Serving Skokie & nearby Evanston, Park Ridge

Oven, Range & Cooktop Installation in Skokie, IL

We install gas and electric ranges, wall ovens and cooktops in Skokie, connected safely, leveled and checked before we go.

  • Installers working in Skokie ZIP 60076, 60077, 60203
  • Hookups by licensed trades where the code calls for it
  • Old unit hauled away on request

Prefer a callback?

Leave your number and a Skokie range and oven installer will call you.

Range, oven and cooktop installs we handle in Skokie

A new range has to do more than fit the gap. In Skokie we check the gas or electrical supply first, connect the unit per the maker's instructions, put in the anti-tip bracket, level it and test every burner or element before calling it done.

1950s wall oven and cooktop combo

Kitchens from the 1950s often have a built-in wall oven and a separate cooktop. We replace them with modern units sized to the old cutouts or rework the cabinets.

Cooktop cutout in the wrong size

Cutout dimensions come from the installation guide, not the old cooktop. We check them against your counter before you order.

Double wall oven on an undersized circuit

Older wiring to a wall oven is often too light for a modern double unit. We confirm the circuit and have it upgraded when needed.

New range delivered but not hooked up

If the store left your new stove unconnected, we finish the job: gas or power connected, anti-tip bracket installed, unit leveled and tested.

Slide-in range that won't sit flush

A slide-in is less forgiving than a freestanding range. We measure the cutout first and set the unit so its cooktop overlaps the counter evenly.

Switching from gas to induction

Induction usually needs a 240-volt circuit with more capacity than an old outlet provides. An electrician checks the panel, runs the circuit and we cap the gas line at the valve.

Switching from electric to gas

Electric-to-gas conversions are a small plumbing project. The new line is installed under permit, and the old 240-volt outlet is dealt with safely.

Range that tips forward when the oven door opens

If you can rock the range by leaning on the door, it isn't anchored. We add the maker's bracket and slide the unit back until it locks in.

What we hook up and check

  • Supply and opening checkWe look at the gas shutoff or circuit, measure the opening and compare it to the new unit's specs.
  • Cabinet and counter adjustmentsOpenings trimmed or reinforced so the new appliance fits and is supported.
  • Gas connectionGas hookup with a new connector, each joint checked with a leak detector solution.
  • Electrical connectionThe appliance tied into the correct 240-volt or 120-volt supply, with panel and circuit work handled by an electrician.
  • Wall oven and cooktop mountingBuilt-in units secured with the maker's brackets and screws.
  • Burner, element and oven testWe run the cooktop and oven so you see it working before we leave.
  • Haul-away and cleanupWe remove the old unit, cartons and debris.

What to pick before the install

Gas, electric and dual-fuelGas burners with a gas or electric oven; dual-fuel units need both a gas line and a 240-volt circuit.
Freestanding rangesFinished sides, controls on the backguard, the easiest to install and replace.
Gas and electric cooktopsDrop-in cooktops in the counter, with gas, radiant electric or induction heat.
Slide-in and front-control rangesControls on the front, no backguard, the cooktop overlapping the counter for a built-in look.
Induction cooktops and rangesElectric cooking with quick response and a cool glass top around the pan.

Before and after: kitchens near Skokie

Oven, Range & Cooktop Installation in a 1980s-1990s two-story colonial / tract house — beforeBefore
Oven, Range & Cooktop Installation in a 1980s-1990s two-story colonial / tract house — installedInstalled
Oven, Range & Cooktop Installation in a 1980s-1990s two-story colonial / tract house — detailDetail

Oven, Range & Cooktop Installation in a two-story colonial from the 1990s, Skokie

This one is a two-story colonial from the 1990s in Skokie. What we started with: white appliances. The reason for the call: an old stove that needed replacing. The result: a new stainless range installed level with a new gas connector. The job covered supply and opening check, electrical connection, plus burner, element and oven test.

Oven, Range & Cooktop Installation project in Evanston, beforeBefore
Oven, Range & Cooktop Installation project in Evanston, afterAfter

Evanston kitchen, prewar foursquare: oven, range & cooktop installation

A prewar foursquare in Evanston, a typical kitchen for Evanston. What we started with: a white range and a white refrigerator. The reason for the call: a new range waiting to be connected. Finished kitchen: a new stainless range installed level with a new gas connector. On site this meant supply and opening check, burner, element and oven test, plus haul-away and cleanup.

