Serving Aurora & nearby Batavia, Warrenville

Garbage Disposal Installation & Repair in Aurora, IL

Jammed, humming, leaking or dead garbage disposals repaired or replaced by licensed plumbers in Aurora.

  • Installers working in Aurora ZIP 60506, 60502, 60505, 60504, 60503
  • Hookups by licensed trades where the code calls for it
  • Old unit hauled away on request

Prefer a callback?

Leave your number and a Aurora licensed plumber will call you.

Garbage disposal problems we fix in Aurora

We repair and install garbage disposals in Aurora kitchens. That means clearing jams, tracing leaks, sizing a new unit to how you cook, and connecting it to the sink, the dishwasher and the power under the cabinet.

Dishwasher hose without a high loop or air gap

We set the dishwasher connection so dirty water can't run back toward the tub, using whichever method your village accepts.

Sink not draining with the disposal off

If the bowl over the disposal won't drain, the blockage is in the disposal outlet, the trap or the pipe behind the wall. We find it and clear it.

Grinding slowly or making loud noises

Rattling, clanking or slow grinding can mean a utensil or bone fragment inside, or worn grinding parts. We check it before deciding on repair or replacement.

Disposal too small for the household

Small, low-horsepower units bog down with busy-family loads. A larger motor grinds faster and jams less.

Old disposal rusting out

If the bottom of the disposal is rusted and the cabinet floor is stained, the unit is near the end. We swap it and check the drain fittings.

Disposal won't turn on at all

No sound at all points to power: the reset button, the breaker, the switch or the plug. We test each and replace the unit only if the motor is dead.

Disposal leaking from the bottom

A leak from the housing itself, not a pipe, is the end for that disposal. We remove it and install a new one with fresh connections.

Wall switch or wiring problems

A disposal that works only sometimes may have a failing switch or a loose connection. We check the power side along with the unit.

Included with the install

  • Diagnose the problemA look at the disposal, its wiring and the drain to see what actually failed.
  • Clear jamsPower off, the flywheel freed from below and the object removed.
  • Repair leaks at connectionsSink flange reseated, drain gasket and dishwasher inlet resealed.
  • Size the new disposalA unit sized for how much food goes down the sink.
  • Drain connectionDischarge elbow, trap and tailpieces set so the sink drains freely.
  • Dishwasher hookupKnockout plug removed, hose connected, high loop or air gap set as code requires.
  • Test and clean upFull test with the sink and dishwasher draining, then cleanup.

What to pick before the install

HorsepowerMore horsepower means more grinding power for bigger households and more cooking.
Septic-rated modelsModels built for septic systems, for owners whose septic service approves a disposal.
Continuous feedRuns from a wall switch while you feed food in; the most common type.
Sound insulationSound-dampened models for open kitchens.
Batch feedRuns only with the stopper lid in place, so no wall switch is needed.

Kitchens like yours in Aurora: before and after

Garbage Disposal Installation & Repair in a 1980s-1990s two-story colonial / tract house — beforeBefore
Garbage Disposal Installation & Repair in a 1980s-1990s two-story colonial / tract house — installedInstalled
Garbage Disposal Installation & Repair in a 1980s-1990s two-story colonial / tract house — detailDetail

An Aurora 1990s two-story colonial: before and after

A 1990s two-story colonial near Far East Side, a typical kitchen for Aurora. What we started with: solid-surface integrated sink. The reason for the call: an old disposal that hummed, jammed and leaked into the cabinet. After: a new garbage disposal installed under the sink with a clean dishwasher connection. The job covered clear jams, drain connection, plus dishwasher hookup.

Garbage Disposal Installation & Repair project in Batavia, beforeBefore
Garbage Disposal Installation & Repair project in Batavia, afterAfter

Before and after: a two-story colonial from the 1990s in Batavia

A two-story colonial from the 1990s in Batavia, a typical kitchen for Batavia. Before: white double sink. The main complaint was an old disposal that hummed, jammed and leaked into the cabinet. The result: a new garbage disposal installed under the sink with a clean dishwasher connection. On site this meant size the new disposal, drain connection, plus test and clean up.

