Serving Orland Park & nearby Tinley Park, Woodridge

Range Hood Installation in Orland Park, IL

We install under-cabinet, wall chimney, island and insert range hoods in Orland Park, ducted outside wherever the house allows.

  • Serving Orland Park ZIP 60462, 60467
  • Installed level, sealed and tested before we leave
  • Clear price for the install before the visit

Prefer a callback?

Leave your number and a Orland Park range hood installer will call you.

Range hood installs we handle in Orland Park

Most kitchen ventilation complaints come from the install, not the hood: a duct that is too small, a long run full of elbows, or a fan that blows grease into the cabinet above. Our Orland Park installers set the hood, the duct and the exterior cap as one system.

1990s hood on an old duct

A 1990s hood swap usually turns up a small, greasy duct and a damper that no longer closes. Those get replaced with the hood.

Flexible foil duct behind the old hood

Crinkled foil duct traps grease in its ridges and slows the air. We replace it with rigid, smooth metal duct with sealed joints.

Island hood over a new island cooktop

An island hood hangs in open air, so it needs a wider canopy, solid ceiling blocking and a duct route through the joists. We plan the route before the ceiling is opened.

High-CFM hood and makeup air

Bigger isn't always better. Above a certain airflow, many codes call for makeup air, so we size the hood to what you actually cook.

Old hood that only recirculates

A hood that blows air back into the room through a charcoal filter catches some grease but leaves heat, moisture and smoke inside. When a duct route exists, we convert it to vent outdoors.

Hood too narrow for the cooktop

When the outer burners sit beyond the edge of the hood, much of what they produce escapes. A wider canopy captures more of the plume.

Custom hood cover that needs an insert

If your cabinetmaker built a decorative hood, the working part is a hood insert. We fit it, duct it outside and wire it to the switch.

No hood over the range at all

If your range sits under bare cabinets, we can install a new hood with a new duct, a new exterior cap and a switched circuit.

Included with the install

  • Site check and sizingWe measure the cooktop, the space above it and the possible duct routes, then size the hood.
  • Permit and approvalsPermits, condo approvals and any makeup-air requirement are confirmed up front.
  • Blocking and mountingMounting points set at the height in the maker's instructions.
  • Duct runA short, direct duct with as few elbows as possible.
  • Wall cap or roof jackExterior wall cap or roof jack with a backdraft damper, flashed and sealed against weather.
  • Electrical connectionPower brought to the hood and connected per the maker's instructions.
  • Test and cleanupEvery fan speed and light tested, the damper checked from outside, the area cleaned up.

Options to choose from

Duct, caps and dampersSmooth metal pipe and a damper-equipped exterior termination.
Ducted vs recirculatingDucted hoods send air outside; recirculating hoods filter it through charcoal and return it to the room.
Inserts and linersFan units built into a custom wood, plaster or metal hood cover.
Under-cabinet hoodsThe most common style, tucked under the upper cabinet above the range.
Wall chimney hoodsA canopy on the wall with a chimney cover hiding the duct up to the ceiling.

Kitchens like yours in Orland Park: before and after

Range Hood Installation in a 1980s-1990s two-story colonial / tract house — beforeBefore
Range Hood Installation in a 1980s-1990s two-story colonial / tract house — installedInstalled
Range Hood Installation in a 1980s-1990s two-story colonial / tract house — detailDetail

Orland Park kitchen, 1990s two-story colonial: range hood installation

This one is a 1990s two-story colonial in Orland Park. What we started with: white appliances and white thermofoil cabinets peeling at the edges, oak trim. What bothered the owners most: cooking smells that stayed in the house for hours. Finished kitchen: a new stainless chimney range hood ducted to the outside. Work included wall cap or roof jack, electrical connection, plus test and cleanup.

Range Hood Installation project in Tinley Park, beforeBefore
Range Hood Installation project in Tinley Park, afterAfter

Tinley Park kitchen, 1990s two-story colonial: range hood installation

A 1990s two-story colonial in Tinley Park, a typical kitchen for Tinley Park. What we started with: black appliances and golden-oak cabinets with oak soffits above. The reason for the call: a recirculating hood that left the kitchen smoky. After: a new stainless chimney range hood ducted to the outside. The job covered site check and sizing, duct run, plus electrical connection.

