Smoke residue in the rest of the house
Residue goes where the air goes. We inspect adjoining rooms and recommend duct cleaning when the system ran during the fire.
Serving Park Ridge & nearby Des Plaines, Glenview
Kitchen Fire & Smoke Restoration in Park Ridge, IL
Stovetop fire or smoke damage in your Park Ridge kitchen? We clean soot, remove smoke odor and rebuild what burned.
- Serving Park Ridge ZIP 60068
- Containment so the damage doesn't spread
- One team from cleanup to rebuild
Fire and smoke damage we restore in Park Ridge kitchens
After a grease fire, the cabinets above the range may be charred while the rest of the kitchen is coated in a greasy film you can smell for weeks. Our Park Ridge crew sorts out what can be cleaned and what has to be replaced, then does both.
Burned or charred cabinets
Cabinets with scorched faces or charred wood are replaced. Neighboring cabinets with only soot can often be cleaned and refinished to match.
Black soot on the ceiling and upper cabinets
Ceilings and cabinet tops catch most of the smoke. We clean, prime and paint so stains don't bleed through.
Grease fire on the stovetop
Grease fires leave a sticky, dark film that ordinary cleaners smear. We use the right cleaning approach for that soot and replace what was charred.
Damaged range hood or microwave above the range
A melted or soot-filled hood is replaced, and the duct is checked for grease and damage before the new one goes up.
Smoke smell that won't go away
If the kitchen still smells weeks later, residue is left somewhere, often inside cabinets, the hood ductwork or wall cavities. We find it and remove it.
Water and extinguisher residue
Dry chemical extinguisher powder spreads everywhere and can be corrosive. We clean it from surfaces, appliances and inside cabinets.
Melted outlets, wiring or switches
Heat near the range can damage outlets, switches and wiring. A licensed electrician checks the circuits before the kitchen is used again.
What the restoration covers
- Electrical checkCircuits near the fire are checked by a licensed electrician before power is relied on in the kitchen.
- Protecting the rest of the houseUnaffected rooms are closed off and floors covered so soot isn't tracked through.
- Removing burned materialsEverything that burned comes out first.
- Soot cleaningCeilings, walls, cabinets and appliances are cleaned with methods suited to the type of soot.
- Cabinet interiors and contentsInside the cabinets and drawers, shelves are cleaned since smoke gets in behind closed doors.
- Odor removalRemaining smoke odor is treated once the residue is gone.
- RebuildNew cabinets, hood, counters, drywall and fixtures are installed to match or update the kitchen.
Methods and equipment
Dry soot spongesThe first pass on ceilings and walls, so residue isn't smeared.
Replacement cabinets and hoodMatching boxes and doors for the burned section and a new ventilation hood.
Degreasing cleanersCleaners suited to oily grease-fire residue on cabinets and walls.
HEPA vacuums and air scrubbersFiltration that keeps loose particles from spreading.
Odor treatment equipmentThermal foggers, ozone or hydroxyl units used after cleaning when odor remains.
Kitchens like yours in Park Ridge: before and after
Problem
Fixed
DetailPark Ridge kitchen, 1980s two-story: kitchen fire & smoke restoration
This one is a 1980s two-story in Park Ridge. What we started with: golden-oak cabinets with oak soffits above and two hanging glass pendants. The main complaint was a grease fire that scorched the upper cabinets. After: the ceiling cleaned, sealed and repainted, new upper cabinets and a new range hood above the stove. Work included cabinet interiors and contents, odor removal, plus rebuild.
Before
AfterBefore and after: a 1980s two-story in Des Plaines
This one is a 1980s two-story in Des Plaines. What we started with: white thermofoil cabinets peeling at the edges, oak trim and a brass chandelier over the nook. The main complaint was a grease fire that scorched the upper cabinets. After: the ceiling cleaned, sealed and repainted, new upper cabinets and a new range hood above the stove. The job covered electrical check, cabinet interiors and contents, plus rebuild.
Kitchen Fire & Smoke Restoration in Des Plaines →
Before
AfterBefore and after: a 1980s two-story in Skokie
The site: a 1980s two-story in Skokie. What we started with: honey-oak cathedral raised-panel cabinets with worn finish near the handles, brass knobs and a fluorescent box light in the ceiling. The main complaint was smoke-blackened wood cabinets above the range. The result: the ceiling cleaned, sealed and repainted, new upper cabinets and a new range hood above the stove. The job covered electrical check, odor removal, plus rebuild.
Kitchen Fire & Smoke Restoration in Skokie →
Before
AfterBefore and after: a postwar Cape Cod in Park Ridge
Finished: cabinets in forest green with matte black pulls, black honed granite counters, a green zellige-look tile backsplash, warm oak luxury vinyl plank flooring and a flush drum fixture and under-cabinet lights.
Kitchen Remodeling in Park Ridge →
Before
AfterA Park Ridge postwar Cape Cod: before and after
Finished: the same doors sprayed in light warm taupe, new unlacquered brass knobs and cup pulls; counters and floor stayed as they were.
Kitchen Cabinet Painting in Park Ridge →What happens after you call
- Call us after the fire is outOnce the fire department has cleared the house, call us and we'll tell you how fast we can be there.
- Assess and protectA walkthrough, photos for your insurer and protection for the rest of the house.
- Clean and deodorizeBurned materials come out, soot is cleaned and odor is treated.
- RebuildNew cabinets, hood, paint and finishes put the kitchen back together.
Kitchen Fire & Smoke Restoration questions from Park Ridge homeowners
How do I get a fire report in Park Ridge?
Contact the fire department that responded; they can tell you how to request the incident report. Your insurer may ask for it.
Can a kitchen with fire damage be repaired?
In most cases, yes. We replace what burned and restore the smoke-damaged parts.
What should I do if I have a kitchen fire?
Cover a pan fire with a lid, turn off the heat and don't move the pan. Water spreads grease fires. If it grows, get everyone out and call 911.
Should cabinets be cleaned or replaced after a fire?
It depends on heat exposure. Doors with blistered finish or charring go; smoke-stained ones are cleaned.
Can I clean smoke damage myself?
Use dry soot sponges first, not water. If the soot is widespread or the smell persists, it's a professional job.
Do I need a permit for kitchen fire and smoke restoration in Park Ridge?
It depends on the scope. Park Ridge's rule in short: Park Ridge publishes permit guidelines by project type; contact the Permit Technicians to confirm whether a kitchen project needs a permit. We handle the permit when one is needed.
Do you work in my part of Park Ridge?
Yes. Our crews work across Park Ridge — ZIP 60068 — and nearby Des Plaines, Glenview, Skokie.
Working in Park Ridge
- A lot of Park Ridge kitchens date from the 1950s. We know these layouts well and what is worth keeping.
- Most Park Ridge homes are single-family. We protect floors and driveways and leave the site clean every day.
- We know how Park Ridge building department handles kitchen permits and pull them for you.
ZIP 60068
Kitchen Fire & Smoke Restoration nearby
Other kitchen services in Park Ridge
Kitchen Water Damage RestorationLeaks stopped, water extracted, cabinets and floors dried and rebuilt.
Kitchen Mold RemediationMoisture source fixed, mold contained and removed, kitchen rebuilt.
Kitchen RemodelingFull kitchen remodels, from layout to last cabinet pull.
Kitchen Cabinet PaintingFactory-smooth painted cabinets without replacing them.
Cabinet RefacingNew doors and fronts on your existing cabinet boxes.