Serving Glen Ellyn & nearby Wheaton, Lombard

Range Hood Repair in Glen Ellyn, IL

Fan dead, lights out or a hood that rattles and roars? We repair range hoods in Glen Ellyn and tell you plainly when replacing makes more sense.

  • Technicians covering Glen Ellyn ZIP 60137
  • Diagnosis first, then a written price for the repair
  • Honest advice when replacing makes more sense

Prefer a callback?

Leave your number and a Glen Ellyn range hood technician will call you.

Range hood problems we fix in Glen Ellyn

Before you buy a new hood, it is worth knowing what actually broke. We look at the motor, the controls, the wiring and the duct behind the hood in Glen Ellyn kitchens, then give you a straight answer on repair versus replacement.

Burning smell when the fan runs

If the hood smells hot, stop using it. We check the motor, the wiring connections and how much grease has built up around them.

Fan not working but the light is

Working lights mean the hood has power. A dead fan then points to the switch, the control board, a thermal cutoff or a failed motor.

Fan won't turn off

Some hoods have a heat sensor that starts the fan automatically when the cooktop is hot; if it runs with everything cold, the control is at fault.

Hood that hums but won't spin

A hum with no movement often means a seized motor, a failed start capacitor or a wheel jammed with grease. We free or replace the part.

Fan stuck on one speed

Losing speeds points to the speed control rather than the motor in most cases. We test the switch and the board.

Buttons or touch panel not responding

When some buttons work and others don't, the keypad membrane is often worn. A full lockup is more often the control board.

Loud rattling or grinding

A new rattle is often something simple: a filter not latched, a loose screw, a wheel slipping on its shaft. A grinding noise is more often the motor.

Fan runs but barely pulls air

Poor airflow usually has a blockage behind it: grease, a stuck damper or a crushed duct. We find it and clear or replace the part.

What we check and fix

  • Fan motor replacementA new motor fitted, wired and balanced on its mount.
  • Blower wheel serviceGrease-packed or loose blower wheels cleaned, tightened or replaced.
  • Lights and socketsWorking lights restored with the correct bulb type or LED part.
  • Damper and duct checkBackdraft dampers freed or replaced, the duct and exterior cap checked for blockage.
  • Filter replacementBent mesh or baffle filters and spent charcoal filters replaced with matching ones.
  • Noise and vibration fixesLoose mounts, filters, wheels and duct connections tightened to stop rattles.
  • Final testWe run the hood and check airflow before we leave.

Common fixes and parts

Fan motors and blower wheelsThe parts that move air, and the ones most often worn out.
Under-cabinet and chimney hoodsWall and under-cabinet hoods serviced in place without removing cabinets.
Island hoods and insertsInserts inside custom covers, serviced through the filter opening.
LightsIncandescent, halogen and LED lamps, sockets and modules.
Switches, keypads and boardsControls range from basic switches to electronic boards with timers.

What the work looks like in Glen Ellyn homes

Range Hood Repair in a 1980s-1990s two-story colonial / tract house — problemProblem
Range Hood Repair in a 1980s-1990s two-story colonial / tract house — fixedFixed
Range Hood Repair in a 1980s-1990s two-story colonial / tract house — detailDetail

Before and after: a 1990s two-story colonial in Glen Ellyn

This one is a 1990s two-story colonial in Glen Ellyn. What we started with: black appliances and two hanging glass pendants. The reason for the call: a range hood with dead lights and a weak fan. Finished kitchen: the same hood with a new fan motor and working LED lights. Work included damper and duct check, filter replacement, plus final test.

Range Hood Repair project in Wheaton, beforeBefore
Range Hood Repair project in Wheaton, afterAfter

Before and after: a two-story colonial from the 1990s in Wheaton

The site: a two-story colonial from the 1990s near Wheaton Center. What we started with: almond appliances and a fluorescent box light in the ceiling. The main complaint was a hood that rattled every time it ran. The result: the same hood with a new fan motor and working LED lights. On site this meant lights and sockets, damper and duct check, plus final test.

Range Hood Repair in Wheaton →
Range Hood Repair project in Glendale Heights, beforeBefore
Range Hood Repair project in Glendale Heights, afterAfter

A Glendale Heights 1990s two-story colonial: before and after

This one is a 1990s two-story colonial in Glendale Heights. Before: white appliances and a brass chandelier over the nook. The reason for the call: a hood fan that stopped working. Finished kitchen: the same hood with a new fan motor and working LED lights. The job covered blower wheel service, damper and duct check, plus final test.

Range Hood Repair in Glendale Heights →
Residential Kitchen Hood Cleaning project near Glen Ellyn, beforeBefore
Residential Kitchen Hood Cleaning project near Glen Ellyn, afterAfter

Before and after: a 1980s two-story in Glen Ellyn

Finished: the same hood with clean, shining filters.

Residential Kitchen Hood Cleaning in Glen Ellyn →
Kitchen Remodeling project near Glen Ellyn, beforeBefore
Kitchen Remodeling project near Glen Ellyn, afterAfter

A Glen Ellyn 1960s ranch: before and after

Finished: cabinets in light butter yellow with polished nickel pulls, black honed granite counters, a gray beveled subway tile backsplash, light oak hardwood flooring and two glass pendants and recessed lights.

Kitchen Remodeling in Glen Ellyn →

From diagnosis to fixed

  1. Describe the problemA photo of the label behind the filter and a short description help us bring the likely parts.
  2. Diagnosis on siteA technician checks the power, controls, motor and damper.
  3. Repair or replaceWe explain what failed and whether the fix is worth it on your hood.
  4. Fix and testThe part is replaced and the hood tested on every speed and light.

Range Hood Repair questions from Glen Ellyn homeowners

Why do I feel cold air coming from my hood?
It's almost always the damper. Cleaning or replacing it usually stops the draft.
What bulb does my range hood need?
Check the old bulb or the label for the base and wattage. Using the wrong bulb can overheat the socket.
When should I replace a range hood instead of repairing it?
If the repair costs close to a new hood, or the old one never vented well, replacement is the better spend.
Why does my range hood have weak suction?
Clogged filters, a grease-coated blower wheel, a stuck damper or a crushed duct are the usual causes.
Why won't my range hood fan turn off?
A stuck switch or failed relay on the control board is the usual cause. Some hoods also start the fan automatically when they sense heat.
Do you work in my part of Glen Ellyn?
Yes. Our crews work across Glen Ellyn — ZIP 60137 — and nearby Wheaton, Lombard, Glendale Heights.

Working in Glen Ellyn

  • A lot of Glen Ellyn kitchens date from the 1970s. We know these layouts well and what is worth keeping.
  • Most Glen Ellyn homes are single-family. We protect floors and driveways and leave the site clean every day.
  • Older paint is treated with lead-safe practices: containment, HEPA cleanup and a clean hand-over.

ZIP 60137

Range Hood Repair nearby

Planning a kitchen project in Glen Ellyn?

Call us — we'll check your ZIP, answer your questions and book an in-home estimate.

Call now (708) 400-7049
Call (708) 400-7049Callback