Serving Buffalo Grove & nearby Arlington Heights, Palatine

Kitchen Faucet Installation in Buffalo Grove, IL

Pull-down, touchless and two-handle kitchen faucets installed leak-free by licensed plumbers in Buffalo Grove.

  • Serving Buffalo Grove ZIP 60089
  • Installed level, sealed and tested before we leave
  • Clear price for the install before the visit

Prefer a callback?

Leave your number and a Buffalo Grove licensed plumber will call you.

Kitchen faucet problems we fix in Buffalo Grove

Whether you picked a pull-down, a touchless or a bridge faucet, we fit it to your sink or counter in Buffalo Grove, cover or reuse the extra holes, and connect it with new supply lines.

Scale on the aerator from lake water

Treated Lake Michigan water still leaves some mineral scale in aerators and spray heads over time. Cleaning them restores the spray pattern.

Old two-handle faucet with a side sprayer

Many owners replace the old two-handle setup with a single lever and a pull-down spray. We cover the leftover holes with a deck plate.

Hole count doesn't match the new faucet

Sinks and counters have one to four holes. A deck plate covers unused holes, or they can hold a soap dispenser, side sprayer or filtered-water tap.

Low flow or a sputtering spout

A spout that spits or barely runs usually has debris or mineral buildup in the aerator. If cleaning doesn't help, the cartridge or supply valve may be partly blocked.

Shut-off valves that won't turn

Faucet swaps often stop at the valves: old multi-turn stops seize or leak when turned. We replace them with quarter-turn valves.

Pull-down sprayer that won't retract

Sprayer heads that droop often need the weight moved or a worn hose replaced. It's a quick fix.

Leak under the sink at the faucet lines

If the faucet looks fine on top but the cabinet is wet, check the lines under it. Worn supply hoses and spray hoses are common culprits.

Leaking from the handle

Water seeping out around the handle when the faucet runs is a cartridge or stem seal problem. Some brands make it easy to fix; others are cheaper to replace.

What we hook up and check

  • Check the sink and suppliesA check of the sink holes, shut-offs and clearances so the faucet fits.
  • Shut off and removeWater off, supply lines disconnected and the old faucet unbolted.
  • Clean the deckOld putty, caulk and mineral residue cleaned from the mounting surface.
  • Mount the faucetFaucet set with its gasket or deck plate and tightened from below.
  • Supply connectionsHot and cold lines hooked up to the valves.
  • Power for touchless modelsControl box mounted and battery pack or plug-in adapter set up.
  • Flush and testAerator off, lines flushed of debris, then every joint checked under pressure.

What to pick before the install

Pull-out faucetsGood under low cabinets or windows where a tall spout won't fit.
Touchless and touch faucetsHands-free models for messy hands, with a control box below.
Bridge and two-handle faucetsThree-hole faucets with a classic look, often with a side sprayer.
Pull-down faucetsA spray head that pulls down into the sink; the most popular kitchen style.
FinishesChrome wipes clean easily; matte and brushed finishes hide spots.

Before and after: kitchens near Buffalo Grove

Kitchen Faucet Installation in a 1980s-1990s two-story colonial / tract house — beforeBefore
Kitchen Faucet Installation in a 1980s-1990s two-story colonial / tract house — installedInstalled
Kitchen Faucet Installation in a 1980s-1990s two-story colonial / tract house — detailDetail

Before and after: a 1990s two-story colonial in Buffalo Grove

A 1990s two-story colonial near Green Knolls, a typical kitchen for Buffalo Grove. The kitchen as it was: white cast-iron double sink. The main complaint was an old two-handle faucet that dripped into a worn porcelain bowl. After: a new single-handle pull-down faucet with a clean caulk line. The job covered shut off and remove, clean the deck, plus flush and test.

Kitchen Faucet Installation project in Arlington Heights, beforeBefore
Kitchen Faucet Installation project in Arlington Heights, afterAfter

Before and after: a two-story colonial from the 1990s in Arlington Heights

This one is a two-story colonial from the 1990s in Arlington Heights. The kitchen as it was: solid-surface integrated sink. The reason for the call: a leaking faucet with handles that were hard to turn. Finished kitchen: a new single-handle pull-down faucet with a clean caulk line. Work included shut off and remove, supply connections, plus flush and test.

