1980s hood on an old duct
Original 1980s ventilation was sized for a different era of cooking. A modern hood often needs a larger duct and a new exterior cap.
Serving Winfield & nearby Wheaton, Carol Stream
Range Hood Installation in Winfield, IL
We install under-cabinet, wall chimney, island and insert range hoods in Winfield, ducted outside wherever the house allows.
- Installers working in Winfield ZIP 60190, 60185
- Hookups by licensed trades where the code calls for it
- Old unit hauled away on request
Range hood installs we handle in Winfield
Swapping a tired hood for a new one can be a short job, and adding a hood where there was none takes more planning. Either way, we work out in Winfield where the duct can run, what the wiring needs and whether the village wants a permit, before you order.
Custom hood cover that needs an insert
Wood or plaster hood covers need a liner or insert inside them. We install the insert, the duct and the wiring so the cover can be finished around it.
Hood too narrow for the cooktop
A hood narrower than the burners lets smoke roll past its edges. We usually match the cooktop width at a minimum, and go wider over gas or pro-style ranges.
Flexible foil duct behind the old hood
Flex duct sags, collects grease and is a poor choice for a kitchen exhaust. The new run goes in as rigid metal pipe, taped and supported.
Swapping an over-the-range microwave for a hood
Microwave vents capture far less than a real hood. We remove the microwave, check the duct and install a hood that fits the space.
High-CFM hood and makeup air
Very powerful hoods can pull more air out of a tight house than leaks back in. High-CFM hoods can trigger a makeup-air requirement under local code, and we check that before you choose one.
Island hood over a new island cooktop
Ventilating an island takes more planning than a wall hood: ceiling support, joist direction and the path out all decide where the hood can go.
Hood that vents into the attic or soffit
Venting into a soffit or attic space only moves the problem out of sight. The exhaust has to terminate outside the building envelope.
Included with the install
- Site check and sizingCooktop width, fuel type and duct path are checked before a model is chosen.
- Permit and approvalsPermits, condo approvals and any makeup-air requirement are confirmed up front.
- Removing the old hoodPower off, old hood disconnected and taken down, the old duct inspected or removed.
- Blocking and mountingSolid wood blocking added in the wall or ceiling so the hood is anchored to framing.
- Duct runRigid smooth metal duct sized to the hood outlet, joints sealed with foil tape and supported.
- Wall cap or roof jackExterior wall cap or roof jack with a backdraft damper, flashed and sealed against weather.
- Electrical connectionThe hood connected to a suitable circuit; new wiring or switches are run by an electrician.
Models, parts and fittings
Ducted vs recirculatingDucted hoods send air outside; recirculating hoods filter it through charcoal and return it to the room.
Island hoodsHoods suspended above an island, supported from the ceiling framing.
Wall chimney hoodsWall-mounted hoods with a tall cover, often used where there is no cabinet above the range.
Under-cabinet hoodsThe most common style, tucked under the upper cabinet above the range.
Duct, caps and dampersRigid galvanized or stainless duct, wall caps and roof jacks with backdraft dampers.
Kitchens like yours in Winfield: before and after
Before
Installed
DetailA Winfield two-story colonial from the 1990s: before and after
This one is a two-story colonial from the 1990s in Winfield. The kitchen as it was: white appliances and white thermofoil cabinets peeling at the edges, oak trim. What bothered the owners most: a recirculating hood that left the kitchen smoky. The result: a new stainless chimney range hood ducted to the outside. The job covered permit and approvals, duct run, plus electrical connection.
Before
AfterA Wheaton 1980s two-story: before and after
A 1980s two-story near Wheaton Center, a typical kitchen for Wheaton. Before: black appliances and golden-oak cabinets with oak soffits above. The reason for the call: cooking smells that stayed in the house for hours. Finished kitchen: a new stainless chimney range hood ducted to the outside. On site this meant permit and approvals, wall cap or roof jack, plus electrical connection.
Range Hood Installation in Wheaton →
Before
AfterKitchen Remodeling in a 1990s two-story colonial, Winfield
What changed: cabinets in light butter yellow with satin brass pulls, charcoal concrete-look quartz counters, a terracotta-look square tile backsplash, gray wood-look porcelain plank flooring and two glass pendants and recessed lights.
Kitchen Remodeling in Winfield →
Before
AfterKitchen Cabinet Painting in a 1990s two-story colonial, Winfield
The same doors sprayed in light sand beige, new brushed nickel bar pulls; counters and floor stayed as they were.
Kitchen Cabinet Painting in Winfield →Install day
- Photos and modelTell us what you cook on and show us the space; a model number helps.
- Duct route and sizingOn site we size the hood, pick the duct route and check permits and makeup air.
- Written estimateAn itemized estimate for the hood install, duct, exterior cap, wiring and any permit.
- Install and testWe install, test the airflow and clean up the same day in most cases.
Range Hood Installation questions from Winfield homeowners
What size range hood do I need?
Width should usually be at least the width of the cooktop, and more over a gas or pro-style range. Fan capacity is chosen along with the duct size.
Do I need an electrician to install a range hood?
Not when a suitable power supply is already there; we connect the hood to it. A new circuit or switch is run by an electrician.
Who installs a range hood: a plumber, an electrician or a contractor?
A contractor who handles ducting and mounting is the right call. Plumbers don't usually do hoods; new circuits go to an electrician.
How many CFM does my range hood need?
We size airflow to your cooktop and your duct. Buying the biggest fan made rarely helps if the duct can't carry it.
How much does range hood installation cost?
It depends on the hood type, whether a new duct and exterior cap are needed, wiring and any permit. We give a written, itemized estimate after the visit.
Winfield building permit for range hood installation: where do I apply?
Permits go through Building and Safety / Community Development (Village of Winfield), phone 630-665-1767. When your scope needs one, we prepare the application and schedule the inspections.
Do you work in my part of Winfield?
Yes. Our crews work across Winfield — ZIP 60190, 60185 — and nearby Wheaton, Carol Stream, West Chicago.
Working in Winfield
- A lot of Winfield kitchens date from the 1980s. We know these layouts well and what is worth keeping.
- Most Winfield homes are single-family. We protect floors and driveways and leave the site clean every day.
ZIP 60190ZIP 60185
Range Hood Installation nearby
Other kitchen services in Winfield
Range Hood RepairFans, motors, switches, lights and rattles on kitchen range hoods.
Oven, Range & Cooktop InstallationGas and electric ranges, wall ovens and cooktops, safely connected.
Kitchen Electrical WorkNew circuits and outlets for kitchen appliances.
Kitchen RemodelingFull kitchen remodels, from layout to last cabinet pull.
Kitchen Cabinet PaintingFactory-smooth painted cabinets without replacing them.