Serving Des Plaines & nearby Mount Prospect, Park Ridge

Kitchen Sink Installation & Replacement in Des Plaines, IL

Undermount, drop-in and farmhouse sinks set, sealed and connected by licensed plumbers in Des Plaines.

  • Serving Des Plaines ZIP 60016, 60018
  • Installed level, sealed and tested before we leave
  • Clear price for the install before the visit

Prefer a callback?

Leave your number and a Des Plaines licensed plumber will call you.

Kitchen sink problems we fix in Des Plaines

A new kitchen sink is part fit, part plumbing. In Des Plaines we check the counter cutout and the cabinet below, mount the bowl so it stays put, and our licensed plumbers reconnect the drain, disposal, dishwasher and faucet.

1960s stainless double sink

If your sink dates from the 1960s, the drain parts usually do too. We replace both at once.

Drop-in rim that traps grime

Grime along the rim of a drop-in sink is a common complaint. Undermount is cleaner, but it needs a solid-surface or stone counter with a finished cutout edge.

Sink that drains slowly after replacement

A sink that drains poorly after a DIY swap usually has a trap set too high or a tailpiece forced at an angle. We rebuild the drain.

Undermount sink pulling away from the counter

If the sink has dropped and water runs into the cabinet, it can usually be reattached without replacing the counter. We support it from below and bond it again.

Faucet holes don't match the new faucet

If you want a single-handle faucet on a three-hole sink, a deck plate covers the gaps. With undermount sinks the holes are drilled in the counter instead.

Double bowl too small for big pans

Many owners trade a divided sink for one wide basin. We reconfigure the drain for the single outlet and reconnect the disposal.

Strainer or drain leaking

A leak at the drain flange is usually the strainer, not the sink. We replace it, and with a new sink we always fit new strainers.

Sink cabinet floor wet or swollen

If the cabinet bottom has swollen, the leak has been there a while. We find it, replace what failed and protect the base going forward.

What we hook up and check

  • Shut off and disconnectWe close the valves and take apart the drain, supply and appliance connections.
  • Remove the old sinkOld sealant cut, clips released and the old bowl lifted out.
  • Set and seal the sinkThe bowl mounted level and sealed to the counter.
  • New strainers and drainDrain rebuilt to suit the new bowl and outlet position.
  • Faucet and accessoriesFaucet, sprayer, soap dispenser or deck plate installed.
  • Disposal and dishwasher hookupDisposal remounted to the new flange and dishwasher drain reconnected.
  • Leak check and cleanupBoth bowls filled and drained, every joint checked dry.

What to pick before the install

Workstation sinksBowls with a ledge for cutting boards, colanders and drying racks.
Enameled cast ironClassic cast iron, often drop-in, that needs a sturdy counter and cabinet.
FireclayGlazed ceramic fired at high heat, common for farmhouse sinks; heavy and glossy.
UndermountHung under the countertop; needs a finished cutout edge and a strong counter.
Drop-in (top-mount)The simplest swap, as long as the new rim covers the old cutout.

Kitchens like yours in Des Plaines: before and after

Kitchen Sink Installation & Replacement in a 1980s-1990s two-story colonial / tract house — beforeBefore
Kitchen Sink Installation & Replacement in a 1980s-1990s two-story colonial / tract house — installedInstalled
Kitchen Sink Installation & Replacement in a 1980s-1990s two-story colonial / tract house — detailDetail

Before and after: a 1980s two-story in Des Plaines

The site: a 1980s two-story in Des Plaines. What we started with: white double sink. The reason for the call: a divided sink too narrow for sheet pans. Finished kitchen: a new undermount stainless single-bowl sink with a pull-down faucet. The job covered shut off and disconnect, faucet and accessories, plus disposal and dishwasher hookup.

Kitchen Sink Installation & Replacement project in Mount Prospect, beforeBefore
Kitchen Sink Installation & Replacement project in Mount Prospect, afterAfter

Before and after: a 1980s two-story in Mount Prospect

The site: a 1980s two-story in Mount Prospect. The kitchen as it was: white cast-iron double sink. The reason for the call: worn enamel and rust spots in the old bowl. Finished kitchen: a new undermount stainless single-bowl sink with a pull-down faucet. On site this meant remove the old sink, set and seal the sink, plus faucet and accessories.

