Fan not working but the light is
Working lights mean the hood has power. A dead fan then points to the switch, the control board, a thermal cutoff or a failed motor.
Serving Tinley Park & nearby Orland Park, Woodridge
Range Hood Repair in Tinley Park, IL
Fan dead, lights out or a hood that rattles and roars? We repair range hoods in Tinley Park and tell you plainly when replacing makes more sense.
- Technicians covering Tinley Park ZIP 60477, 60487
- Diagnosis first, then a written price for the repair
- Honest advice when replacing makes more sense
Range hood problems we fix in Tinley Park
Most range hood failures come down to a handful of parts: the fan motor, the blower wheel, the switch or control board, the lights and the backdraft damper. In Tinley Park we find which one has quit, replace it with the right part and make sure the hood pulls air again.
Fan runs but barely pulls air
If the fan spins but smoke still rolls past, we check the filters, the wheel, the duct and the exterior cap before blaming the motor.
Buttons or touch panel not responding
When some buttons work and others don't, the keypad membrane is often worn. A full lockup is more often the control board.
Dripping grease or water from the hood
Grease dripping from the hood usually means saturated filters or a grease-filled duct. Water usually means condensation or a leak at the exterior cap.
Hood that hums but won't spin
Humming without spinning is a classic sign the motor is getting power but can't start. Often a new motor is the fix.
Fan won't turn off
Some hoods have a heat sensor that starts the fan automatically when the cooktop is hot; if it runs with everything cold, the control is at fault.
Fan stuck on one speed
A fan that ignores the speed buttons often has a worn switch or a failing board, both of which can be replaced.
Backdraft damper stuck open or shut
Dampers at the hood or the wall cap get gummed up with grease. We clean or replace them so they open with the fan and close after.
Where we look first
- Fan motor replacementWorn or seized motors replaced with a motor matched to the hood.
- Blower wheel serviceThe wheel removed, degreased and balanced, or swapped for a new one.
- Switches and control boardsFaulty controls swapped so every speed and setting responds again.
- Lights and socketsBulbs, sockets, LED modules and light switches replaced to match the hood.
- Filter replacementNew grease or charcoal filters fitted when the old ones are worn out.
- Noise and vibration fixesVibration traced and fixed at the motor, wheel or hood mounting.
- Final testWe run the hood and check airflow before we leave.
Common fixes and parts
Under-cabinet and chimney hoodsWall and under-cabinet hoods serviced in place without removing cabinets.
Island hoods and insertsCeiling-hung and built-in hoods, often with internal or inline blowers.
Fan motors and blower wheelsThe parts that move air, and the ones most often worn out.
FiltersMesh and baffle grease filters, plus charcoal filters on recirculating hoods.
Switches, keypads and boardsMechanical rocker or slide switches on simpler hoods; touch keypads and control boards on newer ones.
Before and after: kitchens near Tinley Park
Problem
Fixed
DetailTinley Park kitchen, 1990s two-story colonial: range hood repair
The site: a 1990s two-story colonial in Tinley Park. What we started with: black appliances and two hanging glass pendants. The main complaint was a hood fan that stopped working. After: the same hood with a new fan motor and working LED lights. Work included switches and control boards, lights and sockets, plus final test.
Before
AfterBefore and after: a 1980s two-story in Orland Park
This one is a 1980s two-story in Orland Park. Before: white appliances and a brass chandelier over the nook. What bothered the owners most: a hood fan that stopped working. Finished kitchen: the same hood with a new fan motor and working LED lights. The job covered switches and control boards, filter replacement, plus noise and vibration fixes.
Range Hood Repair in Orland Park →
Before
AfterBefore and after: a 1990s two-story colonial in Bolingbrook
A 1990s two-story colonial near Colonial Village, a typical kitchen for Bolingbrook. The kitchen as it was: almond appliances and a fluorescent box light in the ceiling. The main complaint was a hood that rattled every time it ran. The result: the same hood with a new fan motor and working LED lights. Work included lights and sockets, filter replacement, plus final test.
Range Hood Repair in Bolingbrook →
Before
AfterBefore and after: a 1990s two-story colonial in Tinley Park
What changed: the same hood with clean, shining filters.
Residential Kitchen Hood Cleaning in Tinley Park →
Before
AfterBefore and after: a 1980s two-story in Tinley Park
Finished: cabinets in white uppers and deep green lowers with polished nickel pulls, dark soapstone-look quartz counters, a white herringbone tile backsplash, warm oak luxury vinyl plank flooring and a flush drum fixture and under-cabinet lights.
Kitchen Remodeling in Tinley Park →From diagnosis to fixed
- Describe the problemTell us what the hood does or doesn't do, and send the brand and model from the label inside.
- Diagnosis on siteA technician checks the power, controls, motor and damper.
- Repair or replaceWe explain what failed and whether the fix is worth it on your hood.
- Fix and testWe repair, reassemble and run the hood before leaving.
Range Hood Repair questions from Tinley Park homeowners
Why do I feel cold air coming from my hood?
The backdraft damper isn't closing. Grease, a bent flap or a missing damper lets outside air in.
Why does my range hood fan not work but the light does?
Because the light and fan run on separate circuits inside the hood. A failed fan switch, speed control, thermal cutoff or motor is usually behind it.
Can you replace just the fan motor?
In most hoods, yes. We bring or order the motor for your model.
When should I replace a range hood instead of repairing it?
If the repair costs close to a new hood, or the old one never vented well, replacement is the better spend.
What bulb does my range hood need?
Hoods use several bulb types. We match the right one, or the LED part, to your model.
Do I need a permit for range hood repair in Tinley Park?
It depends on the scope. Tinley Park's rule in short: Permit required before construction, alteration or repair; extensive remodeling needs a permit. We handle the permit when one is needed with Building Department (Community Development).
Do you work in my part of Tinley Park?
Yes. Our crews work across Tinley Park — ZIP 60477, 60487 — and nearby Orland Park, Woodridge, Bolingbrook.
Working in Tinley Park
- A lot of Tinley Park kitchens date from the 2000s. We know these layouts well and what is worth keeping.
- Most Tinley Park homes are single-family. We protect floors and driveways and leave the site clean every day.
- We know how Building Department (Community Development) handles kitchen permits and pull them for you.
ZIP 60477ZIP 60487
Range Hood Repair nearby
- Range Hood Repair in Orland Park 3.9 mi
- Range Hood Repair in Woodridge 17.0 mi
- Range Hood Repair in Bolingbrook 17.6 mi
- Range Hood Repair in Berwyn 19.0 mi
Other kitchen services in Tinley Park
Range Hood InstallationUnder-cabinet, chimney, island and insert hoods, ducted to the outside.
Residential Kitchen Hood CleaningDegreased filters, fan, hood interior and the duct you can reach.
Kitchen RemodelingFull kitchen remodels, from layout to last cabinet pull.
Kitchen Cabinet PaintingFactory-smooth painted cabinets without replacing them.
Cabinet RefacingNew doors and fronts on your existing cabinet boxes.