yes. Our crews work across Villa Park — ZIP 60181 — and nearby Elmhurst, Lombard, Addison.
Working in Villa Park
- A lot of Villa Park kitchens date from the 1950s. We know these layouts well and what is worth keeping.
- Most Villa Park homes are single-family. We protect floors and driveways and leave the site clean every day.
- We know how Permitting Division, Community & Economic Development handles kitchen permits and pull them for you.
ZIP 60181
Kitchen Backsplash Installation nearby
Other kitchen services in Villa Park
Countertop Fabrication & InstallationQuartz, granite and butcher block, templated and installed.
Kitchen Tile & Grout RepairCracked tiles swapped, loose tiles reset and tired grout redone.
Kitchen Flooring InstallationKitchen flooring: LVP, tile and hardwood.
Kitchen RemodelingFull kitchen remodels, from layout to last cabinet pull.
Kitchen Cabinet PaintingFactory-smooth painted cabinets without replacing them.