Dark counters and shadows where you work
We fix shadowed counters by adding task light under the wall cabinets and placing ceiling fixtures toward the front of the counters instead of the room's center.
Serving Tinley Park & nearby Orland Park, Woodridge
Kitchen Lighting Installation in Tinley Park, IL
Recessed, pendant and under-cabinet lighting for Tinley Park kitchens, laid out so the counters are bright and wired by a licensed electrician.
- Serving Tinley Park ZIP 60477, 60487
- A new look without tearing the kitchen out
- Clean, protected work area every day
Kitchen lighting problems we solve in Tinley Park
Most kitchens have enough light in the middle of the floor and too little where you actually chop and read recipes. In Tinley Park we plan lighting in layers: recessed or ceiling light for the room, under-cabinet strips for the counters, pendants over the island, each on its own switch or dimmer.
Light over the sink
The sink is where you need light most and often have the least. A recessed light or small pendant above it solves that.
Visible LED dots and glare under the cabinets
Glare and dotted reflections come from bare strips placed too far back. A covered channel near the front edge spreads the light evenly.
Fluorescent box or panel that hums and flickers
Fluorescent tubes and ballasts wear out and are hard to dim. A switch to LED fixtures gives steadier light and dimming.
Pendants over the island
Two or three pendants, or one long linear fixture, are common over an island. We place the boxes so the lights line up with the island, not the old ceiling layout.
Under-cabinet lighting: hardwired or plug-in?
Hardwired LED strips run from a wall switch with the driver hidden in a cabinet, and the wiring disappears. Plug-in kits are simpler but leave a cord to an outlet.
Switches in the wrong place or one switch for everything
A switch on the far side of the room is a daily nuisance. We move or add controls where you walk in.
LEDs that flicker or buzz on the dimmer
Older dimmers weren't made for LED loads and can cause flicker, buzz or lights that won't dim low. We install LED-compatible dimmers matched to the fixtures.
What the work covers
- Lighting layoutA plan for ceiling, task, island and accent light, with fixture positions and switching.
- Wiring and circuit checkWe confirm the lighting circuit can carry the new fixtures.
- Old fixtures removedFluorescent boxes, old cans and outdated fixtures taken down and wiring made safe.
- Wire fished to fixtures and switchesWe pull wire from the switch to each fixture location.
- Fixtures installedEach fixture hung, leveled and wired.
- Switches and dimmersLED-compatible dimmers and separate switches for each lighting layer.
- Patching and cleanupAccess holes patched and the kitchen cleaned of dust.
Materials and finishes
Recessed lightingCanless LED wafers or housings with LED trims, IC-rated where insulation is present.
Accent lightingIn-cabinet lights for glass doors, toe-kick strips and lighting above the cabinets.
Pendants and linear fixturesHanging fixtures that light the island and set the style.
Under-cabinet LEDTask lighting aimed straight at the counters.
Color temperature optionsLEDs in a consistent, warm color with good rendering.
Kitchen Lighting Installation before and after — Tinley Park homes
Before
AfterBefore and after: a two-story colonial from the 1990s in Tinley Park
A two-story colonial from the 1990s in Tinley Park, a typical kitchen for Tinley Park. What we started with: a brass chandelier over the nook. The reason for the call: one ceiling fixture lighting the whole room. Finished kitchen: two glass pendants and recessed lights on separate switches. The job covered old fixtures removed, wire fished to fixtures and switches, plus fixtures installed.
Before
AfterBefore and after: a two-story colonial from the 1990s in Woodridge
This one is a two-story colonial from the 1990s near Seven Bridges. What we started with: two hanging glass pendants. The reason for the call: old lights that no longer matched the kitchen. Finished kitchen: black cage pendants and slim recessed lights on separate switches. Work included lighting layout, old fixtures removed, plus wire fished to fixtures and switches.