Kitchen Faucet Installation in Arlington Heights →
Kitchen Faucet Installation project in Palatine, beforeBefore
Kitchen Faucet Installation project in Palatine, afterAfter

Before and after: a 1990s two-story colonial in Palatine

The site: a 1990s two-story colonial in Palatine. The kitchen as it was: white double sink. What bothered the owners most: a leaking two-handle faucet with a side sprayer. The result: a new single-handle pull-down faucet with a clean caulk line. On site this meant shut off and remove, supply connections, plus power for touchless models.

Kitchen Faucet Installation in Palatine →
Kitchen Plumbing Relocation project near Buffalo Grove, beforeBefore
Kitchen Plumbing Relocation project near Buffalo Grove, afterAfter

Buffalo Grove kitchen, 1990s two-story colonial: kitchen plumbing relocation

Finished: a new island with a prep sink, the drain, vent and water lines relocated from the old wall.

Kitchen Plumbing Relocation in Buffalo Grove →
Kitchen Remodeling project near Buffalo Grove, beforeBefore
Kitchen Remodeling project near Buffalo Grove, afterAfter

A Buffalo Grove 1980s two-story: before and after

Cabinets in pale sage with unlacquered brass knobs and cup pulls, charcoal concrete-look quartz counters, a terracotta-look square tile backsplash, light oak hardwood flooring and black cage pendants and slim recessed lights.

Kitchen Remodeling in Buffalo Grove →

From the old unit to the new one

  1. Pick a faucetChoose one yourself or ask us what fits your sink and holes.
  2. Check the setupA quick look under the sink tells us what else the job needs.
  3. Written estimateYou get the price in writing, including any valve replacement.
  4. Install and testInstalled, flushed and checked for leaks, usually in one visit.

Kitchen Faucet Installation questions from Buffalo Grove homeowners

Can a handyman install a kitchen faucet?
Our faucet installs are done by licensed plumbers, which matters when a valve or supply line turns out to need replacing.
Are touchless faucets worth it?
Many owners like them. Expect to change batteries or use a plug-in adapter, and know there's a manual mode too.
Can you add a filtered-water faucet?
Yes. A separate filtered tap can use an existing hole or a new one, with the filter mounted under the sink.
Why is my faucet leaking from the base?
Usually failed internal O-rings at the swivel. Less often, the mounting gasket.
Can you install a faucet I already bought?
Of course. Have it on site, and we'll fit it with new supply lines.
Does faucet installation need a Buffalo Grove building permit, and who files it?
Permits go through Community Development Services, Building & Zoning Services (BS&A Online), phone 847-459-2530. When your scope needs one, we prepare the application and schedule the inspections.
Does Buffalo Grove have lead service lines?
Village publishes a Service Line Inventory (IEPA material inventory dated 2026) and a service line map. A filter certified for lead reduction is a sensible step until your line is confirmed or replaced.
Is Buffalo Grove water hard, and does it matter for faucet installation?
Buffalo Grove's water source: Lake Michigan water from the Evanston plant, delivered through the Northwest Water Commission (member municipality). Aerators and cartridges scale faster with harder water.
Buffalo Grove contractor registration: do kitchen contractors need it?
All contractors working in the Village must register annually; $75 per trade, no fee for state-licensed contractors. We take care of that before work starts.
Buffalo Grove plumbing code: who can do the plumbing for faucet installation?
Plumbing permit requires a letter of intent from the licensed plumber; contractors provide State of Illinois plumbing license and 055 contractor registration. Our plumbing connections are made by licensed plumbers.
Do I need a permit for faucet installation in Buffalo Grove?
It depends on the scope. Buffalo Grove's rule in short: Permit required to replace or modify a kitchen, including replacing cabinetry; replacing a sink or faucet needs a plumbing permit even in the same location; electrical must meet the 2017 NEC. We handle the permit when one is needed with Community Development Services, Building & Zoning Services.
Do you work in my part of Buffalo Grove?
Yes. Our crews work across Buffalo Grove, including The Highlands, Green Knolls, Windfield, Didier Farms — ZIP 60089 — and nearby Arlington Heights, Palatine, Lake Zurich.

Working in Buffalo Grove

  • A lot of Buffalo Grove kitchens date from the 1980s. We know these layouts well and what is worth keeping.
  • Most Buffalo Grove homes are single-family. We protect floors and driveways and leave the site clean every day.
  • We know how Community Development Services, Building & Zoning Services handles kitchen permits and pull them for you.

The HighlandsGreen KnollsWindfieldDidier Farms

ZIP 60089

Kitchen Faucet Installation nearby

Planning a kitchen project in Buffalo Grove?

Call us — we'll check your ZIP, answer your questions and book an in-home estimate.

Call now (708) 400-7049
Call (708) 400-7049Callback