Oven, Range & Cooktop Installation in Evanston →
Oven, Range & Cooktop Installation project in Park Ridge, beforeBefore
Oven, Range & Cooktop Installation project in Park Ridge, afterAfter

Oven, Range & Cooktop Installation in a 1980s two-story, Park Ridge

A 1980s two-story in Park Ridge, a typical kitchen for Park Ridge. The kitchen as it was: black appliances. The reason for the call: a new range waiting to be connected. Finished kitchen: a new stainless range installed level with a new gas connector. On site this meant supply and opening check, gas connection, plus wall oven and cooktop mounting.

Oven, Range & Cooktop Installation in Park Ridge →
Kitchen Remodeling project near Skokie, beforeBefore
Kitchen Remodeling project near Skokie, afterAfter

Skokie kitchen, postwar Cape Cod: kitchen remodeling

Finished: cabinets in light butter yellow with polished nickel pulls, black honed granite counters, a gray beveled subway tile backsplash, light oak hardwood flooring and two glass pendants and recessed lights.

Kitchen Remodeling in Skokie →
Kitchen Cabinet Painting project near Skokie, beforeBefore
Kitchen Cabinet Painting project near Skokie, afterAfter

A Skokie 1950s ranch: before and after

What changed: the same doors sprayed in powder blue, new satin brass pulls; counters and floor stayed as they were.

Kitchen Cabinet Painting in Skokie →

From the old unit to the new one

  1. Model and photosTell us what you're installing, and show us the current hookup.
  2. Readiness checkWe compare your kitchen with the installation guide and list what needs to change.
  3. Written estimateA clear written price with any permit, gas or circuit work listed separately.
  4. Install and testOld unit out, new one connected, anchored, leveled and tested burner by burner.

Oven, Range & Cooktop Installation questions from Skokie homeowners

Do you install ranges and ovens I bought elsewhere?
We do. Send the model number and we bring the right connector and parts.
Does a gas range need to be professionally installed?
We recommend it. A gas range needs a new connector, tight joints, a leak check, an anti-tip bracket and a burner test.
Will you haul away my old stove?
We do. Removal of the old unit can be included in the same visit.
How much does range or oven installation cost?
The fuel type, cutout work, new gas line or circuit and haul-away drive the price. We put it in writing after the visit.
Can a gas range be converted to propane?
Often yes, using the maker's LP kit. The orifices and regulator are changed, then the burners are tested.
Skokie contractor registration: do kitchen contractors need it?
Many contractors must be registered and insured with the Village each year; permits are not issued unless all listed contractors are registered and insured. We take care of that before work starts.
Can Skokie bulk pickup take my old appliance or cabinets?
One large item or two small items at the curb weekly on regular refuse day, no appointment, out by 7 a.m. and no more than 24 hours ahead. If you'd rather not deal with it, we haul old units and debris away.
What is the Skokie building department phone number?
Permits go through Community Development Department - Building & Inspection Services Division (www.skokiepermits.com), phone (847) 933-8223. When your scope needs one, we prepare the application and schedule the inspections.
Do I need a permit for range or oven installation in Skokie?
It depends on the scope. Skokie's rule in short: Electrical work and plumbing or electrical system changes need a permit. We handle the permit when one is needed with Community Development Department - Building & Inspection Services Division.
Do you work in my part of Skokie?
Yes. Our crews work across Skokie — ZIP 60076, 60077, 60203 — and nearby Evanston, Park Ridge, Glenview.

Working in Skokie

  • A lot of Skokie kitchens date from the 1950s. We know these layouts well and what is worth keeping.
  • Most Skokie homes are single-family. We protect floors and driveways and leave the site clean every day.
  • We know how Community Development Department - Building & Inspection Services Division handles kitchen permits and pull them for you.

ZIP 60076ZIP 60077ZIP 60203

Oven, Range & Cooktop Installation nearby

Planning a kitchen project in Skokie?

Call us — we'll check your ZIP, answer your questions and book an in-home estimate.

Call now (708) 400-7049
Call (708) 400-7049Callback