Wood hidden under old vinyl or tile
Older kitchens sometimes hide hardwood under vinyl tile and black adhesive. Some old tiles and mastic contain asbestos, so we have them tested before anything is disturbed.
Serving Hanover Park & nearby Bartlett, Roselle
Hardwood Floor Repair & Refinishing in Hanover Park, IL
Worn, stained and water-marked hardwood in Hanover Park kitchens sanded, repaired board by board and refinished.
- Crews working in Hanover Park ZIP 60133
- Most jobs done in days, with your kitchen still usable
- Samples and a written quote before we start
Hardwood floor problems we repair in Hanover Park
Kitchen hardwood wears faster than the rest of the house: traffic paths go gray at the sink, water marks show up by the dishwasher and chairs scuff the finish. In Hanover Park we replace boards that are beyond saving, sand the floor to fresh wood and apply a new finish built for kitchen use.
Dull finish that is otherwise intact
If the finish is dull but not worn through, a screen-and-recoat — abrading the top coat and adding fresh finish — restores the sheen without sanding to bare wood.
Floor turned yellow or orange
A floor that has gone orange is usually the finish, not the wood. Refinishing lets you choose a lighter, more neutral look.
White water marks in the finish
If the mark is white or milky, moisture is trapped in the coating. That is good news: the wood below is often fine.
Deep scratches and dents
Light surface scratches come out with a screen and recoat. Scratches and dents into the wood need a full sanding, and deep gouges may mean a new board.
Squeaky or loose boards
Noisy boards are usually not tight to the subfloor. We secure them before sanding.
Damaged boards that need replacing
Board replacement follows the floor's pattern. Staggered ends make the new wood hard to find once it is refinished.
Pet stains and scratches
Dark pet spots are tested first; boards that stay stained after sanding are replaced. A harder finish helps with future scratches.
What we do on the job
- Moisture checkWe measure the wood and subfloor moisture before sanding near any past leak.
- Board repair and replacementWe lace in matching boards wherever stains, rot or splits go too deep to sand out.
- SandingThe floor is sanded in progressive grits with a drum or belt sander and an edger along cabinets.
- Stain and color samplesWe put test patches down on the floor for you to compare.
- Finish coatsMultiple finish coats built up with buffing between them for a smooth surface.
- Trim and thresholdsShoe molding, toe-kick trim and thresholds are reset or replaced after the finish cures.
- Appliances back and care adviceWe set everything back and explain cure times and safe cleaners.
Materials and finishes
Wood stainColors from light natural to deep brown, tested on the sanded floor.
Hardwax oil finishesPenetrating oil finishes that are easy to touch up in high-wear spots.
Replacement boardsMatching boards for weaving in repairs, chosen to blend after finishing.
Waterborne polyurethaneA clear finish that doesn't yellow much over time and dries fast between coats.
Oil-modified polyurethaneA warm, amber-toned finish with a longer dry time and a stronger odor while curing.
Before and after: kitchens near Hanover Park
Before
AfterA Hanover Park 1970s tract home: before and after
The site: a 1970s tract home near Ontarioville. The main complaint was dark water stains in front of the dishwasher. After: the oak floor sanded and refinished with a satin clear finish, grain visible and the water marks gone. The job covered sanding, trim and thresholds, plus appliances back and care advice.
Before
AfterBartlett kitchen, 1990s two-story colonial: hardwood floor repair & refinishing
This one is a 1990s two-story colonial in Bartlett. The reason for the call: a worn finish that no longer protected the wood. The result: the oak floor sanded and refinished with a satin clear finish, grain visible and the water marks gone. Work included moisture check, stain and color samples, plus finish coats.
Hardwood Floor Repair & Refinishing in Bartlett →
Before
AfterHardwood Floor Repair & Refinishing in a 1990s two-story colonial, Carol Stream
The site: a 1990s two-story colonial in Carol Stream. What bothered the owners most: a worn finish that no longer protected the wood. After: the oak floor sanded and refinished with a satin clear finish, grain visible and the water marks gone. Work included board repair and replacement, stain and color samples, plus appliances back and care advice.
Hardwood Floor Repair & Refinishing in Carol Stream →
Before
AfterBefore and after: a raised ranch in Hanover Park
Finished: cabinets in white uppers and dusty blue lowers with satin brass pulls, white quartz with soft gray veining counters, a white 2x8 tile in a vertical stack backsplash, hickory luxury vinyl plank flooring and a flush drum fixture and under-cabinet lights.
Kitchen Remodeling in Hanover Park →
Before
AfterKitchen Cabinet Painting in a raised ranch, Hanover Park
Finished: the same doors sprayed in sage green, new matte black pulls; counters and floor stayed as they were.
Kitchen Cabinet Painting in Hanover Park →How your hardwood floor repair and refinishing goes
- Look at the floorAn on-site check of wear, stains and how much wood is left to sand.
- Plan the workWe agree on color, finish and the rooms included before work starts.
- Repair and sandDamaged boards replaced, then the floor sanded and stained; a kitchen refinish often takes a few days.
- Finish and cureFinish coats go on with dry time between them; light use comes first, full use after the cure.
Hardwood Floor Repair & Refinishing questions from Hanover Park homeowners
How many times can hardwood be refinished?
It depends on how much wood is above the tongue. We check that before sanding.
Will a warped wood floor go back to normal?
Give it time after the leak is fixed; many floors flatten partly. We wait for dry readings before sanding.
Is dustless sanding really dust-free?
No sanding is completely dust-free, but systems that vacuum at the sander capture most of it. We also seal off the kitchen with plastic.
Can you match new boards to an old floor?
Usually, yes. Oak strip is common, and salvage boards help with older or wider floors.
What is the difference between refinishing and a screen-and-recoat?
Recoating refreshes a sound finish; refinishing starts the wood over. Recoats are faster with little dust.
Hanover Park contractor registration: do kitchen contractors need it?
All contractors must be registered and bonded with the Village before a building permit is issued; apply via Inspectional Services. We take care of that before work starts.
Do you work in my part of Hanover Park?
Yes. Our crews work across Hanover Park, including Ontarioville — ZIP 60133 — and nearby Bartlett, Roselle, Bloomingdale.
Working in Hanover Park
- A lot of Hanover Park kitchens date from the 1970s. We know these layouts well and what is worth keeping.
- Most Hanover Park homes are single-family. We protect floors and driveways and leave the site clean every day.
- Live in a historic district? Interior kitchen work is usually not reviewed. We check before anything touches the exterior.
Ontarioville
ZIP 60133
Hardwood Floor Repair & Refinishing nearby
Other kitchen services in Hanover Park
Kitchen Subfloor RepairSoft spots, rot and squeaks fixed at the structure under the floor.
Kitchen RemodelingFull kitchen remodels, from layout to last cabinet pull.
Kitchen Cabinet PaintingFactory-smooth painted cabinets without replacing them.
Cabinet RefacingNew doors and fronts on your existing cabinet boxes.
Countertop Fabrication & InstallationQuartz, granite and butcher block, templated and installed.