Garbage Disposal Installation & Repair in Batavia →
Garbage Disposal Installation & Repair project in Naperville, beforeBefore
Garbage Disposal Installation & Repair project in Naperville, afterAfter

Garbage Disposal Installation & Repair in a 1990s two-story colonial, Naperville

The site: a 1990s two-story colonial near Tamarack. Before: white cast-iron double sink. The reason for the call: an old disposal that hummed, jammed and leaked into the cabinet. After: a new garbage disposal installed under the sink with a clean dishwasher connection. Work included diagnose the problem, drain connection, plus test and clean up.

Garbage Disposal Installation & Repair in Naperville →
Kitchen Drain Cleaning project near Aurora, beforeBefore
Kitchen Drain Cleaning project near Aurora, afterAfter

Aurora kitchen, 1990s two-story colonial: kitchen drain cleaning

Finished: the same sink draining clear after the kitchen line was cleaned with a drain cable.

Kitchen Drain Cleaning in Aurora →
Kitchen Remodeling project near Aurora, beforeBefore
Kitchen Remodeling project near Aurora, afterAfter

Kitchen Remodeling in a 1990s two-story colonial, Aurora

Finished: cabinets in white uppers and deep green lowers with unlacquered brass knobs and cup pulls, warm walnut butcher block counters, a green zellige-look tile backsplash, warm oak luxury vinyl plank flooring and recessed lights and under-cabinet LED strips.

Kitchen Remodeling in Aurora →

How the install goes

  1. Tell us what it's doingHumming, silent, leaking or slow: the symptom points to the fix.
  2. Diagnose on siteWe check the jam, reset, power and connections first.
  3. Written estimateYou get the repair or replacement price in writing before work starts.
  4. Repair or installWe fix the problem or install the new unit and connect it, usually in one visit.

Garbage Disposal Installation & Repair questions from Aurora homeowners

How long does it take to install a new garbage disposal?
Most replacements are done in one visit; extra time goes into drain rework or power.
What size disposal do I need?
Small units suit light use; families who cook a lot do better with a larger motor.
Repair or replace my disposal?
Jams, resets and connection leaks are repairs. Body leaks, a dead motor or an old, rusted unit call for replacement.
Do I need a plumber or an electrician?
If a switched outlet already exists, the plumber handles the swap. New wiring or a new switch is electrical work.
Can I have a disposal on a septic system?
It adds solids to the tank. Ask your septic professional; if they agree, we can install a septic-rated unit.
Does Aurora require a licensed plumber for disposal repair or replacement?
Interior plumbing work requires a permit. The City pages do not state plumber licensing rules (Illinois state license applies). Our plumbing connections are made by licensed plumbers.
What is the Aurora building department phone number?
Permits go through Division of Building and Permits, City of Aurora, phone (630) 256-3130. When your scope needs one, we prepare the application and schedule the inspections.
Aurora water: how does it affect disposal repair or replacement?
Aurora's water source: Fox River surface water plus deep and shallow wells (about 60% surface / 40% well, varies); reported hardness is 7 to 8 grains per gallon (120-137 mg/L). We plan fittings and filters around it.
Aurora contractor registration: do kitchen contractors need it?
Contractors must be registered/licensed with the City (application, required testing if applicable, proof of insurance naming the City as additional insured). Homeowners may act as own contractor if owner-occupied 6+ months with a Homeowner Liability Waiver. We take care of that before work starts.
Do I need a permit for disposal repair or replacement in Aurora?
It depends on the scope. Aurora's rule in short: Interior remodels, structural changes and interior plumbing always need a permit; electrical/mechanical may. We handle the permit when one is needed with Division of Building and Permits, City of Aurora.
Do you work in my part of Aurora?
Yes. Our crews work across Aurora, including Near Eastside, Tanner, Riddle Highlands, Palace Street — ZIP 60506, 60502, 60505, 60504, 60503 — and nearby Batavia, Warrenville, Naperville.

Working in Aurora

  • A lot of Aurora kitchens date from the 1990s. We know these layouts well and what is worth keeping.
  • Most Aurora homes are single-family. We protect floors and driveways and leave the site clean every day.
  • Live in a historic district? Interior kitchen work is usually not reviewed. We check before anything touches the exterior.

Near EastsideTannerRiddle HighlandsPalace StreetWest SideFar East Side

ZIP 60506ZIP 60502ZIP 60505ZIP 60504ZIP 60503

Garbage Disposal Installation & Repair nearby

Planning a kitchen project in Aurora?

Call us — we'll check your ZIP, answer your questions and book an in-home estimate.

Call now (708) 400-7049
Call (708) 400-7049Callback