Kitchen Lighting Installation in Woodridge →
Before
AfterKitchen Lighting Installation in a brick bungalow from the 1920s, Berwyn
The site: a brick bungalow from the 1920s near Ogden Avenue. Before: a single pendant bowl light. What bothered the owners most: a single old light that left the counters in shadow. Finished kitchen: a flush drum fixture and under-cabinet lights on separate switches. Work included lighting layout, wiring and circuit check, plus old fixtures removed.
Kitchen Lighting Installation in Berwyn →
Before
AfterKitchen Remodeling in a 1990s two-story colonial, Tinley Park
Cabinets in white uppers and deep green lowers with polished nickel pulls, dark soapstone-look quartz counters, a white herringbone tile backsplash, warm oak luxury vinyl plank flooring and a flush drum fixture and under-cabinet lights.
Kitchen Remodeling in Tinley Park →
Before
AfterKitchen Cabinet Painting in a 1980s two-story, Tinley Park
Finished: the same doors sprayed in light butter yellow, new brushed nickel bar pulls; counters and floor stayed as they were.
Kitchen Cabinet Painting in Tinley Park →How your kitchen lighting project goes
- Share photos and plansTell us what feels too dark and what lights you have in mind.
- Layout visitWe check the ceiling type, joists, insulation and wiring, and mark fixture positions.
- Written estimateA clear written price before any ceiling is cut.
- Install and testFixtures wired and mounted, dimmers set, ceiling patched and everything tested.
Kitchen Lighting Installation questions from Tinley Park homeowners
Can recessed lights go into a plaster ceiling?
Yes. Plaster needs careful cutting and sometimes added support, and slim canless fixtures often fit best.
Do I need a permit for kitchen lighting?
Often when new circuits are added; simple fixture replacements usually don't need one. We check with the village before work starts.
What's the best lighting for a small kitchen?
Bright, even ceiling light plus task lighting under the cabinets. We size the fixtures so they don't crowd the room.
Can you install fixtures I already bought?
Yes. Many owners pick their own fixtures and we handle the wiring and mounting.
How high should pendants hang over an island?
The bottom of the fixture usually sits around 30 to 36 inches above the counter, adjusted to your height and sight lines.
What does Tinley Park ask for on electrical work?
Changing electric service must be done by a licensed electrical contractor. New circuits and wiring are done by licensed electricians.
Tinley Park contractor registration: do kitchen contractors need it?
Village contractor license required for all contractors; $100/year general, $50/year subcontractor. We take care of that before work starts.
Does kitchen lighting project need a Tinley Park building permit, and who files it?
Permits go through Building Department (Community Development), phone 708-444-5100. When your scope needs one, we prepare the application and schedule the inspections.
Do I need a permit for kitchen lighting project in Tinley Park?
It depends on the scope. Tinley Park's rule in short: Permit required before construction, alteration or repair; extensive remodeling needs a permit. We handle the permit when one is needed with Building Department (Community Development).
Do you work in my part of Tinley Park?
Yes. Our crews work across Tinley Park — ZIP 60477, 60487 — and nearby Orland Park, Woodridge, Bolingbrook.
Working in Tinley Park
- A lot of Tinley Park kitchens date from the 2000s. We know these layouts well and what is worth keeping.
- Most Tinley Park homes are single-family. We protect floors and driveways and leave the site clean every day.
- We know how Building Department (Community Development) handles kitchen permits and pull them for you.
ZIP 60477ZIP 60487
Kitchen Lighting Installation nearby
Other kitchen services in Tinley Park
Kitchen RemodelingFull kitchen remodels, from layout to last cabinet pull.
Kitchen Cabinet PaintingFactory-smooth painted cabinets without replacing them.
Cabinet RefacingNew doors and fronts on your existing cabinet boxes.
Countertop Fabrication & InstallationQuartz, granite and butcher block, templated and installed.
Kitchen Backsplash InstallationTile backsplashes with clean lines and flush outlets.