Kitchen Sink Installation & Replacement in Mount Prospect →
Kitchen Sink Installation & Replacement project in Elk Grove Village, beforeBefore
Kitchen Sink Installation & Replacement project in Elk Grove Village, afterAfter

An Elk Grove Village two-story colonial from the 1990s: before and after

This one is a two-story colonial from the 1990s in Elk Grove Village. Before: solid-surface integrated sink. The reason for the call: a stained solid-surface bowl. The result: a new undermount stainless single-bowl sink with a pull-down faucet. The job covered shut off and disconnect, disposal and dishwasher hookup, plus leak check and cleanup.

Kitchen Sink Installation & Replacement in Elk Grove Village →
Kitchen Remodeling project near Des Plaines, beforeBefore
Kitchen Remodeling project near Des Plaines, afterAfter

Des Plaines kitchen, 1950s ranch: kitchen remodeling

Finished: cabinets in light butter yellow with satin brass pulls, creamy quartzite-look quartz counters, a green zellige-look tile backsplash, warm oak luxury vinyl plank flooring and a flush drum fixture and under-cabinet lights.

Kitchen Remodeling in Des Plaines →
Kitchen Cabinet Painting project near Des Plaines, beforeBefore
Kitchen Cabinet Painting project near Des Plaines, afterAfter

Des Plaines kitchen, postwar Cape Cod: kitchen cabinet painting

What changed: the same doors sprayed in pale sage, new polished nickel pulls; counters and floor stayed as they were.

Kitchen Cabinet Painting in Des Plaines →

Install day

  1. Pick the sinkSend the model you like or let us suggest a few that fit.
  2. Measure and planA visit to confirm the fit and the connections before ordering.
  3. Written estimateYou get an itemized estimate for removal, installation and plumbing.
  4. Install and connectWe mount the sink and hook up the drain, faucet and appliances.
  5. Cure and testAdhesive and sealant cure, then we run water and check every joint.

Kitchen Sink Installation & Replacement questions from Des Plaines homeowners

Will Lake Michigan water mark my new sink?
Some spotting is normal. A quick dry-off and an occasional vinegar rinse keep the bowl clean.
How long does a sink replacement take?
A straight swap is often done in a day. Undermount adhesive needs time to cure before heavy use, and farmhouse conversions take longer.
Who would you call to install a new sink?
For a straight swap, a plumber. If the counter or cabinet changes too, a crew that handles both saves a second visit.
What does a farmhouse sink need?
A cabinet built or modified for the apron, solid support under the bowl and usually a new countertop cutout.
What does a new kitchen sink installation cost?
We price it after seeing the sink base and counter, and you get the details in writing.
Is Des Plaines water hard, and does it matter for sink replacement?
Des Plaines's water source: Lake Michigan water purchased from the City of Chicago and the Northwest Water Commission (which is supplied by Evanston). We plan fittings and filters around it.
Des Plaines contractor registration: do kitchen contractors need it?
Contractors must register with the City (via the online portal); registrations expire Dec 31. We take care of that before work starts.
Does Des Plaines require a licensed plumber for sink replacement?
Plumbers need a State of Illinois license; no City fees. Our plumbing connections are made by licensed plumbers.
Does Des Plaines have lead service lines?
City has submitted its IEPA Water Service Line Inventory (2025) and a proposed draft Replacement Plan; a public service line map is available. A filter certified for lead reduction is a sensible step until your line is confirmed or replaced.
Does sink replacement need a Des Plaines building permit, and who files it?
Permits go through Community and Economic Development Department - Building Division, phone 847-391-5380. When your scope needs one, we prepare the application and schedule the inspections.
Do I need a permit for sink replacement in Des Plaines?
It depends on the scope. Des Plaines's rule in short: A building permit is required for any residential kitchen remodel; non-structural work uses the Kitchen/Bath Non-Structural permit ($150 fee, rough and final inspections). We handle the permit when one is needed with Community and Economic Development Department - Building Division.
Do you work in my part of Des Plaines?
Yes. Our crews work across Des Plaines — ZIP 60016, 60018 — and nearby Mount Prospect, Park Ridge, Elk Grove Village.

Working in Des Plaines

  • A lot of Des Plaines kitchens date from the 1960s. We know these layouts well and what is worth keeping.
  • Most Des Plaines homes are single-family. We protect floors and driveways and leave the site clean every day.
  • We know how Community and Economic Development Department - Building Division handles kitchen permits and pull them for you.

ZIP 60016ZIP 60018

Kitchen Sink Installation & Replacement nearby

Planning a kitchen project in Des Plaines?

Call us — we'll check your ZIP, answer your questions and book an in-home estimate.

Call now (708) 400-7049
Call (708) 400-7049Callback