Runs but doesn't heat
Everything runs except the heat: it's one of the most searched microwave problems, and it's usually a single part in the high-voltage section.
Serving Aurora & nearby Batavia, Warrenville
Microwave Repair in Aurora, IL
Microwave runs but won't heat, sparks or has a dead display? We repair over-the-range and built-in microwaves in Aurora.
- Repairs across Aurora ZIP 60506, 60502, 60505, 60504, 60503
- We find the cause, not just the symptom
- Parts and labor quoted before work starts
Microwave problems we fix in Aurora
We repair microwaves that won't heat, won't start, spark inside, have dead keypads or a broken door. For Aurora homes with a countertop model, we'll usually tell you a new one is the better buy; for an over-the-range or built-in unit, a repair is often worth it.
Broken door handle or latch
If the door won't stay shut or the handle snapped, we replace the handle, latch hooks or door assembly so the switches engage.
Loud humming, buzzing or grinding
Buzzing louder than usual is a sign to stop using it until it's checked. We test safely and replace what's failing.
Won't start or turns off mid-cycle
A microwave that won't start, or quits halfway, often has a faulty door switch, a blown fuse or a thermal cutout tripping.
Built-in or drawer microwave failure
Built-in and drawer microwaves are fitted into cabinets with trim kits, so repairing them in place often makes more sense than replacing them.
Light or vent fan out on an over-the-range unit
The cooktop light and exhaust fan on an over-the-range microwave are separate parts from the oven itself. Bulbs, fan motors and switches can all be replaced.
Burning smell or smoke
Burning odors from inside the case point to an electrical fault. We find the cause before it causes more damage.
Display dead or keypad not responding
Dead keypads and blank displays are common on older units. Whether it's worth fixing depends on parts availability, and we check that first.
What the repair visit covers
- Symptom and safety checkWe confirm the outlet, the breaker and how the door closes before opening anything.
- Unit taken down if neededBuilt-in units are pulled from their trim kit only when necessary.
- High-voltage dischargeThe capacitor is safely discharged before any internal testing.
- Component testsMagnetron, diode, capacitor, transformer, fuses and door switches tested.
- Cavity and waveguide inspectionWe look for burn marks and grease that cause sparking.
- Written quoteYou see the cost and our honest view before work starts.
- Remount and testWe heat a cup of water and test the vent and light before leaving.
Common fixes and parts
Microwave drawersDrawer-style microwaves in islands and lower cabinets.
High-voltage partsMagnetrons, diodes, capacitors, transformers and fuses.
Vent fan, light and filter partsExhaust fan motors, cooktop light sockets, grease filters and charcoal filters for over-the-range models.
Over-the-range microwavesMicrowaves mounted above the cooktop with a vent fan and light.
Door, keypad and turntable partsHandles, latches, door switches, keypads, turntable motors and waveguide covers.
Before and after: kitchens near Aurora
Problem
Fixed
DetailAn Aurora 1990s two-story colonial: before and after
A 1990s two-story colonial near Palace Street, a typical kitchen for Aurora. What we started with: almond appliances. The reason for the call: an old microwave that had stopped heating. After: the over-the-range microwave with a new door handle and a lit display, heating again. The job covered unit taken down if needed, written quote, plus remount and test.
Before
AfterBefore and after: a 1980s two-story in Batavia
The site: a 1980s two-story in Batavia. Before: black appliances. What bothered the owners most: a microwave with a dark display. After: the over-the-range microwave with a new door handle and a lit display, heating again. Work included unit taken down if needed, high-voltage discharge, plus cavity and waveguide inspection.
Microwave Repair in Batavia →
Before
AfterKitchen Remodeling in a 1980s two-story, Aurora
Cabinets in white uppers and deep green lowers with unlacquered brass knobs and cup pulls, warm walnut butcher block counters, a green zellige-look tile backsplash, warm oak luxury vinyl plank flooring and recessed lights and under-cabinet LED strips.
Kitchen Remodeling in Aurora →
Before
AfterKitchen Cabinet Painting in a two-story colonial from the 1990s, Aurora
Finished: the same doors sprayed in creamy white uppers and navy lowers, new matte black pulls; counters and floor stayed as they were.
Kitchen Cabinet Painting in Aurora →The repair visit
- Tell us the type and symptomOver-the-range, built-in or countertop, the model number and what it's doing.
- Repair or replace adviceFor countertop units we'll often tell you up front that replacing makes more sense.
- Diagnosis and written quoteWe find the cause and put the cost in writing.
- Repair and testThe part goes in, the unit is remounted and tested with heat, fan and light.
Microwave Repair questions from Aurora homeowners
What usually breaks in a microwave?
Most repairs involve the door switches, the heating circuit, the keypad or the turntable.
How much does microwave repair cost?
The part, labor and whether the unit has to come down set the price. We put it in writing first.
Why is my microwave running but not heating?
Usually a failed high-voltage diode, magnetron, capacitor or a door switch. These are inside the high-voltage section and need a technician.
Can I fix my microwave myself?
Swapping a bulb or filter is fine. Anything inside the case is a job for a technician who knows how to discharge the capacitor.
Can I replace my over-the-range microwave with a range hood?
It's a common change when an over-the-range unit dies. We can tell you on the visit whether a repair or a switch to a hood makes more sense for your kitchen.
Do I need a permit for microwave repair in Aurora?
It depends on the scope. Aurora's rule in short: Interior remodels, structural changes and interior plumbing always need a permit; electrical/mechanical may. We handle the permit when one is needed with Division of Building and Permits, City of Aurora.
Do you work in my part of Aurora?
Yes. Our crews work across Aurora, including Near Eastside, Tanner, Riddle Highlands, Palace Street — ZIP 60506, 60502, 60505, 60504, 60503 — and nearby Batavia, Warrenville, Naperville.
Working in Aurora
- A lot of Aurora kitchens date from the 1990s. We know these layouts well and what is worth keeping.
- Most Aurora homes are single-family. We protect floors and driveways and leave the site clean every day.
- Live in a historic district? Interior kitchen work is usually not reviewed. We check before anything touches the exterior.
Near EastsideTannerRiddle HighlandsPalace StreetWest SideFar East Side
ZIP 60506ZIP 60502ZIP 60505ZIP 60504ZIP 60503
Microwave Repair nearby
Other kitchen services in Aurora
Refrigerator & Ice Maker RepairNot cooling, frost, leaks and dead ice makers diagnosed and fixed.
Dishwasher RepairDraining, cleaning, leaking and door problems found and fixed.
Oven, Stove & Cooktop RepairGas and electric ovens, ranges and cooktops diagnosed and repaired.
Kitchen RemodelingFull kitchen remodels, from layout to last cabinet pull.
Kitchen Cabinet PaintingFactory-smooth painted cabinets without replacing them.