Range Hood Installation in Tinley Park →
Range Hood Installation project in Woodridge, beforeBefore
Range Hood Installation project in Woodridge, afterAfter

Range Hood Installation in a suburban townhome, Woodridge

A suburban townhome near The Ridge, a typical kitchen for Woodridge. The kitchen as it was: white appliances and oak flat-panel cabinets. The main complaint was a recirculating hood that left the kitchen smoky. After: a new stainless chimney range hood ducted to the outside. Work included permit and approvals, wall cap or roof jack, plus electrical connection.

Range Hood Installation in Woodridge →
Kitchen Remodeling project near Orland Park, beforeBefore
Kitchen Remodeling project near Orland Park, afterAfter

An Orland Park two-story colonial from the 1990s: before and after

Finished: cabinets in white uppers and deep green lowers with polished nickel pulls, dark soapstone-look quartz counters, a white herringbone tile backsplash, warm oak luxury vinyl plank flooring and a flush drum fixture and under-cabinet lights.

Kitchen Remodeling in Orland Park →
Kitchen Cabinet Painting project near Orland Park, beforeBefore
Kitchen Cabinet Painting project near Orland Park, afterAfter

Orland Park kitchen, 1980s two-story: kitchen cabinet painting

What changed: the same doors sprayed in cream uppers and walnut-stained lowers, new satin brass pulls; counters and floor stayed as they were.

Kitchen Cabinet Painting in Orland Park →

From the old unit to the new one

  1. Photos and modelTell us what you cook on and show us the space; a model number helps.
  2. Duct route and sizingOn site we size the hood, pick the duct route and check permits and makeup air.
  3. Written estimateA clear written price with duct and electrical work listed separately.
  4. Install and testHood mounted, ducted and wired, then every speed tested and the damper checked.

Range Hood Installation questions from Orland Park homeowners

Do I need an electrician to install a range hood?
Only if new wiring is needed. Connecting to an existing hood supply is part of our install.
How high should a range hood be above the stove?
Every hood has a mounting height in its installation guide. Too high and it misses smoke; too low and it gets in the way.
Can I install a range hood myself?
A simple swap on the same duct can be DIY. When the job involves a new duct route, a roof jack or a permit, it's worth hiring it out.
Can a range hood vent into the attic?
It shouldn't. Grease and moisture in an attic cause damage; the duct must end outside with a damper.
Ducted or ductless: which should I choose?
Venting outside works better. Ductless is the fallback for condos and spots where no duct can run.
What is the Orland Park building department phone number?
Permits go through Development Services Department - Building Division, phone 708-403-5300. When your scope needs one, we prepare the application and schedule the inspections.
Orland Park contractor registration: do kitchen contractors need it?
Contractors must be licensed with the Village before permits issue; apply via Civic Access portal. We take care of that before work starts.
Which Orland Park office signs off on hood work?
Orland Fire Protection District inspections and permits page (separate from Village). We schedule the inspection and have the paperwork ready.
Do I need historic review for range hood installation in Orland Park?
Orland Park has locally reviewed areas, including Old Orland Historic District. Exterior changes there can need review; interior-only work usually does not. We check before anything changes on the outside.
Do I need a permit for range hood installation in Orland Park?
It depends on the scope. Orland Park's rule in short: Permit needed for remodeling; application lists electrical and plumbing contractors. We handle the permit when one is needed with Development Services Department - Building Division.
Do you work in my part of Orland Park?
Yes. Our crews work across Orland Park — ZIP 60462, 60467 — and nearby Tinley Park, Woodridge, Bolingbrook.

Working in Orland Park

  • A lot of Orland Park kitchens date from the 1990s. We know these layouts well and what is worth keeping.
  • Most Orland Park homes are single-family. We protect floors and driveways and leave the site clean every day.
  • Live in the Old Orland Historic District? Interior kitchen work is usually not reviewed. We check before anything touches the exterior.

ZIP 60462ZIP 60467

Range Hood Installation nearby

Planning a kitchen project in Orland Park?

Call us — we'll check your ZIP, answer your questions and book an in-home estimate.

Call now (708) 400-7049
Call (708) 400-7049Callback