Concrete ceilings in condo buildings
Condo kitchens with concrete ceilings need surface-mounted lighting or a framed soffit. We plan it with the building's rules in mind.
Serving Lisle & nearby Downers Grove, Woodridge
Kitchen Lighting Installation in Lisle, IL
Recessed, pendant and under-cabinet lighting for Lisle kitchens, laid out so the counters are bright and wired by a licensed electrician.
- Crews working in Lisle ZIP 60532
- Most jobs done in days, with your kitchen still usable
- Samples and a written quote before we start
Kitchen lighting problems we solve in Lisle
A single fixture in the center of the ceiling leaves you working in your own shadow. Our Lisle electricians replace it with lights placed over the counters, the sink and the island, using LED fixtures that suit your ceiling and wiring.
Recessed lights under an insulated attic
Non-IC cans need clearance from insulation. We install fixtures rated for contact so the attic stays fully insulated.
Visible LED dots and glare under the cabinets
If your under-cabinet lights glare off the stone, we swap them for diffused LEDs and add a light rail where needed to hide them.
Switches in the wrong place or one switch for everything
A switch on the far side of the room is a daily nuisance. We move or add controls where you walk in.
Fluorescent box or panel that hums and flickers
Fluorescent tubes and ballasts wear out and are hard to dim. A switch to LED fixtures gives steadier light and dimming.
Light that looks too blue or too yellow
Mixing bulbs of different color temperatures makes a kitchen look patchy. We use one consistent warm white across the fixtures.
Light over the sink
The sink is where you need light most and often have the least. A recessed light or small pendant above it solves that.
Under-cabinet lighting: hardwired or plug-in?
Hardwired LED strips run from a wall switch with the driver hidden in a cabinet, and the wiring disappears. Plug-in kits are simpler but leave a cord to an outlet.
What we do on the job
- Lighting layoutWe mark where each light goes and which switch controls it.
- Ceiling openings and boxesOpenings cut cleanly and pendant boxes secured to framing.
- Wire fished to fixtures and switchesNew cable run through the ceiling and walls with minimal access holes.
- Fixtures installedEach fixture hung, leveled and wired.
- Switches and dimmersLED-compatible dimmers and separate switches for each lighting layer.
- Testing and adjustmentWe run each circuit and fine-tune before leaving.
- Patching and cleanupWe close up openings and clean the work area.
Finishes we offer
Surface and flush fixturesCeiling-mounted lights when recessing isn't possible.
Accent lightingSofter layers that add depth in the evening.
Pendants and linear fixturesHanging fixtures that light the island and set the style.
Color temperature optionsWarm white around 2700 to 3000K, and selectable-color fixtures where you're unsure.
Recessed lightingDownlights set into the ceiling for even general light.
What the work looks like in Lisle homes
Before
AfterA Lisle two-story colonial from the 1990s: before and after
This one is a two-story colonial from the 1990s in Lisle. The kitchen as it was: a brass chandelier over the nook. What bothered the owners most: a single old light that left the counters in shadow. The result: two glass pendants and recessed lights on separate switches. On site this meant lighting layout, wire fished to fixtures and switches, plus patching and cleanup.
Before
AfterKitchen Lighting Installation in a postwar Cape Cod, Downers Grove
This one is a postwar Cape Cod near Denburn Woods. Before: a dome ceiling light. The main complaint was one ceiling fixture lighting the whole room. The result: a flush drum fixture and under-cabinet lights on separate switches. On site this meant lighting layout, ceiling openings and boxes, plus testing and adjustment.
Kitchen Lighting Installation in Downers Grove →
Before
AfterKitchen Lighting Installation in a 1990s two-story colonial, Woodridge
A 1990s two-story colonial near The Ridge, a typical kitchen for Woodridge. What we started with: two hanging glass pendants. The main complaint was dim counters despite the ceiling lights. The result: black cage pendants and slim recessed lights on separate switches. On site this meant lighting layout, ceiling openings and boxes, plus fixtures installed.
Kitchen Lighting Installation in Woodridge →
Before
AfterKitchen Remodeling in a two-story colonial from the 1990s, Lisle
Cabinets in light butter yellow with satin brass pulls, charcoal concrete-look quartz counters, a terracotta-look square tile backsplash, gray wood-look porcelain plank flooring and two glass pendants and recessed lights.
Kitchen Remodeling in Lisle →
Before
AfterBefore and after: a 1980s two-story in Lisle
What changed: the same doors sprayed in pale mint green, new matte black pulls; counters and floor stayed as they were.
Kitchen Cabinet Painting in Lisle →How the job goes
- Share photos and plansSend photos of the kitchen, the ceiling and any fixtures you've picked.
- Layout visitAn electrician looks at the space and plans the layers and switching.
- Written estimateAn itemized estimate listing fixtures, wiring, switches, patching and any permit.
- Install and testWe install, test each light and clean up.
Kitchen Lighting Installation questions from Lisle homeowners
What color temperature is best for a kitchen?
Most kitchens look best in warm white. Keep all fixtures in the same color so the room looks even.
Do I need a permit for kitchen lighting?
Often when new circuits are added; simple fixture replacements usually don't need one. We check with the village before work starts.
How high should pendants hang over an island?
The bottom of the fixture usually sits around 30 to 36 inches above the counter, adjusted to your height and sight lines.
What's the best lighting for a small kitchen?
In a small kitchen, under-cabinet lighting does the most work for the space. Add even ceiling light and skip bulky fixtures.
Hardwired or plug-in under-cabinet lights?
Hardwired looks cleaner and works from a wall switch. Plug-in is quicker but leaves a cord and uses an outlet.
Lisle building permit for kitchen lighting project: where do I apply?
Permits go through Development Services Department, phone 630-271-4150. When your scope needs one, we prepare the application and schedule the inspections.
Does Lisle require a licensed electrician for kitchen lighting project?
Electrical permits require a letter of intent and license copy from the electrical contractor; owner-occupants of a primary residence may do the work themselves with an electrical affidavit. New circuits and wiring are done by licensed electricians.
Can you do kitchen lighting project in a Lisle condo?
Associations usually set rules for work hours, elevators, deliveries and insurance, and many require approval for plumbing, electrical or structural changes. We provide the certificate of insurance and follow the building's rules.
Do you work in my part of Lisle?
Yes. Our crews work across Lisle, including Oakview, The Meadows, Four Lakes Village — ZIP 60532 — and nearby Downers Grove, Woodridge, Wheaton.
Working in Lisle
- A lot of Lisle kitchens date from the 1980s. We know these layouts well and what is worth keeping.
- Condo or townhome? We follow association rules on work hours and elevators and bring the insurance certificate your board asks for.
OakviewThe MeadowsFour Lakes Village
ZIP 60532
Kitchen Lighting Installation nearby
Other kitchen services in Lisle
Kitchen RemodelingFull kitchen remodels, from layout to last cabinet pull.
Kitchen Cabinet PaintingFactory-smooth painted cabinets without replacing them.
Cabinet RefacingNew doors and fronts on your existing cabinet boxes.
Countertop Fabrication & InstallationQuartz, granite and butcher block, templated and installed.
Kitchen Backsplash InstallationTile backsplashes with clean lines and flush outlets.